Instruction/ maintenance manual of the product UH50000 Hoover
Go to page of 19
Owner's Manual 0 pe roti n g o n d Se rvi ci n g I nstru cti ons www.hoover.com Please review this manual before operating your Hoover@ product. =z =2 =z =t l=t @2008 Healthy Gain lnvestments, Ltd.
Thank you for choosing Please enter the complete model and serial numbers in the spaces provided. Model a HOOVER' product. ff@,lffifiiklfliitlll, #Fffqlra"*.@" frnf.lm-ffi lrE IIilEL|h[t[ M mffi** I*r/FtEtIE l||fiffi|slEilil -rs!:* UXUXXINXX Serial Number Hint: Attach your sales receipt to this owner's manual.
lmportant Safety lnstructions When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNINGI To reduce the risk of fire, electric shock, or injury: o Do not use outdoors or on wet surfaces.
1. Assembling cleaner This cleaner was inspected and packaged carefully before being shipped from the factory. lf you should happen to need assistance during assenrbly or operation, call 1-800-944-9200 for an automated referral of authorized service outlet locations (U.
STEP ll Attach hose Align end of hose with projection (E) over slots (F) in dirt duct on back of handle. NOTE: Hose must be connected as shown for all operations. Slide hose into (F) and twist hose to lock it into place. Position hose over rack and into hose tube (G).
2. How to use Cleaner description Operate cleaner only at voltage specified on data plate on bottom of cleaner. The assembled cleaner will look like the drawing. l. Handle 2. Self-propel button 3. 0N-0FF switch 4. Hose 5. Tool cover 6. Powered hand tool 7.
ON-OFF Switch Plug cord into elec- trical outlet. To turn cleaner 0N, push switch up. To turn cleaner 0FF, push switch down. Note: To reduce the risk of electric shock, this appli- ance has a polarized plug Ione blade is wider than the other). This plug will fit in a polar- ized outlet only one way.
(Fig. 2.7 Continued) When the red light is on, you should take additional cleaning strokes in the area until it changes to green. o The red light may seldom come on during cleaning. This means that your cleaner is picking up primarily fine surface dust and lint which the system may not detect, or that the carpet is generally clean.
tool cover How to attach The tool cover is designed with a "break-away" feature which al- lows it to snap free if it is pushed open too far. To reattach, align hinges of cover with slots on sides of tool storage area. Push cover down to secure in place.
Sta ir Cleaning Use the hose and powered hand tool or furniture nozzle for stair cleaning. CAUTION: To prevent the cleaner from falling, always place it at the bot- tom of the stairs.
Where to buy Filter bags may be purchased from Au- thorized Hoover Dealers (Depot), Leading Retailers, from Hoover Factory Service Centers, or through Hoover lnc., on-line at www.hoover.com. What to buy To assure cleaning effectiveness, use only HOOVER@ Allergen Filtration Media Type Y Disposable Filter Bags.
Replacing final The final filter assists in the filtration process to return clean air to the room. The 3 layer filter (some models) can be washed in the sarne manner as the secondary filter and reused. To remove final filter, first open the door on the side of the cleaner (Fig.
Belt replacement The belts are located under the bottorn plate of the cleaner and should be checked from time to time to be sure thev are in rrood condition. The flat (wide) belt is described below; tlre other is described under "Brush roll replacement".
Replacing brush roll Removing brush roll Slide Brush Roll Control (Fig. 2-9) to "Hard" (0FF) position. Turn cleaner over and remove bottom plate (Fig. 3-e). Lift up brush roll and slide V-belt (D) off brush roll. Inspecting V-belt The V-belt is designed to last for a long time and is not normally replaced.
Q,,{----,,---g 3. Remove agitator including end plates (C) and discard. 4. lnspect belt to ensure that it is in good condition. lf belt is cracked, gouged or broken, replace it (see fol- lowing section). 5. lnsert brush roll through belt and position belt over gear teeth (D) on brush roll.
Edge groomer replacement When to replace The edge groomers, located on both sides of the front of the cleaner, should be replaced when they appear worn. What to buy When purchasing edge groomers, ask for HOOVER part No. 3941 1 01 B. Replacing edge groomers Disconnect cleaner from electrical outlet.
4. Trouble Shooting lf a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below. PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION Cleaner won't .
Checking under bottom plate 5. Remove bottom plate ( Fig. 3-e) and brush roll (Fig. 3-r 5). Look into opening (F), in channnels (G) and around lin- er (H), and remove any accumulated debris. lf blockage occurs hand tool use 1. Disconnect powered hand tool from hose.
Parts and Accessories MAIL ORDER FORM Detach this sectiorr arrd mail to: Hoover, lnc. 7005 Cochrarr Road o Clenwillow 0hio o 44119 Attrr: Sales tt Service Cerrtcr Item Description Part No. Qty/ Pk. Price/Pk. atv. Total Allergen Filtration Type Y Disposable Filter Bags 40 1 01 00Y 3 $ 9.
An important point after buying a device Hoover UH50000 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hoover UH50000 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hoover UH50000 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hoover UH50000 you will learn all the available features of the product, as well as information on its operation. The information that you get Hoover UH50000 will certainly help you make a decision on the purchase.
If you already are a holder of Hoover UH50000, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hoover UH50000.
However, one of the most important roles played by the user manual is to help in solving problems with Hoover UH50000. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hoover UH50000 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
