Instruction/ maintenance manual of the product Monogram ZIC360N LH GE
Go to page of 20
Installation Instructions ZIC360N RH, ZIC360N LH, ZICS360N RH, ZICS360N LH Built-In Bottom-Freezer Refrigerators Design 6uide With Installation Instructions Monogram:.
Safety Information BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - hese instructions for h)cal inspector's use. Obserxe all goxerning codes and ordinances. • Note to Installer -- Be sure to leaxe these instructions with the (:onsmner.
Design Guide THE INSTALLATION SPACE 35-I/2" Finished Width The linished _1_ Wal,View .to.t width /llg 2-8/1B'' mustbe /11 _T ,, / I m :8 maxL 10 84-1/ ]] 75" From 83-1/2" min .
Design Guide Refrigerator Top View 130 ° DOOR SWING (factory setting) Scale 1:1 23-7/8" From Rear of Refrigerator Case Trim Door Frameless Cabinets: The case trim overlaps cabinets at the top and sides. Therefore, frameless cabinets may require filler strips to prevent interference with cabinet door swing.
Design Guide Refrigerator Top View 90 ° DOOR SWING (optional setting) Scale 1:1 Door Case Trim Frameless Cabinets: The case trim overlaps cabinets atthe top and sides. Therefore, frameless cabinets may require filler strips to prevent interference with cabinet door swing.
Design Guide CUSTOMIZATION BASICS: Framed Or Overlay Panels, Custom Handles and Accessory Kits Models Available Stainless Steel Wrapped Models: ZICS360N RH (right-handed door) ZICS360N I,H (leli-hande.
Design Guide 1/4" FRAMED PANEL DIMENSIONS If you choose to install framed panels, they must be cut to tile dimensions shown. Tile panels will slide into tile frame on tile door, drawer and ,rille.
Design Guide SIDE PANELS Side panels must be used whenever the sides of the refrigerator will be exposed. The 1/4" side panels will slip into the side case trim. Secure the panels to the refrigerator with stick-on hook and loop fastener strips. Order the side panels fl'om the cabinet I11[I n 11{;I ct t II'eI'.
Installation Instructions TOOLS REQUIRED • Tinsnips to cut banding • Stepladder • Bucket • i,evel • Appliance Hand T_uck • Tubing cutter • 7/16" open-end wrench • #9 Phillips scre.
Installation Instructions [STEP 1] REMOVE PACKAGING CAUTIO N: Refrigerator is much hea, ier at the top than at the botton/- be careflll when moxing. X,_ hen usim* a hand track, handle fl'om side onE. PRUDENCE: Ce est pl.s hmrd en haut qu'en bas.
Installation Instructions [STEP 21(continued} • Turn on the main water supply and flush debris. Run about a quml ot water through the robing into a bucket. Shut off water supply at the shut-offvalve. NOTE: Saddle type shut-off ;flves are included in many wamr supply kits.
Installation Instructions [STEP 5] LEVEL REFRIGERATOR All models have 4-point leveling. The front is supported by leveling legs, the rear is supported by a_!justable wheels.
Installation Instructions [STEP 7] ADJUST DOOR SWING NOTE: This refiigerator has a 2-position door stop. When space does not allow the door to swing open fldlv to 130 °, you may change the door swing to a 90 ° opening. Skip this step if door opening is satisfactory for your installation situation.
Installation Instructions I STEP 91 INSTALL FRAMED PANELS Right hmad models shown. Use the same instructions for left hand models. IF YOU ARE INSTALLING OVERLAY PANELS, GO TO STEP 9A. UseFrontHoles to Secure Trim Use RearHoles to Secure Handle Handle Trim j Door Trim Refrigerator Door Standard supplied handleshown in 1/4" panel position.
Installation Instructions [STEP 9A] INSTALL OVERLAY PANELS Right hand models shown. Use the same instructions for left hm_d models. Handle Trim Move Forward For3/4" Panel - Use Front Holes to Secure Handle Use RearHoles to Secure Trim Door Trim Refrigerator Door Suppliedhandle shown in the overlaypanel position.
Installation Instructions [STEP 10]CONNECT WATER SUPPLY L[ • i,ocate and bring tubing to the fl'ont of the cabinet. • Turn the water oil to flush debris frmn line. Run about a quart of water through tubing into a bucket, then s hut off wa te r.
Installation Instructions I STEP 131 INSTALL TOEKICK • I,ocate the supplied toekick (shipped taped to the side of the refl'igerator), Install with 2 screws provided, a_!iust to desired height a.
Notes 18.
Notes 19.
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. t'_n" Mo_wg'r,m °° Iocnl ._vic_, ht your (m_,, c(lfl l. 800.444. 1845. NOTE: Pl-o(ltlc[ iln[)l-()'¢( mt_lll is _ contimfing ,:m,:l( ;avov ;_t (;en(:r_d Ele(tri(:.
An important point after buying a device GE GE Monogram ZIC360N LH (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought GE GE Monogram ZIC360N LH yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data GE GE Monogram ZIC360N LH - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, GE GE Monogram ZIC360N LH you will learn all the available features of the product, as well as information on its operation. The information that you get GE GE Monogram ZIC360N LH will certainly help you make a decision on the purchase.
If you already are a holder of GE GE Monogram ZIC360N LH, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime GE GE Monogram ZIC360N LH.
However, one of the most important roles played by the user manual is to help in solving problems with GE GE Monogram ZIC360N LH. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device GE GE Monogram ZIC360N LH along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
