Instruction/ maintenance manual of the product 32LD6600 Hitachi
Go to page of 36
32LD6600 GB D F I Instructions for use Bedienungsanleitung Notice d'utilisation Istruzioni per l'uso 32LD6600B 32LD6600A Downloaded From TV-Manual.
- 1 - Contents T eletext .................................................. 1 8 T o Operate T eletext ............................ 1 8 T o Select A Page Of T eletext ............... 1 8 T o Select Index Page ......................... 1 8 T o Select T eletext W ith A TV Programme .
- 2 - Remote Control Buttons = S tand by On/Off = Picture Mode = Equalizer Sound Mode = Surround Mode = Input Source = Program Information = Sound Mode = Sleep Timer RED / = P A T (Picture and T ext) .
- 3 - LCD TV FRONT VIEW REAR VIEW 01-ENG-32705W-CLE967 UK-HITACHI 32 INCH TFT-TRIDENT-(SAM)-50076727.p65 20.10.2005, 09:56 3 Downloaded From TV-Manual.
- 4 - Headphone Audio Inputs Video Input S-VHS Input EXT -4 S St andyby button TV/A V button MENU button Prog. Up, Prog. Down buttons V olume Up, V olume Down buttons Power cord input Power On/Off swi.
- 5 - Preparation For ventilation, leave a space of at least 10 cm free all around the set. To prevent any fault and unsafe situations, please do not place any objects on top of the set. Use this apparatus in tropical and/or moder- ate climates. Features Remote controlled colour television.
- 6 - priate safety approved extension lead or con- sult your dealer . Observe the manufacturers instructions when connecting extension leads to the TV . Check the fuse rating on the new plug, this should be fitted with a 5 Amp fuse which conforms to ei- ther AST A or BSI (BS1 362) approvals, these are easily identifiable by either the or symbols.
- 7 - "The LCD panel is very high technology product with about a million thin film tran- sistors, giving you fine picture details. Oc- casionally, a few non-active pixels may ap- pear on the screen as a fixed point of blue, green or red. Please note that this does not affect the performance of your prod- uct.
- 8 - Befo re Swit ching On Y our TV Power Connection IMPORTANT: The TV set is designed to op- erate on 220-240V AC, 50 Hz. After unpacking, allow the TV set to reach the ambient room temperature before you con- nect the set to the mains.
- 9 - Unplug the power cord from the mains socket. Initial Settings Initial APS (Automatic Programming System) The following menu will be displayed on the screen when you turn your TV on for the first time. APS, searches and sorts all channels and stores them automatically on your TV, according to the transmission of programme systems in your area.
- 10 - Press the P+ button to select the next programme. Programme Selecting (direct access): Press digit buttons on the remote control handset to select programmes between 0 and 9. The TV will switch to the selected programme after a short delay.
- 11 - Film Mode Films are recorded at a different number of frames per second to normal television programmes. By pressing / button, select Film Mode. Press / button to set this feature On or Off. Turn this feature on when you are watch- ing films to see the fast motion scenes clearly.
- 12 - Sound Mode By pressing / button, select Sound Mode. Press / button to change the mode. You can select Mono , Stereo, Dual A or Dual B mode, only if the selected channel sup- ports that mode. In case of bilingual broadcast (Dual Sound), you can select original or dubbed language using mode option.
- 13 - Ext-2 Out By pressing / button, select Ext-2 Out. You can set Ext-2 Out to TV, EXT-1, EXT-3, EXT-4, EXT-5 or PC by pressing / button. Note: Only audio output is available for EXT- 3, EXT-5 and PC. The other options have both audio and video outputs.
- 14 - found. You can also enter a frequency value directly by pressing the digit buttons. VCR (Video Cassette Recorder) This item can be seen in all modes except EXT -3, EXT-5 and PC. If you want to watch a VCR source from one of these modes, then it will be better to set VCR mode on.
- 15 - Source menu By pressing / button, select the sixth icon. Source menu appears on the screen. In source menu, highlight a source by pressing / button and switch to that mode by pressing / or OK button. PC Mode Installation Power off both Computer and Display before making any connections.
- 16 - Use / button to adjust the value. Phase Depending on the resolution and scan fre- quency that you input to the TV Set, you may see a hazy or noisy picture on the screen. In such a case you can use this item to get a clear picture by trial and error method.
- 17 - PIP window. You can use button to change the PIP position. Aspect Ratio of the PIP window is fixed and 4:3. When PIP Mode is entered, the default active window is PIP window and the active win- dow is indicated by a green frame around it. The active window can be changed by pressing the Yellow button.
- 18 - 14:9 Zoom: This zooms up the wide picture (14:9 aspect ratio) to the upper and lower limits of the screen. Panoramic: This stretches the left and right sides of a normal picture (4:3 aspect ratio) to fill the screen, without making the picture appear unnatural.
- 19 - Press the button again to allow the next page to be displayed. To Select A Subcode Page Subcode pages are subsections of long Teletext pages that can only be displayed on the screen one section at a time. Select the required Teletext page.
- 20 - Connect Peripheral Equipment There is a wide range of audio and video equipment that can be connected to your TV. The following connection diagrams show you where the different (Optional) equipment should be connected at the rear side of the TV.
- 21 - and stored the TV signals. S tore the test sig- nal under programme number 0. Replace the aerial cable in the aerial socket of your video recorder once you have stored the test signal. Camera And Camcorder T o Connect T o AV Input Connect your camera or camcorder to AV (EXT-4) input at the right side of the TV.
- 22 - Connect Peripheral Equipment Aerial Connection 01-ENG-32705W-CLE967 UK-HITACHI 32 INCH TFT-TRIDENT-(SAM)-50076727.p65 20.10.2005, 09:56 22 Downloaded From TV-Manual.
- 23 - Tips Care Of The Screen Clean the screen with a slightly damp, soft cloth. Do not use abrasive solvents as they may damage the TV screen coating layer. Poor Picture Have you selected the correct TV system? Is your TV set or house aerial located too close to non-earthed audio equipment or neon lights, etc.
- 24 - Specifications TV BROADCASTING PAL/SECAM B/G D/K K' I/I' L/L' RECEIVING CHANNELS VHF (BAND I/III) UHF (BAND U) HYPERBAND CABLE TV (S1-S20/ S21-S41) NUMBER OF PRESET CHANNELS 1 0 0 CHANNEL INDICA TOR On Screen Display RF AERIAL INPUT 75 Ohm (unbalanced) OPERA TING VOL T AGE 220-240V AC, 50 Hz.
- 25 - Appendix A: PC Input T ypical Display Modes The display has a maximum resolution of 1366x 768, vertical sync. frequency range of 56-85 Hz and a horizontal sync. frequency range of 30-69 KHz. The following table is an illustration of some of the typical video display modes.
- 26 - Appendix B: DVD Player Selection You can use this remote control to operate the selected brand of DVD player by pressing the following buttons on the remote control simultaneously. Example T o operate HIT ACHI DVD player , press and hold the INFO button, followed by the 1 button.
- 27 - Appendix C: Main and PIP-P A P Picture Combinations 01-ENG-32705W-CLE967 UK-HITACHI 32 INCH TFT-TRIDENT-(SAM)-50076727.p65 20.10.2005, 09:56 27 Downloaded From TV-Manual.
- 28 - UK Guarantee Your Guarantee of Excellence Thank you for purchasing this Hitachi Television. In the unlikely event that this product should develop a fault, we undertake to replace or repair any.
TV/AV MENU P/CH VOLUME Rear view ANT .IN VCR AV- 1 AV- 2 QUICK GUIDE QUICK GUIDE QUICK GUIDE IMPORT ANT - If placing TV into cabinet or alcove, ensure there is at least a 100mm (10cm) gap to the sides, rear a n d t o p o f t h e T V. This is to allow for adequate ventilation during operation.
...or through a satellite decoder ... ...or through a VCR and sa tellite decoder . ANT .IN ANT .IN ANT .IN RF Lead to Aerial RF Lead to Aerial RF Lead from VCR to Satellite RF Lead from VCR to TV Satellite LNB lead Satellite LNB lead RF Lead from Satellite to TV Aerial Aerial VCR • Scart Lead to on TV .
basic functions of r emote control connect the TV plug to the mains sock et s w i t c hy o u rT Vo n by pressing the On/Of f button NB: When the set is first switched on, the set will be in standby . Press the channel up down (P- and the indicator on the front of the set will illuminate red , P+) or numeric buttons (1, 2, 3, .
Once the TV has found all your local stations, they are then automatically assigned a programme numberand name, if available from the broadcast. If you would like to change the programme number or order , please refer to the Program Menu section of the instruction book.
- 33 - *% Installation Of The TFT TV To The Wall 1- To install the TFT TV on the wall, first of all, foot assembly should be removed. (Figure 1). Unscrew the 4 screws (M3 x 6) that attach the foot assembly to the TFT panel and remove the foot assembly from the TFT panel.
- 34 - *% ),*85( Attention: Only the original wall bracket should be used with this product 32705 duvara montaj (13 DIL).p65 26.10.2005, 15:38 2 Downloaded From TV-Manual.
HIT ACHI EUROPE L TD. UNITED KINGDOM Consumer Affairs Department PO Box 3007 Maidenhead Berkshire SL6 8ZE T el: 0870 405 4405 Email: HIT ACHI EUROPE GmbH GERMANY HIT ACHI EUROPE S.
An important point after buying a device Hitachi 32LD6600 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hitachi 32LD6600 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hitachi 32LD6600 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hitachi 32LD6600 you will learn all the available features of the product, as well as information on its operation. The information that you get Hitachi 32LD6600 will certainly help you make a decision on the purchase.
If you already are a holder of Hitachi 32LD6600, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hitachi 32LD6600.
However, one of the most important roles played by the user manual is to help in solving problems with Hitachi 32LD6600. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hitachi 32LD6600 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
