Instruction/ maintenance manual of the product ZEM200WV GE Monogram
Go to page of 16
GE Monogram ® Installation Instr uctions Under Cabinet Installation and JX827WN Built-In Kit Microwave Oven Model ZEM200WV.
Before you begin—Read these instructions completely and carefully . IMPORT ANT: Save these instr uctions for local inspector’ s use. IMPORT ANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INST ALLER: Be sure to leave these instructions with the Consumer .
Design Infor mation Micr owav e Oven Wall Cutout ZEM200WN 3 Designed for versatility , this Monogram microwave oven adapts to virtually any installation.
Installation Preparation Microwave Oven 4 ZEM200WV In-wall installation Note: When installed, trim kit will require wall space 26-1/8" W x 16 -1/4" H for clearance. Within opening of appropriate dimensions: • Install a level base of plywood: – Flush with lower edge of opening.
Refer to diagram at right for dimensions when installing ZEM200WV above a Monogram single oven. ZEM200WV With single oven Within opening of appropriate dimensions: • Install a level base of plywood: – Flush with lower edge of opening. – Entirely covering floor of opening.
Installation Preparation Micr owave Oven T ools and materials required: • 3-prong grounded electrical receptacle. • Electrical cable, 2-wire with ground, No. 14 minimum, as required. Monogram microwave ovens require a 120 volt, 60 Hz power supply , protected by a time delay fuse or circuit breaker .
ZEM200WV In-wall installation (continued) ZEM200WV Under-cabinet mounting Installation Preparation Micr owav e Oven • When cabinet depth is a critical factor , receptacle should be installed in a side wall at rear of opening: – 14 -5 /8" minimum cabinet depth is requir ed.
JX827WN installation Installation Micr owav e Oven T ools and materials required: • Accessory kit JX827WN for in-wall installation of ZEM200WV • 2 Phillips head screwdrivers (#1 & #2) •Drill and 3/32" drill bit • Centerpunch or nail • Pencil and ruler JX827WN Parts List 1.
JX827WN installation Installation Micr owav e Oven Note: Do not tighten screws until all screws are started. • Install side cover by inser ting between oven and base pan. • Star t two screws A, through side cover and two screws E, through the cover on top into holes where buttons were removed.
10 Installation Micr owav e Oven JX827WN installation • Install rear duct by inser ting into bottom flange between the oven and back of base pan. – The rear duct should be as far to the left as possible, between the base pan back flange and the partition on the right side.
11 Assemble trim kit frame Install trim kit frame • Assemble top, bottom and side trims with four screws D, as illustrated. When assembled, top, bottom and side strips must be flush. Note: Bottom trim has a hinge notch and is not interchangable with top trim.
12 15 13/32" Template 1 / 3 4 / 1 2 / 1 4 Template 2 Installation Micr owav e Oven ZEM200WV Under-cabinet mounting T ools and materials required: • Flat-blade screwdriver • Phillips screwdriv.
13 Installation Microwave Oven – Position remaining piece of T emplate 2 inside cabinet and align hole center line with ar rows on T emplate 1. – Cut excess paper from center of T emplate 2 so it will lie flat. – Distance from right hole center to left hole center should measure distance indicated on template.
14 Finalize under-cabinet installation 13/16" Installation Micr owav e Oven • W ith template secured in place, check again that hole center lines on T emplate 2 are straight, and that distance from right to left hole center measures distance shown on template.
15 Notes Microwave Ovens.
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. T o obtain specific information concerning any Monogram product or service, call GE Answer Center ® consumer information service at 800.626.2000—any time, day or night.
An important point after buying a device GE Monogram ZEM200WV (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought GE Monogram ZEM200WV yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data GE Monogram ZEM200WV - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, GE Monogram ZEM200WV you will learn all the available features of the product, as well as information on its operation. The information that you get GE Monogram ZEM200WV will certainly help you make a decision on the purchase.
If you already are a holder of GE Monogram ZEM200WV, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime GE Monogram ZEM200WV.
However, one of the most important roles played by the user manual is to help in solving problems with GE Monogram ZEM200WV. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device GE Monogram ZEM200WV along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
