Instruction/ maintenance manual of the product 28LD5000TA Hitachi
Go to page of 53
1 ENGLISH USER'S MANUAL Thank you very much for purchasing the HITACHI LCD Monitor. Before using your monitor, please carefully read the "SAFETY INSTRUCTIONS" and this "USER'S MANUAL" so you will know how to operate the monitor properly.
2 Important Please read this User's Manual thoroughly, especially the Safety Instructions on Page 4 to 7. Mis-use may cause damage to your LCD monitor, which could shorten its lifespan, or cause injury to yourself.
3 ENGLISH CONTENTS FEATURES ....................................................2 SAFETY INSTRUCTIONS ..............................4 COMPONENT NAMES ..................................8 Main Unit .......................................................
4 SAFETY INSTRUCTIONS This LCD monitor has been designed and manufactured to meet international safety standards, but like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.
5 ENGLISH • FOR THE CUSTOMERS IN THE U.K. THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINLAND EUROPE. FOR THE U.K. PLEASE REFER TO THE NOTES ON THIS PAGE.
6 PRECAUTIONS • Installation environment Do not obstruct a ventilation hole. Do not put the monitor on carpet or blanket, or near a curtain which has a possibility of obstructing a ventilation hole of the monitor. Do not put the monitor in the following places.
7 ENGLISH • Prevention of an obstacle to Radio receivers This monitor has been designed pursuant to the international EMI standards. This is to prevent a problem to Radio receivers. - Keep the monitor away from Radio. - Adjust Radio antennas in order for the monitor not to receive interference.
8 Caution when moving the main unit • As this product is heavy, whenever it is moved, two people are required to transport it safely. • Whenever the unit is moved it should be gripped on the top of the panel and the unit should then be held at the base on both sides for stability as shown.
9 ENGLISH COMPONENT NAMES Remote control POWER ON / OFF button PICTURE MODE button SURROUND button Loading Batteries 1. Open the battery cover. • Slide back and remove the battery cover in the direction of the arrow. 2. Load batteries. • Load two Size AA batteries included observing the correct polarities.
10 COMPONENT NAMES (continued) Remote control (continued) D / N A / B i + M E NU O K FR EE Z E Z OO M A V 1 R G B 1 R G B 2 A V 2 A V 3 A V 4 2 - 4 - 12 I / II P+ P- + - D V D 12 3 45 6 78 0 9 PICTURE MODE INPUT SELECT RECALL DVD CONTROL PROGRAM SELECT TIME AUDIO MODE Y ou may recall the sound mode by pressing this button.
11 ENGLISH Anti-tumble measures Securing to a wall or pillar Using a commercially available cord, chain and clamp, secure the set to a firm wall or pillar. Securing desktop 1) Using wood screws (two), fasten the set to the clamping screw holes on the rear of the stand as shown.
12 Read SAFETY INSTRUCTIONS ( to ) carefully to ensure maximum safety before proceeding to these steps: • Choose an appropriate site and install the product on a level table where the stand is secure. • Install the monitor to have ready access to a power socket available.
13 ENGLISH ① Connect the power cord to this device. ➁ Connect the power cord plug to the power outlet. (The type of plug is different from this drawing for some countries.) Connect the power cord, after completing all other connections. ① ➁ INST ALLA TION INSTRUCTIONS (continued) Power Cord Connection • Use only the power cord provided.
14 OPERA TING INSTRUCTIONS T urning Power On and Off • To turn the monitor power ON, press the main power switch on the monitor main unit to ON, and then press the SUB POWER button or the ON/OFF or ON button on the remote control.
15 ENGLISH D / N A / B i + MENU OK FREE ZE ZOO M AV1 RGB1 RGB2 AV2 AV3 AV 4 2- 4- 12 I / II P+ P- + - DVD 123 456 78 0 9 OPERA TING INSTRUCTIONS (continued) Audio Mute The audio volume can be temporarily mute by pressing the MUTE button of the remote control.
16 Size Switching Each time the ZOOM button of the remote control is pressed, the screen display area will change in sequence and the status will be displayed at the bottom of the screen.
17 ENGLISH D / N A / B i + MENU OK FR EEZ E ZO O M AV1 RGB1 RG B2 AV2 AV3 AV 4 2- 4- 12 I / II P+ P- + - DVD 123 456 78 0 9 Using the Menu Screen (On-screen display system) When the MENU button is pre.
18 PICTURE MENU Picture Audio Tim er Function Setup Language Select OK Set Picture Contrast : + 31 Brightness : – 31 Colour : 0 Hue : + 31 Picture Enhancement : Off Colour T emperature : Normal Colour T emp.
19 ENGLISH Selected characters Setup hint Audio Mode Movie Music Speech Favourite Movie: This selects the audio suitable for Movie. Music: This selects the audio suitable for Music. Speech: This selects the audio suitable for News, Talk show etc. Favourite: This mode should be adjusted depending on user ’ s preference.
20 Picture Audio Tim er Function Setup Language Select OK Set Function Screen Saver Off Screen Wipe On 60Min. Black Side Panel Off Video Power Save Off Freeze Mode Split Default Zoom Panoramic Reset R.
21 ENGLISH SETUP MENU Picture Audio Time r Function Setup Language Select OK Set Setup Auto Adjust Adjust Horizontal Position 0 Vertical Position + 31 Horizontal Clock – 20 Clock Phase 10 Reset Reset Select Return Exit Setup Input Level 0.
22 LANGUAGE MENU Picture Audio Tim er Function Setup Language Select OK Set Language English Fran ç ais Deutsch Espa ñ ol Italiano Norsk Svenska Select Return Exit OK P+ P- MENU Select a language by ▼ ▲ SELECT buttons and press the OK button. OTHER FEA TURES Automatic Store Approximately 1 sec.
23 ENGLISH Signal Check Status Display Action The input signal is switched or when the RECALL button is pressed. A guide is displayed for the input terminal and the horizontal and vertical sync frequency. When the sync signal is no longer detected. • A guide displays No Sync.
24 NOTES About screen defects • High precision technology is used in the making of LCD panels but there may be dark spots (points that do not illuminate) and bright spots (points that are too bright) in some cases. These do not indicate a malfunction.
25 ENGLISH Symptoms That Seemingly Appear to be Failures Make the checks suggested below depending on the symptoms observed. If the symptoms remain uncorrected, contact your dealer. TROUBLESHOOTING Customer servicing can be hazardous. W ARNING Symptom Point to check See page • No picture with the power-indicating lamp off.
26 20.
27 ENGLISH Depending on the kind of system equipment used, images may not be displayed normally. In this case, make the adjustments suggested below. (only for RGB2) Actions to Correct Abnormal Display.
28 Monitor rear panel Speaker (R) Speaker (L) Power cord Video Unit Function Use if the video equipment has an S video input terminal T o RGB, video and audio input terminals T o SCART terminal T o S .
29 ENGLISH OPERA TING INSTRUCTIONS Input Switching OK FREE ZE ZOO M AV1 RGB1 RGB2 AV2 AV3 AV 4 P+ P- + - DVD 123 456 78 0 9 TV A V1 A V2 A V3 RGB2 RGB1 A V4 INPUT SELECT button RGB/VIDEO buttons Each .
30 ATTENTION Using a wide-screen monitor • This monitor has a screen mode selection feature. If an incompatible screen mode is selected to play certain software, such as a TV program, the image would appear different from the original. Take this into consideration when making screen mode choices.
31 ENGLISH OPERA TING INSTRUCTIONS (continued) PinP button D / N A / B i + MENU OK FR EEZ E ZO O M 2- 4- 12 I / II P+ P- + - DVD 123 456 78 0 9 RECALL button The input signal status can be displayed on the screen by pressing the RECALL button of the remote control.
32 Picture Audio Time r Function Setup Language Select OK Set Picture Picture Mode Dynamic Contrast +31 Brightness -31 Colour 0 Sharpness +15 Hue 0 Colour T emperature Normal Contrast Mode Normal Back.
33 ENGLISH OPERA TING INSTRUCTIONS (continued) PICTURE MENU (continued) ▼ ▼.
34 Selected characters Setup hint Colour Management Off On Turn On when the original balance of each colour is required to adjust depending on the user ’ s preference. Magenta Magenta is weakened. Magenta is strengthened. This adjusts listed colours individually to make them either deeper or more pure.
35 ENGLISH OPERA TING INSTRUCTIONS (continued) SETUP MENU Picture Audio Time r Function Setup Language Select OK Set Setup System System 1 Colour System Video Input Audio Input Scart Output Monitor RG.
36 Approximately 1 sec. after adjustment is completed, the adjustments will be recorded as shown in the table below. OTHER FEA TURES Automatic Store • The previously recorded items will be lost.
37 ENGLISH Make the checks suggested below depending on the symptoms observed. If the symptoms remain uncorrected, contact your dealer. Customer servicing can be hazardous. W ARNING Symptom Point to check See page • The screen becomes dark and the images cannot be seen during VCR special playback (fast forward, rewind).
38 D / N A / B i + MENU OK FREEZE ZOOM AV1 RGB1 RGB2 AV2 A V3 AV4 2-4-12 I / II P+ P- + - DVD 123 456 78 0 9 SUBTITLE button TV button TEXT button COLOUR buttons (RED, GREEN, YELLOW, BLUE) TEXT / TV +.
39 ENGLISH Monitor rear panel Speaker (R) Speaker (L) Power cord 20 18 16 14 12 10 8 6 4 2 21 19 17 15 13 11 9 7 5 31 antenna Make sure that the power switch of the monitor is turned off.
40 OPERA TING INSTRUCTIONS D / N A / B i + MENU OK FREEZE ZOOM AV1 RGB1 RGB2 AV2 AV3 AV4 2-4-12 I / II P+ P- + - DVD 123 456 78 0 9 POWER ON/OFF button • Input can be switched by pressing the AV1, AV2, AV3, AV4, RGB1 or RGB2 buttons of the remote control.
41 ENGLISH OPERA TING INSTRUCTIONS (continued) RECALL button MULTI PICTURE button SELECT buttons Activating the Split mode from the TV screen Pressing the MULTI PICTURE button one time will display 2 pictures.
42 Input Signal Screen Display The TV channel status can be displayed on the screen by pressing the RECALL button of the remote control. • The display will go out in approximately 6 seconds.
43 ENGLISH OPERA TING INSTRUCTIONS (continued) D / N A / B i + MENU OK FREEZE ZOOM AV1 RGB1 RGB2 AV2 A V3 AV4 2-4-12 I / II P+ P- + - DVD 123 456 78 0 9 When the FREEZE button on the remote control is pressed, the screen transfers into the freeze mode.
44 SETUP MENU Picture Audio Time r Function Setup Language Select OK Set Setup Auto Tuning Manual Tuning Fine Tuning Sort Auto Of f Off Select Set Return OK OK P+ P- M ENU Setup Auto Tuning Country Au.
45 ENGLISH OPERA TING INSTRUCTIONS (continued) SETUP MENU (continued) [During VIDEO signal input] 1 item is added to the Menu shown in the page . 35 Selected characters Setup hint Scart Output TV Monitor TV:AV4 (Scart) output will be fixed as TV signal output.
46 OTHER FUNCTIONS A2 / NICAM / Sound Multiplex • The CH I / II button is only useful for NICAM and sound multiplex signals. Otherwise pressing this button will have no effect. BILINGUAL / DUAL sound broadcast When bilingual program is received, sound mode display appears in yellow as shown on right.
47 ENGLISH OPERA TING INSTRUCTIONS (continued) DVD Player Selection • You can use this remote control to operate the selected brand of DVD player by pressing the following buttons on the remote control simultaneously. Example To operate HITACHI DVD player, press and hold the RECALL button, followed by the button.
48 Make the checks suggested below depending on the symptoms observed. If the symptoms remain uncorrected, contact your dealer. Customer servicing can be hazardous. W ARNING TROUBLESHOOTING Symptoms That Seemingly Appear to be Failures Symptom Possible reason Remedy (1) Connection of antenna cable to the TV is poor.
49 ENGLISH PRODUCT SPECIFICA TIONS • The monitor takes at least 30 minutes to attain the status of optimal picture quality..
50 Signal Input 1 2 3 4 S-input connector pin specifications Pin Input signal 1 Y 2 Y-GND 3 C 4 C-GND Frame GND 20 18 16 14 12 10 8 6 4 2 21 19 17 15 13 11 9 7 5 31 Scart connector pin specifications Pin Signal Pin Signal 1 AUDIO OUT (RIGHT) 12 Not Used 2 AUDIO IN (RIGHT) 13 RGB-R GND 3 AUDIO OUT (LEFT/MONO) 14 GND 4 AUDIO GND 15 RGB-R / S.
51 ENGLISH Recommended Signal List PRODUCT SPECIFICA TIONS (continued).
52 No. Signal mode Horizontal frequency (kHz) Dot clock frequency (MHz) Remarks Signal Name Resolution Vertical frequency (Hz) 1 NTSC4.43 NTSC3.58 525 59.94 15.73 — 2 PAL SECAM 625 50.00 15.63 — With Composite Input(AV1~AV4 input) and S-video Input (AV3 input).
53 ENGLISH Thank Y ou for purchasing this Hitachi T elevision. In the unlikely event that this product should develop a fault, we undertake to repair or replace any part of the product which fails due to a manufacturing defect within 12 months of the date of purchase provided that .
An important point after buying a device Hitachi 28LD5000TA (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hitachi 28LD5000TA yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hitachi 28LD5000TA - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hitachi 28LD5000TA you will learn all the available features of the product, as well as information on its operation. The information that you get Hitachi 28LD5000TA will certainly help you make a decision on the purchase.
If you already are a holder of Hitachi 28LD5000TA, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hitachi 28LD5000TA.
However, one of the most important roles played by the user manual is to help in solving problems with Hitachi 28LD5000TA. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hitachi 28LD5000TA along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
