Instruction/ maintenance manual of the product JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635 GE
Go to page of 12
Use and Care of Recirculation Hood Models JN322, JN334, JN335, JMW, & JN635 and Ventilating Hood Models JV322, JV324, JV332, JV334, JV335, JV624, JV634, & JV635 — IMPORTANT SAFETY C. When cutting or drilling into wall or ceiling, INSTRUCTIONS do not damage electrical wiring and other hidden utilities.
2 If You Need Service... ● Do not attempt to repair or replace any part of 1 your hood unless it is speciikxdly recommended in this book. All other servicing should be referred to a qualified technician. ● Disconnect hood circuit breaker or fuse before performing any service.
To Operate —Vents (“JN” models only) Lamp switch Fan switch Trim Lamp Switch Models: JN322, JV322 & JV332 Press for OFF and ON. Lamp Stitch All other models. CENTER position OFF, LE~ position NIGHT LIGHT, RIGHT position BRIGHT LIGHT. Fan Switch CENTER position OFF, LEFT position LOW SPEED, RIGHT position HIGH SPEED.
Installation Instructions for General Electric Hood Models: JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635 Important-save for the local electrical inspector% use Power supply connection box on underside of hood.
1. PREPARATION OF WALL CABINET AND WALL FLUSH OR RECESSED BOITOM CABINET NOTE: For easier installation make all hood and vent cutouts in the cabinet and wall before cabinet is permanently fastened in place. It is recommended that the power supply be brought into the hood from the wall below the cabinet as shown in Fig.
2. DUCT INSTALLATION T@e “B” Models: See Figs. 4 and 9. The hood exhaust has been designed to mate with standard 7“ round duct. (A round damper kit may be ordered. Order GE model number JXDA22.)* A. If a rectangular duct is desired, a round-to-rectangular adapter must be used.
3. POWER SUPPLY A. CIRCUIT VOLTAGE: This hood must be connected to a supply circuit of the proper voltage and frequency as specified on the rating plate. Wire size must conform to the requirements of the National Electrical Code or the prevailing local code for hoods of this rating.
IMPORTANT: After installation, peel off the transparent protective film stripping from the decorative trim on the front of the hood. (See Fig. 12.) B. ELECTRICAL CONNECTION 1. Be sure the power supply is disconnected before making electrical connections.
Lamp Replacement Remove the lamp and replace with an ordinary screw- base lamp bulb NOT MORE THAN 60 WATTS. Models JN334, JN335, JN634, To remove the lamp cover, if desired: JN635, JV324, JV334, JV335, ● Press the sides with 2 fingers until the side prongs JV624, JV634, JV635 have a are released.
Questions? Use This Problem Solver PROBLEM POSSIBLE CAUSE FAN DOES NOT ● A fuse may be blown or a circuit breaker tripped. Replace fuse or reset circuit breaker. OPERATE WHEN THE SWITCH IS ON FAN FAILS TO . Fan blade striking the hcmd sheI1. CIRCULATE AIR s Excessively soiled filter should be checked and corrected before using the hood again.
Help Us Help You... Write down the model and serial numbers. You’ll find them on a label on the back wall of the hood. These numbers are also on the Consumer Product Ownership Registration Card that came with your hood.
YOUR RANGE HOOD Staple sales slip or cancelled check WARRANTY here. Proof of original purchase date is needed to obtain service I — under warranty. WHAT IS COVERED FULL ONE-YEAR WARRANTY For one yea.
An important point after buying a device GE JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought GE JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data GE JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, GE JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635 you will learn all the available features of the product, as well as information on its operation. The information that you get GE JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635 will certainly help you make a decision on the purchase.
If you already are a holder of GE JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime GE JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635.
However, one of the most important roles played by the user manual is to help in solving problems with GE JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device GE JN322, JN334, JN335, JN634, JN635, JV322, JV324, JV332, JV334, JV335, JV624, JV634, JV635 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
