Instruction/ maintenance manual of the product GDZ5-1C Haier
Go to page of 24
Quality ■ Innovation ■ Style Fr ont Load Electric Dryer Seche-linge Electrique Chargement de Devant User Manual Model # GDZ5-1C Guide de l’Utilisateur Modéle # GDZ5-1C.
IMPOR T ANT SAFETY INSTRUCTIONS Wa r ning – To r educe the risk of fir e, electric shock, or injury to persons when using your appliance, follow basic precautions, including the following: 1.
15. If material has been used with any flammable liquids or solids it should not be used in the dryer until all traces of the flammable liquids and its fumes have been removed. 16. This dryer must be pr operly installed in accordance with the installation instructions before it is used.
3 English As dry cleaning solvents, gasoline, vegetable and cooking oils are highly hazardous materials, items soaked in or spotted with such should not be used in the dryer . Items may still contain a substantial amount of the hazardous material after being washed.
4 English T ABLE OF CONTENTS P AGE SAFETY INSTRUCTIONS .......................................................................... 1 OPERA TING INSTRUCTIONS .................................................................... 5 Features ...............
Dryer Timer: • Dryer Timer: The timer will let you set the time for up to 120 minutes to dry your clothes depending on the fabric type and load size. • Cotton/Synthetic Dry Button Setting: In order to dry COTTON clothes push button in its outward position.
6 English • Cotton Cycle: This can be either HIGH or LOW heat dry cycle depending on what type of clothes you want to dry for up to 120 minutes. • Synthetic Cycle: This cycle is used for synthetic fabrics where you can use dry time up to 60 minutes at low heat setting.
7 English Please follow the chart below for proper cycle/time/clothes selections. CYCLE TYPE Cotton Cycle Synthetic Cycle Synthetic Cycle Delicate Cycle Note: Cotton Cycle is also known as Regular Cyc.
8 English Start Button: • Once you have made your selection of the cycle, time and heat setting, you need to push start button to turn the power on. Y ou will see the power light comes on indicating that power is on.
Synthetic Light: • Y ou must have synthetic button in its inward position in order to have the light "ON". When cycle is about to finish and goes in cool dry at the end, you will notice that the light will go "OFF". Note: If the light does not come on then check the position of synthetic button.
10 English Lint Filter: • It is located on middle-front behind door . The filters slides out easily for cleaning. • It is ok to wash the lint filter with water and/or soap.
11 English 1. Sort clothes for drying. Separate dark and light colored items, like you do for washing. Check for stains that have not been removed in washing. Dryer heat may permanently set some stains. Properly dried clothes will need minimum of care when r emoved from dryer .
12 English Drying Tips Note: The average load will fill drum 1 /3 to 1 /2 full. Clothes will need room to tumble freely for even drying and less wrinkling. If you overload the dryer , you may cause damage to motor because it will not handle overloads and the dryer may not start at all.
English 13 • Lint filter needs to be cleaned before and after each use for your unit to operate at optimum efficiency . The filter can be slid out, by pulling on the tab located on the inside of the dryer door . The filter may be washed or vacummed.
Dryer does not operate: • Check if unit is plugged in. The plug may have come loose. • Check if the electrical wall receptacle is of pr oper voltage. • Check if the circuit br eaker needs to be reset or if the fuse needs to be r eplaced. • Check if the unit is in “Off” mode.
English 15 It is your responsibility • T o connect a qualified electrical installer . • T o be sure that the electrical connection is adequate and in conformance with CAN1-B149 (.1 or .2) installation codes and/or local codes. • A 4 wire, single phase, 115/230-volt, 60-Hz.
Replacement Power Supply Cord must be: • UL Listed or CSA Interantional Certified • Marked for use with clothes dryers • Rated 115/230 volt minimum • 30 amp • T ype SRD or SRDT • 4 Conductors • At least 5 ft (1.52 m) long. Grounding Instructions • For a grounded, cor d-connected dryer: This dryer must be grounded.
17 English • Select a suitable location for the dryer on a hard even surface away fr om direct sunlight or heat sour ce e.g. radiators, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with the leveling legs located on the bottom of the dryer .
The following are specific r equirements for pr oper and safe operation of your dryer . Failure to follow these instructions can cr e- ate excessive drying times and fire hazar ds. W ARNING 1. Do not use plastic flexible duct to exhaust the dryer . Excessive lint can build up inside exhaust system and create a fir e hazard and r estrict air flow .
19 English Materials INST ALL MALE FITTINGS IN THE CORRECT DIRECTION Use only 4 inch (10.2 cm) diameter (minimum) rigid or flexible metal duct and approved vent hood which has a swing-out damper hat open when the dryer is in operation. When the dryer stops, the dampers automatically close to prevent drafts and the entrance of insects and rodents.
English After installation is completed, the following method must be used to determine if the exhaust system is acceptable: 1. Connect an inclined or digital manometer between the dryer and the point the exhaust connects to the dryer . 2. Set the dryer timer and temperature to air fluf f (cool down) and start the dryer .
21 English Do Not Install Y our Dryer: • In an area exposed to dripping water or outside weather conditions. • In an area wher e it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion and ventilation air .
English • Dryer must be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 inches (10.
Made in China Fabriqué en Chine Haier America New Y ork, NY 10018 Printed in China GDZ5-1C-01 Issued: April 05 IMPOR T ANT Do Not Return This Product T o The Store If you have a problem with this product, please contact the "Haier Customer Satisfaction Center" at 1-877-337-3639.
An important point after buying a device Haier GDZ5-1C (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Haier GDZ5-1C yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Haier GDZ5-1C - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Haier GDZ5-1C you will learn all the available features of the product, as well as information on its operation. The information that you get Haier GDZ5-1C will certainly help you make a decision on the purchase.
If you already are a holder of Haier GDZ5-1C, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Haier GDZ5-1C.
However, one of the most important roles played by the user manual is to help in solving problems with Haier GDZ5-1C. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Haier GDZ5-1C along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
