Instruction/ maintenance manual of the product RFS11 Amana
Go to page of 16
Commercial Microwave Oven Owner's Manual RFS9* RFS1 1* * Additional alphanumeric characters representing other models in the series may follow each model number . Keep these instructions for future reference. If the oven changes ownership, be sure this manual accompanies oven.
2 Model Identification Complete enclosed registration card and promptly return. If registration card is missing, call Consumer Affairs Department at 1-800-843-0304 inside U.S.A. 1-319-622-551 1 outside U.S.A. When contacting Amana, provide product information.
3 SA VE THESE INSTRUCTIONS 1. READ all instructions before using equipment. 2. READ AND FOLLOW the specific “PRECAUTIONS TO A VOID POSSIBLE EXPOSURE TO EXCESSIVE MICROW A VE ENERGY” on page 4. 3. This equipment MUST BE GROUNDED . Connect only to properly GROUNDED outlet.
4 SA VE THESE INSTRUCTIONS 1. Briskly stir or pour liquids before heating with microwave energy to prevent spontaneous boiling or eruption. Do not overheat. If air is not mixed into a liquid, liquid can erupt in oven or after removal from oven. 2. Do not deep fat fry in oven.
5 Unpacking Equipment • Inspect equipment for damage such as dents in door or dents inside oven cavity . • Report any dents or breakage to source of purchase immediately . Do not attempt to use oven if damaged. • Remove all materials from oven interior .
6 TIME ENTRY Use to enter heating time without changing preprogrammed number pads. Pads 1-0 Use to begin heating with preprogrammed times or to enter times for “Manual Time Entry” cooking. ST AR T Use to start “Manual Time Entry” program or restart interrupted cooking cycle.
7 • Shows after oven is plugged in. Open oven door to clear . REA DY • “READY”—Indicates pads will accept entry . Shows when oven is paused or ready for next entry . POW ER 88:88 • “88:88”—Shows heating time. • “POWER”—Shows when oven generates microwave energy .
8 Operating Preprogrammed Pads Equipment has 10 preprogrammed number pads. Instructions are written for factory programmed ovens. Ovens that are reprogrammed can respond differently than described below . 1. Open oven door , place food in oven, and close oven door .
9 Preprogrammed Number Pads 1. Open oven door . • Fan and light operate. • If door i s c l osed or RESET pad is pressed before finishing programming sequence, oven exits programming mode. 2. Press and hold pad 1 for approximately 15 seconds. • After 15 seconds, signal sounds.
10 User Options 1. Open oven door . • If door is closed or RESET pad is pressed before finishing programming sequence, oven exits programming mode. 2. Press and hold pad 1 for approximately 15 seconds. • After 15 seconds, signal sounds. Display shows “P”.
11 Record all inspections and repairs for future reference. Changing Oven Light Bulb T ools and Bulb • Protective gloves • Standard screwdriver • Light bulb rated 1 15-125 volt, 40 watt 1. Unplug oven. 2. Remove screw from back of oven and remove access cover .
12 Cleaning Discharge Air V ents Check for a buildup of cooking vapors along discharge louvers in back of oven monthly . Clean air vent with damp cloth to ensure proper airflow . Dry thoroughly . Air v ents T o avoid overheating and oven damage, clean air filter regularly .
13 W arranties COMMERCIAL MICROW A VE OVEN FULL THREE YEAR W ARRANTY Amana Appliances warrants this product when the original purchaser uses the oven for commercial food service preparation. FIRST THRU THIRD YEAR Amana Appliances will repair or replace, including related labor and travel, any part (F .
14 COMMERCIAL MICROW A VE OVEN FULL ONE YEAR W ARRANTY LIMITED THREE YEAR W ARRANTY Amana Appliances warrants this product when the original purchaser uses the oven for commercial food service preparation. FIRST YEAR Amana Appliances will repair or replace, including related labor and travel, any part (F .
15 Before Calling for Service If oven does not operate: • Confirm oven is plugged into dedicated circuit. • Confirm oven is on grounded and polarized circuit. (Contact electrician to confirm.) • Check fuse or circuit breaker . If oven light does not work: • Confirm light bulb is screwed in tightly .
Part No.12392603 Printed in U.S.A. 10/97 Amana Appliances Amana, Iowa 52204 Quick Reference Instructions Read “Important Safety Information” before using “Quick Reference Instructions”. If there are unanswered questions, see detailed sections of this manual.
An important point after buying a device Amana RFS11 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Amana RFS11 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Amana RFS11 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Amana RFS11 you will learn all the available features of the product, as well as information on its operation. The information that you get Amana RFS11 will certainly help you make a decision on the purchase.
If you already are a holder of Amana RFS11, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Amana RFS11.
However, one of the most important roles played by the user manual is to help in solving problems with Amana RFS11. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Amana RFS11 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
