Instruction/ maintenance manual of the product U6049 Hoover
Go to page of 16
’ I HOOVER. Model Owner’s Dial-A-Matic” U6049 Manual Cleaner with Automatic Rd PowerDrive’” 1.
Fill in and ret&n! The HOOVER vacuum cleaner you have just purchased is a combination cleaner. The cleaner may be used on carpet and rugs, and it is also for use with attachments. This cleaner is equipped with the automatic ‘Power - Drive’ feature.
I Importantsafeguards! II l Read all instructions. ! l Warning: Electric shock could occur if used outdoors or on weh surfaces. I 8 1 l Close supervision is necessary when any appliance is used by or near chil- i{ dren. Do not allow vacuum cleaner to be used as a toy or to run unattend- ,I ed at any time.
MANUAL TRANSPORT BUTTON (DISENGAGE DRIVE) ON/OFF SWITCH COVER LATCH CARRYING HANDLE FULL BAG INDICATOR -SOME MODELS CARPET AND TOOL SUCTION ADJUSTMENT DIAL AND INTERLOCK OPENING FOR CLEANING ATTACHMEN.
Howtouse FIG. 1 This deluxe cleaner provides you with an automatic ‘Power Drive’ feature. It propels the cleaner forward and backward at a variable rate of speed controlled entirely by (you) the operator. ! To move forward Push the handle grip forward.
FIG. 1 FIG. 2 To transport Your ‘Power Drive’ cleaner can be transported by two methods: 1. Use the convenient carrying hand)e for carrying your cleaner up and down stairs or when lifting the cleaner from one surface to another. Lift it as shown in Fig.
Cleaning tools 1. Vinyl hose Hose has vinyl jacket for long, trouble-free life. The light flexible hose has a vinyl tab, so it can be hung on the cleaner. A suction regulator is located on the hose grip. 2. Extension wand Use to give extra length when cleaning stairs or above the floor, hard to reach areas.
b. To wand Add a tool to the end of the wand by fitting the button projection on the tool into the opening on the wand. You will hear the plastic spring latch snap and lock into place. To release, press down on the spring latch and remove. 4. Remove hose for floor use When you are finished using the attachments, remove the hose.
There are two types of full bag indicators. One is a light which will glow red showing the words “CHECK BAG”. The second is an indicator which appears showing the words “CHECK BAG”. This indicator may become visible for a few seconds when the cleaner is first turned on and will then disappear.
FIG. 1 FIG. 2 outside of cover and the cover is in proper posit&on on the gasket before latching. With the cleaner upright and the handle in the storage position, turn on the motor briefly before lowering handle into cleaning position. This insures that the throw-away bag is inflated.
I I i There are two belts on your cleaner. The belts drive the agitator and the power drive pulley and are important for the efficient operation of your cleaner. Because of this, when buying new belts, you should always insist on genuine HOOVER belts.
! Replace agitator and latch it in posi- I tion. (Fig. 4). Make sure that large belt is in center of pulley, and free of agitator mount- ings and latch. Turn agitator by hand to be sure that belt is in proper posi- tion. (Fig. 5). Replace bottom plate.
By turning the end plates in opposite directions, one plate will come off. (Fig. 3 and Fig. 4). Then pry out either end section as shown in Fig. 5 and 6. This will ex- pose the shaft. “a-,,, : , , / i Tap the shaft gently with a hammer to release other plate and end section.
THE HEADLIGHT (Some models only) The headlight, located at the bottom of the front bag cover, operates when the cleaner is turned on. The headlight bulb illuminates both the headlight and the full bag indicator. TO REPLACE BULB 1. Remove cord from electrical outlet.
USER CHECK LIST This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usually can be remedied quite easily when the cause is identified. Accordingly, this check list is provided for your convenience.
. VCMA VACUUM CLEAhER MANUFACTURERS ASSOCIATION (HOOVER -AN ASSOCIATION MEMBER) Service To The Consumer Since 19 13 This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Governmental and Private Sources concerned with product safety.
An important point after buying a device Hoover U6049 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hoover U6049 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hoover U6049 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hoover U6049 you will learn all the available features of the product, as well as information on its operation. The information that you get Hoover U6049 will certainly help you make a decision on the purchase.
If you already are a holder of Hoover U6049, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hoover U6049.
However, one of the most important roles played by the user manual is to help in solving problems with Hoover U6049. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hoover U6049 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
