Instruction/ maintenance manual of the product QV26E Hearth and Home Technologies
Go to page of 25
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 1 Owner ’ s Manual Installation and Operation Models: QV26E Electric Fireplace/Insert DO NOT DISCARD THIS MANUAL CAUTION • Important operating and maintenance instructions included. • Leave this manual with p a r t y r e s p o n s i b l e f o r use and operation.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 2 Read this manual before installing or operating this heater . Please retain this owner ’ s manual for future reference.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 3 T able of Contents 1 Listing and Code Approvals A. Certification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 B. Important Instructions . . . . . . . . . . . . . . . . . . . .
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 4 1 Listing and Code Appro vals Not int ende d for us e as a pr imar y heat sou rce. This heate r is teste d and appro ved as a decorative heat er . It shoul d not be f actored as a pr imar y heat s ource i n residential heating c alculations.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 5 2 Get ting Star ted A. Design and Installation Considerations Check building codes prior to installation. • Installation MUST comply with local, regional, state and national codes and regulations.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 6 3 F raming and Clearances A. Selecting Heater Location Several options are available to you when choosing a loca- tion for your heater . This heater may be used as a room divider , installed along a wall, across a corner or used in an exterior chase.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 7 D B A 1 in. min. (26 mm) 9-3/4 in. (248 mm) 9-3/4 in. (248 mm) A A C 1/2 in. min. (13 mm) Figure 3.1 Heater Locations Fire Risk • Comply with all minimum clearances to combustibles as specified. Failure to comply may cause fire.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 8 C. Frame the Heater Figure 3.2 shows a typical framing (using 2 x 4 lumber) of the heater , assuming combustible materials are used. All re- quired clearances to combustibles around the heater must be adhered to.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 9 4 Installation Sharp Edges • We ar protective gloves and safety glasses during installation. CAUTION Shock Risk Improperly grounded outlets could cause electrical shock. • Always use properly grounded, fused and polarized outlets.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 10 B. As an Insert Pre-installation Preparation This insert and its components are tested and safe when in- stalled in accordance with this manual. Report to your dealer any parts damaged in shipment, particularly the condition of the glass.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 1 1 Note : This heater must be elect rically wire d and gr ounded in acc ordance w ith loc al code s or , in t he absence of lo cal codes, with National Electr ic Code ANSI / NFP A 70-l atest edi tio n or t he Cana dia n Ele ct ri c Cod e, CSA C 2.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 12 FLAME MOTOR TEMPERATURE ADJUSTMENT POTENTIOMETER ON_BRIGHT OFF ON_DIM SELECTOR REMOTE THERMISTOR SENSOR 110 VAC 60 HZ 1300 WATT HEATER THERMAL HIG.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 13 5 Accessories A. Install the Front Face Install the front face following the instructions packaged with the face. B. Install other Optional Accessories Installation of other optional accessories may be done at this time.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 14 6 F inishing A. Finishing Material • Combustible Material Material which is made of or surfaced with wood, compressed paper , plant fibers, plastics, or any material capable of igniting and burning, whether flame proofed or not, plastered or not plastered.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 15 HOT! DO NOT TOUCH. SEVERE BURNS MA Y RESUL T . CLOTHING IGNITION MA Y RESUL T . • Keep children away . • CAREFULL Y SUPERVISE children in same room as heater . • Alert children and adults to hazards of high temperatures.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 16 8 T roublesh ooting Issues Possible Causes Solutions Heater doesn’t turn on with the main switch or remote transmitter . 1. Power switch is off. 1. T urn the power switch to the “ON” position.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 17 9 Maintenance and Ser vice Shock Risk Burn Risk Cl eani ng, pe rfor ming mai nte nanc e or mov ing this electric heater without disconnecting power and allowing the heater to cool could create a shock or burn hazard.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 18 E. Maintenance T ask List Handle glass assembly with care. When cleaning glass door: • Avoid striking, scratching or slamming glass. • Do NOT use abrasive cleaners. • Use a hard water deposit glass cleaner on white film.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 19 1 0 R eference Mater ials A. Heater Dimensions 27-5/8 in. (702 mm) 26 in. (661 mm) 16 in. (407 mm) 4-1/4 in. (108 mm) 22-5/8 in. (575 mm) 22-7/8 in. (581 mm) 18-5/8 in. (473 mm) 9-1/4 in. (235 mm) 1/2 in.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 20 B. Optional Components RC-ELEC-QUAD Remote Control Remote Control T rim Kits PBT26EA SST26EA PBT26ER SST26ER PBT = Polished Brass T rim SST = Stainless Steel T rim Cabinets Several styles of cabinets are available for use with these heaters.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 21 Fronts DF-26ERA-BK2824 DF-26ESP-BK2824 DF-26ERA-BK4028 DF-26ESP-BK4028 DF-26ERA-BK4432 DF-26ESP-BK4432 Model Description Width Height DF-26ERA-BK2824 Remington Avenue 28 in. 24 in. DF-26ESP-BK2824 Sun Prairie 28 in.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 22 C. Service Parts Exploded Parts Diagram QV26E Service Parts QV26E Beginning Manufacturing Date: 04/04 Ending Manufacturing Date: Active.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 23 Service Parts List QV26E Service Parts QV26E Beginning Manufacturing Date: 04/04 Ending Manufacturing Date: Active # Description of Part QV26E Qty .
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 24 D. Limited W arranty W ARRANTY Hearth & Home T echnologies Inc. (HHT) Electric Fireplaces are tested and inspected prior to shipment and are guaranteed from defect to the purchaser of each new product.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05 25 Hearth & Home T echnologies Inc. 1445 North Highway Coleville, W A 991 14-2124 Please contact your Quadra-Fire dealer with any questions or concerns. For the number of your nearest Quadra-Fire dealer , please call 1-800-926-4356.
An important point after buying a device Hearth and Home Technologies QV26E (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hearth and Home Technologies QV26E yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hearth and Home Technologies QV26E - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hearth and Home Technologies QV26E you will learn all the available features of the product, as well as information on its operation. The information that you get Hearth and Home Technologies QV26E will certainly help you make a decision on the purchase.
If you already are a holder of Hearth and Home Technologies QV26E, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hearth and Home Technologies QV26E.
However, one of the most important roles played by the user manual is to help in solving problems with Hearth and Home Technologies QV26E. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hearth and Home Technologies QV26E along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
