Instruction/ maintenance manual of the product F-330BAH(-C) Hoshizaki
Go to page of 17
® Hoshizaki “A Superior Degree of Reliability” www .hoshizaki.com Model F-330BAH(-C) Self-Contained Flaker Hoshizaki America, Inc. Issued: 5-4-2007 Revised: 9-5-2007 I N S T R U C T I O N M A N U.
IMPORTANT Only qualied service technicians should attempt to install, service, or maintain this icemaker. No installation, service, or maintenance should be undertaken until the technician has thoroughly read this Instruction Manual.
3 CONTENTS I. Specications ..................................................................................................................... 4 A. Nameplate Rating .................................................................................
4 I. Specications A. Nameplate Rating 1. F-330BAH, F-330BAH-C See the nameplate for electrical and refrigeration specications. This nameplate is located on the rear panel. We reserve the right to make changes in specications and design without prior notice.
5 B. Dimensions/Connections 1. F-330BAH, F-330BAH-C Unit = inches (mm).
6 II. Installation and Operating Instructions A. Checks Before Installation IMPORTANT 1. Install in accordance with all applicable national, state, and local regulations. . Remove shipping carton, tape, and packing. If any are left in the icemaker, it will not work properly.
7 C. Location CAUTION This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within +45°F to +100°F (+7°C to +38°C); Normal operating water temperature should be within +45°F to +90°F (+7°C to +3°C).
8 • Drain line should not be piped directly to the sewer system. An air gap of a minimum of vertical inches (5 cm) should be between the end of the drain pipe from the unit and the oor drain. • This icemaker must be installed in accordance with applicable national, state, and local regulations.
9 G. Final Checklist 1) Is the icemaker level? ) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (+7°C to +38°C) and the water temperature within +45°F to +90.
10 H. Startup CAUTION 1. All parts are factory-adjusted. Improper adjustments may result in failure. . If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the compressor. 1) Clean the storage bin.
11 III. Cleaning and Maintenance A. Cleaning and Sanitizing Instructions IMPORTANT Ensure all components, fasteners, and thumbscrews are securely in place after any maintenance or cleaning is done to the equipment. WARNING 1. HOSHIZAKI recommends cleaning this unit at least twice a year.
1 6) Lift up the top insulation and unsnap the bin control assembly. Lift the assembly up through the insulation and set it aside. See Fig. 4. 7) Remove the top insulation. 8) Remove the thumbscrews attaching spout (B) to the bin, then remove spout (B).
13 19) When the gear motor starts, remove the front panel and move the ush switch to the "FLUSH" position to drain out the water from the icemaker. 0) After the water has drained, move the power switch to the "OFF" position and unplug the unit.
14 4) Remove the top panel. 5) Remove the bin control assembly from the top insulation and set it aside. Remove the top insulation. 6) Remove the thumbscrews attaching spout (B) to the bin, then remove spout (B).
15 B. Maintenance IMPORTANT 1. This icemaker must be maintained individually, referring to the instruction manual and labels provided with the icemaker.
16 C. Preparing the Icemaker for Long Storage CAUTION When the icemaker is not used for two or three days under normal conditions, it is sufcient to only move the power switch to the "OFF" position.
17 HOSHIZAKI AMERICA, INC. 618 Hwy . 74 S., Peachtree City , GA 30269 USA TEL (770) 487-2331 F AX (770) 487-3360 www .hoshizaki.com 91A2SA10B.
An important point after buying a device Hoshizaki F-330BAH(-C) (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hoshizaki F-330BAH(-C) yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hoshizaki F-330BAH(-C) - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hoshizaki F-330BAH(-C) you will learn all the available features of the product, as well as information on its operation. The information that you get Hoshizaki F-330BAH(-C) will certainly help you make a decision on the purchase.
If you already are a holder of Hoshizaki F-330BAH(-C), but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hoshizaki F-330BAH(-C).
However, one of the most important roles played by the user manual is to help in solving problems with Hoshizaki F-330BAH(-C). Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hoshizaki F-330BAH(-C) along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
