Instruction/ maintenance manual of the product 2175.502 American Standard
Go to page of 6
COLONY SOFT 2175.502 T urn off hot and cold water supplies before beginning. CAUTION Inser t F AUCET (1) and CABLE CONNECTOR (2) through center hole of mounting surface. Fig. A. From under side of mounting surface thread the two MOUNTING NUTS (2) onto F AUCET SHANKS (4) .
M968881 Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain body. Fig. A. Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3). Fig. B. POP-UP DRAIN Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY.
M968881 COMPRESSION NUT 3/8” COMPRESSION CONNECTION COUPLING NUT FLEXIBLE SUPPLIES 3/8 O.D. BULL-NOSE RISERS Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes. Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.
3 2 10 TEST INST ALLED FITTING 5 2 CHECK DRAIN CONNECTIONS Operate POP-UP KNOB (4) and fill lavator y with water . Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK. If DRAIN STOPPER (5) does not seal properly , please refer to T roubleshooting section in these instructions.
M968881 SpeedConnect™ Drain Troubleshooting Guide Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A. Look at the area on the Drain Body where the Cable was attached and locate the component labeled as “Cam” and “Cam Cap” in the illustration.
M968881 STOPPER INSTALLATION PROCEDURE Locked Mode: Look at the Plastic Loop at the bottom of the Stopper and notice that the Loop is on one side of the Stopper.
An important point after buying a device American Standard 2175.502 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought American Standard 2175.502 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data American Standard 2175.502 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, American Standard 2175.502 you will learn all the available features of the product, as well as information on its operation. The information that you get American Standard 2175.502 will certainly help you make a decision on the purchase.
If you already are a holder of American Standard 2175.502, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime American Standard 2175.502.
However, one of the most important roles played by the user manual is to help in solving problems with American Standard 2175.502. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device American Standard 2175.502 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
