Instruction/ maintenance manual of the product CSX24X Hotpoint
Go to page of 24
Contenk Appliance Registration 2 Solid State Monitor 6-9 Base Grille 4 Door Alarm 7 Care and Cleaning 17 Status Check—Reset 7 Condenser 17 Warm Temperature 7 Diagnostic Codes 8,9 Storage Drawers 15,.
Help us help you... Read this book carefully. It is intended to help you operate and maintain your new refrigerator properly. Keep it handy for answers to your questions.
~PORTANT S~ETY~STRUC~ONS Read all i~rudions before@ this appliance. W~N~When usin~ this appliance, always exercise ba;ic safety precautions, including the following: ● Use this appliance oniy for its intended purpose as describd in this Use and Care Book, .
Installation Requirement (continued)–IMPORTANT,.. PleaSe Read Carefully. Use of Adapter Plug (U5-volt units) Because of potential safety hazards under certain conditions, we strongly recommend against use of an adapter plug.
Opemting Your Refrigemtor Set the Temperature Controk I TEMPERATURE CONTROLS I Your refrigerator has two controls that let you regulate the temperature in the fresh food and freezer compartments. INITIALLY, set the FRESH FOOD control at 5 and the FREEZER control at C.
Solid State Monitor System It keeps an eye on things for you. @Red signal light flashes to tell you when either door is open. @Green signal light tells you[hat the Door Alarm beeper has been set to sound after either door has been open 30 seconds. @Red signal light tells you when freezer foodkeeping temperature is above normal.
How to Set the Door Alarm You don’t have to set the visual alarm. As long as either door is open. the red DOOR OPEN signal light flashes. If the green signal light on the DOOR ALARM pad is glowing, the beeper alarm is set. If it’s not, touch the pad to turn it on.
Solid Sbte Monitor System (continued) The Solid State Monitor System alerts you when something starts to go wrong. If a diagnostic code appears on the display, something needs special attention. To get your attention, the display code flashes until you erase it.
Signal Lights and Diagnostic Codes What they mean, and what to do when they alert you, is summarized on this panel on the inside of the freezer compartment door.
Ice & Chilled Water Dispemer Automatic Icemaker and Ice & Water Dispenser Your refrigerator has an automatic icemaker and a dispenser that dispenses chilled water and ice cubes through the freezer compartment door.
Once Your Icemaker and Dispenser Are in Operation Throw away the first few batches of ice cubes (16 or 24 cubes). This will flush away any impurities in the water line. Do the same thing after vacations or extended periods when ice isn’t used. Discard the first six glassfuls of water in the kitchen sink.
Ice & Chilled Water Dispemer (continued) If Ice Clumps Form in Storage Bin... The Icemaker ejects cubes in groups of eight, and it is normal for several cubes to be joined together. However, if you don’t use the ice very often, ice clumps may form in the storage bin and can clog the dispenser.
Food Storage Su~estions Su~ested storage times for meat and poultry* Eating quality drops after time shown Fresh Meats Roasts (Beef & Lamb) Roasts (Pork & Veal) Steaks (Beef) Chops (Lamb) Chops (Pork) Ground & Stew Meats Variety Meats Sausage (Pork) Processed Meats Bacon Frankfurters.
Shelves Shelves in the fresh food and freezer compartments are adjustable, enabling you to make efficient shelf arrangements to fit your fdmily ’s food storage needs. Adjwtible Shelves in Fresh Food Compartment To remove shelves: Tilt shelf up at front, then lift it up and out of.
Storage Drawers Convertible Meat Keeper The Convertible Meat Pan drawer has its own cold air duct to allow a stream of cold air from the freezer compafiment to flow around the drawer. The variable temperature control regulates the air tlow from the freezer compartment.
To Remove Dmwers 1. Remove food from the shelf above the Sealed & Fresh drawer and take out the shelf. Take food off the glass cover and out of the drawer. 2. Put your fingers behind the gasket at the rear of the drawer and pull forward. Remove the gasket.
Care and Cleaning Cleaning—Outside Solid state monitor system panels. Clean the panels on the outside and inside of the freezer compartment door with a soft, clean cloth lightly dampened with water. Do not use cleaning sprays or large amounts of water—the liquid can run down and damage the control mechanisms.
Care and Cleaning (continued) Light bulb replacement In Fresh Food Compartment 1. Unplug refrigerator. 2. To align the control knob properly, note position of numbered control for proper reassembly and pull off knob. 3. Pull bottom of light panel down about l/4’’—just enough to disengage lip at rear from grooves in retainers on rear wall.
- m Questiom? ~ Use This Problem Solver - Rapid Electrical Diagnosis Y(]ur refrigerator is wired for accurate electrical diagnosis in your home—takes only minutes for a service technician to check itsentireelectrical system. No need for the technician to unplug, move or unload the refrigerator to make the diagnosis.
The Problem Solver (continued, PROBLEM OPERATING SOUNDS FRESH FOOD OR FREEZER COMPARTMENT TEMPERATURE TOO WARM FOODS DRY OUT FROST OR lCE CRYSTALS ON FROZEN FOOD SLOW ICE CUBE FREEZING ICE CUBES HAVE .
PROBLEM POSSIBLE CAUSE AND REMEDY CUBE DISPENSER . No ice cubes. Remove storage container. If cubes are frozen to wire arm, remove DOES NOT WORK cubes. . No ice cubes. Icemaker turned off or water supply turned off. ● Irregular ice clumps in storage container.
Noks 22.
If You Need Service To obtain service, see your warranty on the back page of this book. We’re proud of our service and want you to be pleased. If for some reason you are not happy with the service you receive, here are three steps to follow for further help.
YOUR H~POINT REFRIGERATOR WARRAN~ Save proof of original purchase date such as your sales slip or cancelled check to establish warranty period. WHAT IS COVERED FULL ONE-YEAR WARRANTY For one year from.
An important point after buying a device Hotpoint CSX24X (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hotpoint CSX24X yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hotpoint CSX24X - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hotpoint CSX24X you will learn all the available features of the product, as well as information on its operation. The information that you get Hotpoint CSX24X will certainly help you make a decision on the purchase.
If you already are a holder of Hotpoint CSX24X, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hotpoint CSX24X.
However, one of the most important roles played by the user manual is to help in solving problems with Hotpoint CSX24X. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hotpoint CSX24X along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
