Instruction/ maintenance manual of the product Adventure Island Hobie
Go to page of 8
1. Using an Allen key wrench, unscrew the bolt that is passing through that handle and pull the handle off of the control arm shaft. 2. Push the control arm shaft in so that it falls in the hull. Reach inside the hull and grab the control arm to take both of the lines off of it.
6. With the up and down control lines loose, pull on them and re- move them from the hull with the tubes. If they get hung up inside the hull, you can cut whatever is preventing you from taking out the lines. Y ou will no longer need these lines and tubes with this kit.
1 1. Now feed the UP control line through the same two holes above the rudder pin to the inside of the rudder housing. Wrap the line so that it goes over top and around the drum. Insert the end of the line into the lower hole indicated in step 10 and tie a knot at the end of the line.
16. Drill a hole in the dotted location with a 5/16” drill bit 17. Insert one of the two the small length of rigid tube into the hole and press the black fitting at the end of the tube into the hole. It will be a tight fit, so you may need to give it a couple taps with a hammer to get it into the hole.
18. Locate the cleat on the right side map pocket just like in step 7 and use the holes in the cleat as a guide to drill two 1 1/64” holes through the map pocket frame and kayak hull material underneath it. Make sure to center the cleat along the width of the map pocket frame so that it rests on a nice flat surface.
23. Through bolt the two pulleys on the inside of the kayak. On the RIGHT side of the kayak, use the existing screws that are being used to attach the mainsheet routing pulley line and place nuts on the outside of the new block to hold it in place.
28. Pull the lines all the way back to the rear hatch and tie a simple knot approximately 4” from the end of the lines. 29. Now you are going to lock the small lines with loops at the end coming from the rudder to the knots that you just tied. T o do this, follow the diagram below to form a cinch around the line up to the knot.
29. Y our up/ down rudder system is now ready to go a. Pull on the right “T” handle to lower the rudder . Pull the line tight and cleat off to hold it in the down position. b. T o raise the rudder , uncleat the lock down line and pull the “T” handle on the left side of the boat.
An important point after buying a device Hobie Adventure Island (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hobie Adventure Island yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hobie Adventure Island - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hobie Adventure Island you will learn all the available features of the product, as well as information on its operation. The information that you get Hobie Adventure Island will certainly help you make a decision on the purchase.
If you already are a holder of Hobie Adventure Island, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hobie Adventure Island.
However, one of the most important roles played by the user manual is to help in solving problems with Hobie Adventure Island. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hobie Adventure Island along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
