Instruction/ maintenance manual of the product Spirit Vacuum Cleaner Hoover
Go to page of 20
.
Fill in and retain! The HOOVER vacuum cleaner you have just purchased is a combina- tion cleaner. It has a nozzle for carpet and floor cleaning and cleaning tools for above the floor cleaning. The model and serial number appear on the bottom of the cleaner.
Important Safeguards! l Read all instructions. l Warning: Electric shock could occur if used outdoors or on wet sur- faces. l Close supervision is necessary when any appliance is used by or near children. Do not allow vacuum cleaner to be used as a toy or to run unattended at any time.
11 I Unpacking Unpack the cleaner from the carton and identify the parts shown. Remove and dispose of the cardboard packing. A. Canister cleaner B. Rug and floor nozzle C. Throw away bag D. Extension wands, hose and cleaning tools The cleaner assembled will // i look like the -8 k.
1. Combination rug and floor nozzle (ONE nozzle is included with each model) 2. Carrying handle * 3. Bag check indicator shows red when throw away bag should be checked. 4. Cover is removed by lifting up top section of carrying handle and pulling forward.
How to assemble I. Connect hose To connect hose, insert large end into opening of cleaner, lining up largest projection on hose with largest notch of opening. Turn hose to the right to tighten. To disconnect, depress latch, and turn hose to the left. 2.
How to use Rug and floor nozzle The combination rug and floor nozzle has been designed to do an effi- cient cleaning job on both carpet and hard surface floors.
Hard surface floors Put the brush in the stationary position by moving the brush lock lever to “FLOOR” on the nozzle. Rugs Put the brush in floating position by moving the brush lock lever either to the left or right to “RUG”.
Hard surface floors Put the brush in the stationary position by pushing in the lever marked “FLOOR” with your toe until you hear a click. Rugs Put the brush in the floating posi- tion by pushing in the lever mark- ed “RUG” with your toe until you hear a click.
Suction regulator (Available with some models) The suction regulator is located on the hand grip and may be used to increase or decrease suction for various cleaning tasks.
Cleaning tools A variety of useful cleaning tools are made for your cleaner. Ail of these are shown below. Some models include a crevice tool and multi-purpose brush for general cleaning tasks. Other models include a crevice tool, furniture nozzle, dusting brush, and wall/floor brush for more.
To clean stairs Clean stairs by placing the cleaner on end as pictured in the illustra- tion. Clean stairs from bottom to top. How to store Your cleaner may be stored on end as shown in the illustration. Store the hose, wands and nozzle separately or attached to the cleaner.
Where to buy bags Bags may be purchased from your local Authorized Hoover Dealer or from a Hoover Factory Service Center. When ordering bags, be sure to give the model number of your cleaner.
3. To install the new bag, place. the notches on the bag collar (at the bag,edge) into the grooves in- side the lower front of cleaner. 4. Pull collar forward until latch snaps onto collar. Open folds of bag. Replace cover. Secondary filter To clean secondary filter Disconnect cleaner from elec- trical outlet.
Rug and floor nozzle To maintain the cleaning effectiveness of your rug and floor nozzle, the brushes and litter pickers (on some models) will need replaced occa- sionally. Refer to the section that shows the rug and floor nozzle that you have purchased.
Replacing rug/f loor nozzle brush When to replace Replace the brush on the rug and floor nozzle when it becomes worn and is not doing a satisfac- tory job of cleaning.
Replacing brush and litter picker on rug/f loor nozzle LITTER PICKER Y ’ I When to replace Replace the brush and litter picker on the rug and floor nozzle when they become worn and are not doing a satisfactory job of cleaning. How to replace 1. Remove four screws and take off bottom plate.
If you have a problem This appliance was inspected thoroughly and was in good operating con- dition when it was shipped from the factory. If a minor problem develops, it usually can be remedied quite easily when the cause is identified. Ac- cordingly, this check list is provided for your convenience.
Lubrication The motor is equipped with two bearings that contain sufficient lubrica- tion for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing. Energy saving tips 1. 2. 3. Replace throw away cleaner bag promptly, before overfilled.
VCMA VACUUM CLEANER MANUFACTURERS ASSOCIATION (HOOVER - AN ASSOCIATION MEMBER) Service To The Consumer Since 1913 This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Government and Private Sources concerned with product safety.
An important point after buying a device Hoover Spirit Vacuum Cleaner (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hoover Spirit Vacuum Cleaner yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hoover Spirit Vacuum Cleaner - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hoover Spirit Vacuum Cleaner you will learn all the available features of the product, as well as information on its operation. The information that you get Hoover Spirit Vacuum Cleaner will certainly help you make a decision on the purchase.
If you already are a holder of Hoover Spirit Vacuum Cleaner, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hoover Spirit Vacuum Cleaner.
However, one of the most important roles played by the user manual is to help in solving problems with Hoover Spirit Vacuum Cleaner. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hoover Spirit Vacuum Cleaner along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
