Instruction/ maintenance manual of the product TINSEA530JBRZ GE
Go to page of 24
TINSEA530JBRZ 49-7592-1 10-08 JR Air Con di t i o n ers Safety Instr uctions . . . . . . . . . . . . .2 Operating Instr uctions Air Direction . . . . . . . . . . . . . . . . . .4 Auxiliary Controls . . . . . . . . . . . .5–8 Controls . . . . . . . .
Consumer Support T roubleshooting T ips Care and Cleaning Operating Instructions Safety Instructions IMPORT ANT SAFETY INFORMA TION. READ ALL INSTRUCTIONS BEFORE USING.
Safety Instructions Operating Instructions Care and Cleaning T roubleshooting T ips Consumer Support About Y our Heat Pump (3900 Series only) Heat pumps can save money by removing heat from the outside air—even when the outside temperature is below freezing— and releasing that heat indoors.
Consumer Support T roubleshooting T ips Care and Cleaning Operating Instructions Safety Instructions V entilation Control The ventilation control lever is located at the upper left side of the Zoneline unit, behind the room cabinet. When set at the closed position, only the air inside the room is circulated and filtered.
Auxiliary Controls on your Zoneline. ge.com Auxiliary Controls—Dip Switches The auxiliary dip switch controls are located behind the room cabinet, through an opening in the control panel. Remove the room cabinet. See the T o Remove the Room Cabinet section.
6 Auxiliary controls on your Zoneline. Load Shedding (Central Desk Control) This feature is active only if the unit is in CDC mode. When this switch is enabled (UP) , the indoor fan can be turned ON or OFF with the unit controls. Freeze Sentinel When this switch is enabled (UP) , it turns OFF the freeze sentinel protection feature.
7 ge.com Safety Instructions Operating Instructions Care and Cleaning T roubleshooting T ips Consumer Support Heat Sentinel When this switch is enabled (UP) , it turns ON the heat sentinel protection feature. With the switch disabled (DOWN) , the heat sentinel is de-activated.
8 Consumer Support T roubleshooting T ips Care and Cleaning Operating Instructions Safety Instructions Auxiliary controls on your Zoneline. External Fan (Obtained locally) When connected, an auxiliary or external fan can be controlled with the indoor fan motor on the Zoneline.
Care and cleaning. Base Pan In some installations, dirt or other debris may be blown into the unit from the outside and settle in the base pan (the bottom of the unit). In some areas of the United States, a “gel-like” or “slime-like” substance may be seen in the base pan.
Consumer Support T roubleshooting T ips Care and Cleaning Operating Instructions Safety Instructions 10 T o maintain optimum performance, clean the filters at least every 30 days. Air Filters T urn the Zoneline off before cleaning. The most important thing you can do to maintain the Zoneline is to clean the filter at least every 30 days.
BEFORE YOU BEGIN Installation Zoneline Air Instructions Conditioners Read these instr uctions completely and carefully . • IMPORT ANT – Save these instructions for local inspector’ s use. • IMPORT ANT – Observe all governing codes and ordinances.
12 Installation Instructions Use the cor rect wall case T hi s u ni t is designed to be installed in a GE plastic or insulated metal wall case. This minimizes condensation from forming on the room side of the case.
Installation Instructions HOW TO CONNECT ELECTRICAL SUBBASE CONNECTION 1 Remove the room cabinet. 2 Connect to electrical power . 3 Review the following steps for applicable supply voltages. 4 Reinstall the room cabinet. T andem 15 Amp. 230/208-volt receptacle configuration.
14 Installation Instructions 265 VOL T ELECTRICAL CONNECTION OPTIONS W ARNING: Connection of this 265 V AC product to a branch circuit MUST be done by direct connection in accordance with the National Electrical Code. Plugging this unit into a building mounted exposed receptacle is not permitted by code.
Installation Instructions MAKE ELECTRICAL CONNECTION TO THE UNIT REINST ALL JUNCTION BOX • Reinstall the junction box by engaging the left tabs on the lower right face of the unit, aligning the screw holes at the top and bottom and driving the two screws until secure.
Installation Instructions 16 POWER CONNECTION CHAR T 230/208 V olt Power Supply Kits with Cur rent Leakage W all Plug Heater W attage Detection Device Configuration Circuit Pr otective Device @ 230/208 V olts RAK3153 T andem 15-Amp Time-Delay Fuse or Breaker 2.
Installation Instructions 17 INST ALL THE W ALL CASE AND EXTERIOR GRILLE The RAB71 series or RAB77 wall case must be properly installed per instructions packed with the case. • Remove the corrugated stiffener and the outdoor protective panel. Use the slit in the outdoor panel as a handhold and push out.
INST ALL THE UNIT INTO THE W ALL CASE Slide the unit into the wall case and secure with four screws through the unit flange holes. 3 REPLACE THE ROOM CABINET Reinstall the room cabinet by hooking the top over the rail along the unit top (1), then pushing it in at the bottom (2).
Installation Instructions 19 OPTIONAL—DRAIN KIT INST ALLA TION Dr y Air 25 Series models are designed to improve dehumidification by 25%. Since more moisture will be r emoved from the air , there is a greater possibility that water will drip from the wall case than with a standard unit.
20 Before you call for service… Consumer Support T roubleshooting T ips Care and Cleaning Operating Instructions Safety Instructions T roubleshooting T ips Save time and money! Review the charts on the following pages first and you may not need to call for service.
Problem Possible Causes What T o Do The air is not always The heat pump is not • This is normal. The heat pump will produce warm air cool or hot during producing hot air . but not as hot as air produced when the higher -cost operation electric heat is used.
22 Normal Operating Sounds Y ou may hear a pinging noise caused by water being picked up and thrown against the condenser on rainy days or when the humidity is high. This design feature helps remove moisture and improve efficiency . Y ou may hear relays click when the controls cycle on and off or are adjusted to change the room temperature.
Safety Instructions Operating Instructions Care and Cleaning T roubleshooting T ips Consumer Support Zoneline W arranty . For The Period Of: GE Will Replace: One Y ear Any part of the Zoneline which fails due to a defect in materials or workmanship.
Printed in China Consumer Support. GE Appliances W ebsite ge.com Have a question or need assistance with your appliance? T ry the GE Appliances W ebsite 24 hours a day , any day of the year! For greater convenience and faster service, you can now download Owner’s Manuals, order parts or even schedule service on-line.
An important point after buying a device GE TINSEA530JBRZ (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought GE TINSEA530JBRZ yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data GE TINSEA530JBRZ - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, GE TINSEA530JBRZ you will learn all the available features of the product, as well as information on its operation. The information that you get GE TINSEA530JBRZ will certainly help you make a decision on the purchase.
If you already are a holder of GE TINSEA530JBRZ, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime GE TINSEA530JBRZ.
However, one of the most important roles played by the user manual is to help in solving problems with GE TINSEA530JBRZ. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device GE TINSEA530JBRZ along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
