Instruction/ maintenance manual of the product 4065 Harbor Freight Tools
Go to page of 8
.
Page 2 For technical questions, please call 1-800-444-3353. Item 4065 W ARNING SYMBOLS AND DEFINITIONS This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
Page 3 For technical questions, please call 1-800-444-3353. Item 4065 16. Do not allow any lubricants to make contact between any part of the Ball Joint Kit and the part being pressed.
Page 4 For technical questions, please call 1-800-444-3353. Item 4065 T o Install a Ball Joint 1. Clean the vehicle’s control arm, and coat the inside diameter of the control arm with a light lubricant. 2. Insert the replacement ball joint as straight as possible into the vehicle’s control arm.
Page 5 For technical questions, please call 1-800-444-3353. Item 4065 T o Disassemble / Assemble a “U” Joint 1. T o disassemble a “U” joint, remove any external and/or internal lock rings. 2. Position the Ball Joint Press around the drive shaft yoke and tighten the Jackscrew until the first bearing is removed.
Page 6 For technical questions, please call 1-800-444-3353. Item 4065 Cleaning, Maintenance, and Lubrication Do not perform any inspection, maintenance or cleaning procedures with the Ball Joint Kit is under a load. 1. BEFORE EACH USE, inspect the general condition of the Ball Joint Kit.
Page 7 For technical questions, please call 1-800-444-3353. Item 4065 Record Product’ s Serial Number Here: Note: If product has no serial number , record month and year of purchase instead. Note: Some parts are listed and shown for illustration purposes only , and are not available individually as replacement parts.
3491 Mission Oaks Blvd., ● P . O. Box 6009 ● Camarillo, CA 9301 1 ● (800) 444-3353.
An important point after buying a device Harbor Freight Tools 4065 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Harbor Freight Tools 4065 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Harbor Freight Tools 4065 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Harbor Freight Tools 4065 you will learn all the available features of the product, as well as information on its operation. The information that you get Harbor Freight Tools 4065 will certainly help you make a decision on the purchase.
If you already are a holder of Harbor Freight Tools 4065, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Harbor Freight Tools 4065.
However, one of the most important roles played by the user manual is to help in solving problems with Harbor Freight Tools 4065. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Harbor Freight Tools 4065 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
