Instruction/ maintenance manual of the product DW12-TFE3S Haier
Go to page of 28
DW12-TFE3 DW12-TFE3S DW12-TFE3ME DW12-TFE3SS Code:0120500380A.
.
EN Index Disposal The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
EN Safety information At time of delivery Check packaging and dishwasher immediately for signs of transport damage. If the appliance is dam- aged, do not put it into use but contact your supplier or customer service without delay. Please dispose of packaging materials properly.
EN If your family includes children This appliance is not intended for use by persons (including children) with reduced physical,sensory or mental capcabilities, or lack of experience and knowledge,unless they have been given supervi- sion or instruction concerning use of the appliance by a person responsible for their safety.
EN Positioning the appliance Positioning the appliance in the desired location. The back of the appliance should rest against the wall, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation.
EN Electrical Connection After making sure that the voltage and frequency values for the current in the home correspond to those on the rating plate (located on the stainless steel inner door of the a.
EN Getting to know your dishwasher Close-up view (control panel) "1/2" Indicator Low Salt Indicator Time-remaining Indicator F G H I J A B C D E State Indicator ON-OFF Button Delayed Start B.
EN 7 Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
EN 8 How to fill rinse aid Important Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot- ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting.
EN 4 3 How to fill the detergent dispenser Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle fol- lowing the instructions provided in the "Programme overview".
EN Not suitable for the dishwasher What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher.
EN Arranging crockery, glasses, etc. in the dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from be- coming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed.
EN The upper rack is designed to hold more delicate and lighter dishware, such as glasses, cups and saucers, plates, small bowls and shallow pans (as long as they are not too dirty). How to use the upper rack fig.G fig.F Shelf Lean tall glasses and those with long stems against the shelf- not against other items to be washed.
EN Programme overview Wash programme Type of crokery e.g. china, pots/ pans, cutlery, glasses, etc Amount of food remains Description of cycle Condi- tion of food remains Pre-wash with warm water. Extended wash at 70°C. Rinses with cold water. Rinse with hot water.
EN Delayed Start Detergent Extended Wash Prewash Rinse Aid Duration in minutes Energy consump- tion in kWh Water consump- tion in litres Laboratory measured valve in accordance with European Standard EN50242 5g 5g 5g 25g 25g 25g 112 94 102 90 162 140 92 82 32 54 12 15g 15g 14 12 28 48 5g 25g 5g 25g 5g 25g 10g 10g 1.
EN Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.
EN End of programme Interrupting the programme Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. When you open the door, the dishwasher will beep ten times every thirty seconds.
EN After 3 seconds the delayed start indicator “ E ” blinks, the time-remaining indicator “ G ” will blink and decrease , the programme will start until the delayed start indicator “ G ” goes out .
EN How to keep your dishwasher in shape After Every Wash After every wash, turn off the water supply the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, always switch off the remove the plug from the socket.
EN Care and maintenance Dishwasher salt Check the LOW SALT indicator “ I ”. Top up with salt, if required. Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher from time to time.
EN Inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm “ 10 ” upwards and lift it off. Unscrew the upper spray arm “ 9 ”. Clean both spray arms under running water. Refit the spray arms.
EN When the buzzer emits 10 short warning signal every 30 seconds and the time-remaining indicator display "E3" Have you checked whether: the drain hose is too low.
EN If you take all these checks and the dishwasher still does not function or your dish- washer have any other error display, you can power the dishwasher OFF, and wait a few minutes.
EN Water remains inside appliance after programme has ended Blockage or kind in drainage hose. Pump is jammed. Filters are blocked. The programme is still running. Wait for the programme to end . ...during washing Unusual amount of foam is creased Normal washing up liquid has been poured into the rinse-aid container.
EN Not enough detergent was added to dispenser. Detergent has insuffcient bleaching properties. Use a detergent containing a chemical bleaching agent. Plastic items are discoloured Not enough detergent was added to dispenser compartment. Amount of rinse-aid was set too low.
EN Technical data 12 standard place settings Width Depth Height Capacity Mains water pressure Power voltage Total absorbed power 60 cm 60 cm 85 cm See nameplate See nameplate See nameplate Fuse 13A Important information Notes on waste disposal Old appliances still have some residual value.
EN General information Measures must be taken to ensure that built-under and built-in units that are subsequently re-sited as free-standing appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface which is screwed to the adjacent cupboards.
An important point after buying a device Haier DW12-TFE3S (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Haier DW12-TFE3S yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Haier DW12-TFE3S - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Haier DW12-TFE3S you will learn all the available features of the product, as well as information on its operation. The information that you get Haier DW12-TFE3S will certainly help you make a decision on the purchase.
If you already are a holder of Haier DW12-TFE3S, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Haier DW12-TFE3S.
However, one of the most important roles played by the user manual is to help in solving problems with Haier DW12-TFE3S. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Haier DW12-TFE3S along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
