Instruction/ maintenance manual of the product TDL14 Hotpoint
Go to page of 20
USER HANDBOOK MODELS TDL14 TDL15 Y ou must read these instructions prior to using the appliance and retain them f or future ref erence..
Contents P age F or your saf ety 3-4 Electrical Requirements 5 F eatures - Get to know the main par ts of your Dryer 6 Where to put and v ent your Dryer 7-8 How to use y our Dr yer 9 Sor ting your lau.
3 For y our saf ety NEVER ● Allow children to play with or otherwise interfere with the dryer. NEVER ● Allow the air inlet at the back of the dryer, the air outlet or vent hose to be obstructed. NEVER ● Direct the vent hose outlet towards the air intake at the back of the machine.
4 For y our saf ety ALWAYS ● When the dryer is not in use, switch off at the wall, remove plug and close the door. ALWAYS ● Comply with the specified electrical requirements. ALWAYS ● Ensure that your dryer is installed correctly and has adequate ventilation.
5 Electrical Requirements Supply Changing the fuse Moulded plug Changing the plug Rewirable plug Changing the mains cable WARNING: This appliance must be earthed! REFER TO THE RATING PLATE FOR VOLTAGE AND CURRENT REQUIREMENTS. (see diagram for location.
6 Features - Get to kno w the main par ts of y our dryer Model and serial numbers NOTE: if your dryer is new wipe out the inside of the drum before you first use it to remove any dust which may have accumulated during transit.
7 Where to put and vent y our dryer Your Tumble Dryer should NOT be located adjacent to a gas hob cooker, heater, or eye level grill as flames from the burners could cause damage to your machine. When the dryer is fitted under a work surface allow space for air to enter the rear grille, 10mm above the dryer minimum.
8 Where to put and vent y our dryer In conjunction with the vent hose we recommend the use of a Wall/Window Vent Kit. These are available from your retailer or nearest Spares Centre. Fitting instructions are supplied with the kits, which can be mounted through a wall or window.
9 Ho w to use y our dr yer 1. Plug in, switch on electricity. 2. Sort your laundry (see section “Sorting Your Laundry”) 3. Open the door. Check that the fluff filter is clean (see section “How to remove and clean the fluff filter”).
10 Sor ting y our laundry 1. Always separate laundry into the correct fabric groups before washing and drying. 2. See that all zips are closed, hooks and eyes are fastened and belt, strings etc. are tied loosely in bows, you will normally have done this for each item before the washing stage.
11 W ash Care Labels Most of today’s fabrics can be tumble dried in your Dryer with no trouble at all, but there are certain fabric finishes which should be dried away from direct heat. The majority of garments now have wash-care labels on them, giving full washing and drying instructions.
12 Items requiring special attention The drying requirements of blankets and bedspreads will, of course, vary tremendously according to size and weight. Some, however are simply too big. if you have difficulty getting them into the Dryer, the machine will have difficulty drying them properly.
13 Ho w to remo ve and c lean the fluff filter Position of filter To remove the filter A very important part of your dryer is the fluff filter at the front edge of the drum. It’s there to trap the particles of lint and fluff which are normally blown away when clothes are dried on the washing-line.
14 TDL14 TDL15 Heat Selection The ‘Cool Tumble’ phase The Contr ols - TDL14 and TDL15 Heat Switch (OUT low heat, IN high heat) Timer Knob Turn the timer clockwise to select the required drying time. The timer controls the drying time for both heat settings.
Please note that the Drying Times stated below and on appliance control panel are a GUIDE only and drying times are affected by : Items such as towelling retain a lot of water after spinning, also the suggested wash programme for small items such as T-Shirts may sometimes incorporate a low spin speed which has the same effect.
16 When finished After each load As necessary Lubrication Caring f or y our Dr y er Your tumble dryer needs very little attention. The following simple steps will keep it performing well. Switch off electricity and remove plug. Always clean the filter and turn the drum by hand to check that small items like handkerchiefs do not get missed.
17 If something goes wr ong First, don’t panic! There may be nothing wrong at all. Look for your problem below, then check the things we suggest. More often tha n not, this will give you the answer to your problem, and you’ll be able to carry on without having to telephone your Service Office.
18 If it still w on’t w ork... Spare par ts Disposal of y our pr oduct if something is still wrong with your machine after you’ve been through the check-list on the previous page: 1. Switch off and unplug your machine from the mains. 2. Call your nearest Service Office or local importer (outside the UK).
.
General Domestic Appliances Ltd, Peterborough, PE2 9JB. PRINTED BY SIMLEX FOUR ASHES, WOLVERHAMPTON. April 2003 Part No. 0766200138-01 K e y Contacts Service Hotpoint has the largest appliance manufacturer’s service team in Europe, trained specialists directly employed by us to ensure your complete confidence.
An important point after buying a device Hotpoint TDL14 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hotpoint TDL14 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hotpoint TDL14 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hotpoint TDL14 you will learn all the available features of the product, as well as information on its operation. The information that you get Hotpoint TDL14 will certainly help you make a decision on the purchase.
If you already are a holder of Hotpoint TDL14, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hotpoint TDL14.
However, one of the most important roles played by the user manual is to help in solving problems with Hotpoint TDL14. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hotpoint TDL14 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
