Instruction/ maintenance manual of the product ZICP720 GE
Go to page of 20
Installation Instructions Professional Style Bottom-Freezer Refrigerators ZICP720 Design Guide With Installation Instructions monogram.com.
Safety Information 2 BEFORE YOU BEGIN Read these instructions completely and carefully. • IMP OR T ANT — Save these instructions for local inspector ’s use. Observe all governing codes and ordinances. • Not e to Installer — Be sure to leave these instructions with the Consumer .
DIMENSIONS AND CLE ARANCES Product Clearances These refrigerators are equipped with a 2-position door stop. The factory set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted. Allow 25 ″ minimum clearance for a full 130° door swing.
1/4" 1/2" 3/4" 1" 1-1/4" 1" 3/4" Overlay Panel (Nominal Size) Stainless Steel 1/4" 1/2" 3/4" 2" 1-1/4" 1-1/2" 1-3/4" 3" 2-1/4.
1/4" 1/2" 3/4" 1" 1-1/4" 1/4" 1/2" 3/4" 1" 1-1/4" 1-1/2" 23-7/8" From Rear of Refrigerator 3/4" Overlay Panel (Nominal Size) Case T rim.
T OOLS REQUIRED • Tinsnips to cut banding • Stepladder • Bucket • Level • Appliance dolly • T ubing cutter • 7/16 ″ open-end wrench • #2 Phillips screwdriver • Drill and appropriat.
7 Installation Instructions REMOVE P A CKA GING CA UTION: Refrigerator is much heavier at the top than at the bottom—be careful when moving. When using a hand truck, handle from side only. PRUDENCE : Le réfrigérateur est beaucoup plus lourd en haut qu'en bas.
INST ALL SIDE P ANELS Side panels must be used whenever the sides of the refrigerator will be exposed. The 1/4 ″ side panels will slip into the side case trim. Secure the panels to the refrigerator with stick-on hook and loop fastener strips. Order the side panels from the cabinet manufacturer .
INST ALL ANTI-TIP BRACKETS W ARNING: ANTI-TIP PRECAUTIONS These refrigerators are top-heavy and must be secured to prevent the possibility of tipping forward.
P OSITION REFRIGERA TOR AND INST ALL TOP TRIM • Before pushing the refrigerators into the opening, plug the power cords into the receptacles. Reach into the top opening to grasp the power cord. Pull the power cord into the opening as you push the refrigerator back .
11 Installation Instructions LEVEL THE REFRIGERA T ORS Place a level inside the machine for each unit . Both refrigerators MUST BE LE VEL AND PLUMB with each other and with adjacent cabinetry on each side. Drawers should be evenly aligned. Both refrigerators have 4-point leveling.
12 Installation Instructions SECURE REFRIGERA T OR TO CABINE TRY Whenever possible, perform this step for anti-tip security, or when anti-tip brackets cannot be used. The refrigerator must be secured to prevent tipping . • Drill hole in trim and drive screw through the trim into adjacent cabinet .
INST ALL CENTER TRIM STRIP • Open doors fully. • The case trims should be evenly aligned top to bottom with a slight gap between them. • Starting at the top, press center trim strip (D) over the inside case trims of both refrigerators. • Continue pressing trim until you reach the bottom of the case trims.
14 Installation Instructions CHECK AND CORRECT DOOR ALIGNMENT 13 • Close the grille panel and both doors. • Check that the freezer drawers and bottom of door s are horizontal and even at the lower inside corners. • Carefully measure the inside corners to determine if an adjustment is needed.
CHECK AND CORRECT DOOR ALIGNMENT (cont .) 13 CA UTION: Follow instructions very caref ully. PRUDENCE : Suivez les instructions très soigneusement . DETERMINE CORRECT SP ACER This kit contains 12 plastic spacers (2 of each size). Match spacer to illustration below to be sure you have selected the correct size as determined in the char ts below .
16 Installation Instructions CHECK AND CORRECT DOOR ALIGNMENT (cont .) 13 1. Open the grille panel. 2. Remove 4 screws on the hinge plate. 3. Use pliers to remove door stop pin. 4. Lift door off bottom hinge pin. The door must be held in place while spacers are being exchanged.
INST ALL GRILLE BASE WRAP • Open doors fully. Open the grille panel. • Install the unified double width grille base wrap (E) by slipping the notched ends over the door hinges.
18 Installation Instructions CONNECT P OWER • Check to be sure the power cord is plugged into the receptacle. • Check to make sure power to refrigerator is on by opening refrigerator door to see if interior lights are on. • The temperature controls are preset at 37°F for the fresh food section and 0°F for the freezer .
19 Notes.
49-60469-2 224D1234P001 09-07 JR Printed in the United States NOTE: While performing installations described in this book, safety glasses or goggles should be worn. If your Monogram appliance should ever require service, you can depend on Monogram Preferred Ser vice.
An important point after buying a device GE ZICP720 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought GE ZICP720 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data GE ZICP720 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, GE ZICP720 you will learn all the available features of the product, as well as information on its operation. The information that you get GE ZICP720 will certainly help you make a decision on the purchase.
If you already are a holder of GE ZICP720, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime GE ZICP720.
However, one of the most important roles played by the user manual is to help in solving problems with GE ZICP720. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device GE ZICP720 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
