Instruction/ maintenance manual of the product F2035 Homelite
Go to page of 20
OPERA T OR’S MANUAL T rimmer F2035 UT70123 SA VE THIS MANUAL FOR FUTURE REFERENCE Y our ne w trimmer has been engineered and manuf actured to Homelite’s high standard f or dependability , ease of operation and operator saf ety . Properly cared for , it will give y ou y ears of rugged, trouble-free perf or mance.
2 ■ ■ ■ ■ ■ Safety ......................................................................................................................... ........................................... 2 - 3 ■ ■ ■ ■ ■ Symbols ......................
3 ■ ■ ■ ■ ■ Secure long hair so it is above shoulder level to prevent entanglement in any moving parts. ■ ■ ■ ■ ■ Keep all bystanders, children and pets at least 15 m (50 ft) away. ■ ■ ■ ■ ■ Do not operate this unit when you are tired, ill or under the influence of alcohol, drugs or medication.
4 Important: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and more safely. SYMBOL NAME EXPLANATION Safety Alert Symbol Indicates danger, warning or caution.
5 The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols and the explanations with them deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention measures.
6 FEA TURES Fig. 1 THROTTLE TRIGGER SILENCER GUARD STARTER GRIP CHOKE LEVER THROTTLE CONTROL AND REAR HANDLE FRONT HANDLE DRIVE SHAFT HOUSING STRING HEAD GRASS DEFLECTOR IGNITION SWITCH INSTRUCTIONS ■ ■ ■ ■ ■ Carefully remove the product from the carton.
7 Fig. 3 SCREWS SILENCER GUARD REAR HOUSING BENT END OF SILENCER GUARD OPENING IN REAR HOUSING ASSEMBL Y WING NUT FRONT HANDLE BOLT Fig. 2 FRONT HANDLE See Figure 2. 1. Remove the front handle, bolt and wing nut from the Owner’s Kit. 2. Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position.
8 ASSEMBLY INSTRUCTIONS: EDGER GUIDE ASSEMBLY See Figure 4. 1. Assemble the two plastic pieces of the edger guide together using the short bolt, flat washer, lock washer and wing nut. 2. Slide the edger guide to adjust it to the desired trimming length.
9 FILLING THE TANK 1. Clean surface round fuel cap to prevent contamination. 2. Loosen fuel cap slowly to release pressure and to keep fuel from escaping around the cap. 3. Carefully pour fuel mixture into the tank. Avoid spillage. 4. Prior to replacing the fuel cap, clean and inspect the gasket.
10 BEST CUTTING AREA DANGEROUS CUTTING AREA Fig. 8 OPERA TION OPERATING THE TRIMMER See Figure 7. Hold the trimmer with the right hand on the trigger handle and the left hand on the left handle. K eep a fir m grip with both hands while in operation. T rimmer should be held at a comf or table position with the rear handle about hip height.
11 EDGER GUIDE OPERATION - TRIM ‘N EDGE ONLY See Figures 10 and 11. ■ Loosen the wing nut and slide the edger guide to adjust it to the desired trimming length; then retighten the wing nut securely. Refer to “Edger Guide Assembly” earlier in this manual for additional information.
12 1 IGNITION SWITCH I = ON TO RUN O = OFF TO STOP Fig. 12 THROTTLE TRIGGER THROTTLE INTERLOCK STARTING AND STOPPING See Figures 12 and 13. OPERA TION TO START A COLD ENGINE: 1. Lay trimmer on a flat, bare surface. Move switch to “I” (RUN) position.
13 Y ou ma y make adjustments and repairs described here. F or other repairs, have the trimmer serviced by an authorised ser vicing dealer . SPOOL REPLACEMENT EZ LINE™ TAP ADVANCE SYSTEM NEW PRE-WOUND SPOOL See Figures 14 and 15. If replacing string only , refer to “String Replacement” later in this manual.
14 STRING REPLACEMENT See Figures 16, 17, 18 and 19. 1 Stop the engine and disconnect the sparking plug wire. Hold the string head and unscrew the spool retainer. Turn anticlockwise. 2 Remove the spool from the string head. NOTE: Keep the spring attached to the spool.
15 The fuel cap contains a non-serviceable filter and a check valve. A clogged fuel filter will cause poor engine perfor- mance. If performance improves when the fuel cap is loosened, the check valve may be faulty or the filter clogged. Replace fuel cap if required.
16 TROUBLESHOOTING PROBLEM PROBLEM PROBLEM PROBLEM PROBLEM POSSIBLE CAUSE POSSIBLE CAUSE POSSIBLE CAUSE POSSIBLE CAUSE POSSIBLE CAUSE SOLUTION SOLUTION SOLUTION SOLUTION SOLUTION IF THESE SOLUTIONS DO NOT SOL VE THE PROBLEM, CONT ACT YOUR AUTHORISED SERVICE DEALER.
17 TROUBLESHOOTING PROBLEM PROBLEM PROBLEM PROBLEM PROBLEM POSSIBLE CAUSE POSSIBLE CAUSE POSSIBLE CAUSE POSSIBLE CAUSE POSSIBLE CAUSE SOLUTION SOLUTION SOLUTION SOLUTION SOLUTION IF THESE SOLUTIONS DO NOT SOL VE THE PROBLEM, CONT ACT YOUR AUTHORISED SERVICE DEALER.
18 SOUND POWER/PRESSURE AND HANDLE VIBRATION CHART FOR TRIMMERS / BRUSHCUTTERS Information on Noise Emission per European Machine Safety Directive 98/37/EC. The individual equipment listed was operated in a manner consistent with normal working conditions.
19 NO TES.
983000-205 2-03 OPERA T OR’S MANUAL T rimmer F2035 UT70123 Ryobi T echnologies GmbH Itterpark 7 D-40724 Hilden Germany T el.: +49 (0)2103 / 29 58 0 F ax : +49 (0)2103 / 29 58 29 info@ryobi-rtg.de Ryobi T echnologies Customer Services Anvil House T uns Lane Henley-on-Thames RG9 1SA UK Homelite / R.
An important point after buying a device Homelite F2035 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Homelite F2035 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Homelite F2035 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Homelite F2035 you will learn all the available features of the product, as well as information on its operation. The information that you get Homelite F2035 will certainly help you make a decision on the purchase.
If you already are a holder of Homelite F2035, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Homelite F2035.
However, one of the most important roles played by the user manual is to help in solving problems with Homelite F2035. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Homelite F2035 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
