Instruction/ maintenance manual of the product DMC-750BWF Hoshizaki
Go to page of 34
INSTRUCTION MANUAL ISSUED: APRIL 13, 1998 CUBELET ICE DISPENSER R eliability is a beautiful thing TM REVISED: NOV . 18, 2003 DCM-500BAF DCM-500BWF DCM-750BAF DCM-750BWF.
2 HOSHIZAKI provides this manual primarily to assist qualified service technicians in the installation, maintenance and service of the ice dispenser. Should the reader have any questions or concerns which have not been satisfactorily addressed, please call or write to the HOSHIZAKI Technical Support Department for assistance.
3 • Please review this manual. It should be read carefully before the ice dispenser is in- stalled and operated. Only qualified service technicians should install, service and main- tain the ice dispenser. This manual should be made available to the technician prior to installation, service or maintenance.
4 MODEL NUMBER MODEL NUMBER MODEL NUMBER MODEL NUMBER MODEL NUMBER SERIAL NUMBER SERIAL NUMBER SERIAL NUMBER SERIAL NUMBER SERIAL NUMBER AC SUPPLY VOLTAGE AC SUPPLY VOLTAGE AC SUPPLY VOLTAGE AC SUPPLY.
5 We reserve the right to make changes in specifications and design without prior notice. MODEL NUMBER MODEL NUMBER MODEL NUMBER MODEL NUMBER MODEL NUMBER SERIAL NUMBER SERIAL NUMBER SERIAL NUMBER SER.
6 MODEL NUMBER MODEL NUMBER MODEL NUMBER MODEL NUMBER MODEL NUMBER SERIAL NUMBER SERIAL NUMBER SERIAL NUMBER SERIAL NUMBER SERIAL NUMBER AC SUPPLY VOLTAGE AC SUPPLY VOLTAGE AC SUPPLY VOLTAGE AC SUPPLY.
7 See the Nameplate for electrical and refrigeration specifications. This Nameplate is located on the upper part of the Left Side Panel. [d] DCM-750BWF (Water-cooled) [d] DCM-750BWF (Water-cooled) [d].
8 Unit: inch (mm.) 2. DIMENSIONS/CONNECTIONS 2. DIMENSIONS/CONNECTIONS 2. DIMENSIONS/CONNECTIONS 2. DIMENSIONS/CONNECTIONS 2. DIMENSIONS/CONNECTIONS [a] DCM-500BAF [a] DCM-500BAF [a] DCM-500BAF [a] DC.
9 Unit: inch (mm.) [b] DCM-500BWF [b] DCM-500BWF [b] DCM-500BWF [b] DCM-500BWF [b] DCM-500BWF.
10 Unit: inch (mm.) [c] DCM-750BAF [c] DCM-750BAF [c] DCM-750BAF [c] DCM-750BAF [c] DCM-750BAF.
11 Unit: inch (mm.) [d] DCM-750BWF [d] DCM-750BWF [d] DCM-750BWF [d] DCM-750BWF [d] DCM-750BWF.
12 II. GENERAL INFORMATION II. GENERAL INFORMATION II. GENERAL INFORMATION II. GENERAL INFORMATION II. GENERAL INFORMATION 1. CONSTRUCTION 1. CONSTRUCTION 1.
13 2. OPERATION - How it works 2. OPERATION - How it works 2. OPERATION - How it works 2. OPERATION - How it works 2. OPERATION - How it works Water flows from a potable water source through the Water Supply Line Shut-off Valve, enters at the water inlet fitting and on to the Water Supply Assembly.
14 III. INSTALLATION AND OPERATING INSTRUCTIONS III. INSTALLATION AND OPERATING INSTRUCTIONS III. INSTALLATION AND OPERATING INSTRUCTIONS III. INSTALLATION AND OPERATING INSTRUCTIONS III. INSTALLATION AND OPERATING INSTRUCTIONS 1. CHECKS BEFORE INSTALLATION 1.
15 3. LOCATION 3. LOCATION 3. LOCATION 3. LOCATION 3. LOCATION WARNING WARNING WARNING WARNING WARNING This ice dispenser is not intended for outdoor use. Normal operating ambient temperature should be within +45°F to +100°F; normal operating water temperature should be within +45°C to +90°C.
16 Fig. 3 Fig. 3 Fig. 3 Fig. 3 Fig. 3 5. CABINET STAND 5. CABINET STAND 5. CABINET STAND 5. CABINET STAND 5. CABINET STAND When placing the ice dispenser on the Cabinet Stand: 1) Attach four adjustable legs to the Cabinet Stand. (Cabinet Stand accessory) 2) Remove the protective plastic film from the panels.
17 Fig. 4 Fig. 4 Fig. 4 Fig. 4 Fig. 4 DIMENSIONS WITH DCM-500BAF ON SD-450 Unit: inch (mm.).
18 DIMENSIONS WITH DCM-750BAF ON SD-700 Unit: inch (mm.) Fig. 5 Fig. 5 Fig. 5 Fig. 5 Fig. 5.
19 Fig. 6 Fig. 6 Fig. 6 Fig. 6 Fig. 6 6. ELECTRICAL CONNECTION - See Fig. 6 6. ELECTRICAL CONNECTION - See Fig. 6 6. ELECTRICAL CONNECTION - See Fig. 6 6.
20 7. WATER SUPPLY AND DRAIN CONNECTIONS - See Fig. 7 and 8 7. WATER SUPPLY AND DRAIN CONNECTIONS - See Fig. 7 and 8 7. WATER SUPPLY AND DRAIN CONNECTIONS - See Fig. 7 and 8 7. WATER SUPPLY AND DRAIN CONNECTIONS - See Fig. 7 and 8 7. WATER SUPPLY AND DRAIN CONNECTIONS - See Fig.
21 Fig. 7 Fig. 7 Fig. 7 Fig. 7 Fig. 7 Air Cooled Model Fig. 8 Fig. 8 Fig. 8 Fig. 8 Fig. 8 Water Cooled Model.
22 8. FINAL CHECK LIST 8. FINAL CHECK LIST 8. FINAL CHECK LIST 8. FINAL CHECK LIST 8. FINAL CHECK LIST 1) Is the ice dispenser level? 2) Is the ice dispenser in a site where the ambient temperature is.
23 9. START UP - See Fig. 9 9. START UP - See Fig. 9 9. START UP - See Fig. 9 9. START UP - See Fig. 9 9. START UP - See Fig. 9 WARNING WARNING WARNING WARNING WARNING 1.
24 11) Check if there is any abnormal noise from the Compressor, Fan Motor or Gear Motor(s) after 30 minutes of running. 12) Move the Dispense Mode Switch, located at the bottom of the Middle Front Panel, to the “PORTION” or “CONTINUOUS” position.
25 Note: When shipped, the Portion Control is set at the minimum dispensing time (0.6 sec.) Model DCM-500BAF, BWF . . . . . . . . . . . . about 0.72 oz.
26 11. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig. 11 11. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig. 11 11. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig. 11 11. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig. 11 11. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig.
27 IMPORTANT IMPORTANT IMPORTANT IMPORTANT IMPORTANT Before operating the dispenser next time, check that the Water Supply Line Drain Valve is closed, and open the Water Supply Line Shut-off Valve.
28 V. CLEANING AND MAINTENANCE INSTRUCTIONS V. CLEANING AND MAINTENANCE INSTRUCTIONS V. CLEANING AND MAINTENANCE INSTRUCTIONS V. CLEANING AND MAINTENANCE INSTRUCTIONS V.
29 8) Wait for 10 minutes before starting the icemaking process. Then turn on the Power Switch and move the Control Switch to the “ICE” position. Run the ice dispenser until it stops automatically. Note: This ice dispenser will not run without the Front Panel.
30 [b] STORAGE BIN - Following Cleaning Procedures for Water System [b] STORAGE BIN - Following Cleaning Procedures for Water System [b] STORAGE BIN - Following Cleaning Procedures for Water System [b.
31 7) Immerse the parts removed in the above steps 2) through 6) in the cleaning and sanitizing solution for about 15 minutes each. 8) Rinse these parts thoroughly with clean water. 9) Wipe thoroughly the Shutter located above the Ice Dispensing Spout.
32 2. MAINTENANCE 2. MAINTENANCE 2. MAINTENANCE 2. MAINTENANCE 2. MAINTENANCE IMPORTANT IMPORTANT IMPORTANT IMPORTANT IMPORTANT 1. This ice dispenser must be maintained individually, referring to the instruction manual and labels provided with the ice dispenser.
33 3) Air Filter (Air-cooled model only) - See Fig. 17. A plastic mesh air filter removes dirt or dust from the air and keeps the Condenser from getting clogged. As the filter becomes clogged, the ice dispenser’s performance will be reduced. Check the filter at least twice a month.
HOSHIZAKI HOSHIZAKI AMERICA, INC. HOSHIZAKI AMERICA, INC. HOSHIZAKI AMERICA, INC. HOSHIZAKI AMERICA, INC. HOSHIZAKI AMERICA, INC. 618 HIGHWAY 74 SOUTH 618 HIGHWAY 74 SOUTH 618 HIGHWAY 74 SOUTH 618 HIG.
An important point after buying a device Hoshizaki DMC-750BWF (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hoshizaki DMC-750BWF yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hoshizaki DMC-750BWF - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hoshizaki DMC-750BWF you will learn all the available features of the product, as well as information on its operation. The information that you get Hoshizaki DMC-750BWF will certainly help you make a decision on the purchase.
If you already are a holder of Hoshizaki DMC-750BWF, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hoshizaki DMC-750BWF.
However, one of the most important roles played by the user manual is to help in solving problems with Hoshizaki DMC-750BWF. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hoshizaki DMC-750BWF along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
