Instruction/ maintenance manual of the product Combination Oven/Steamer Alto-Shaam
Go to page of 31
MN-29805 (R e v . 2) • 10/13 p r i n t e d i n u . s . a . Combitherm ® Combination Oven / Steamer CT EXPRESS™ 4•10ES i 4•10ESiVH 4•10CCi • INSTALLATION W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA PHONe: 262.
i Delivery .................................. 1 Unpacking ................................ 1 Safety Procedures and Precautions ............ 2 Installation Site Installation .......................... 3 Ventilation Requirements .................. 3 Positioning on Site .
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 1. DELIVERY This Alto-Shaam appliance has been thoroughly tested and inspected to ensure only the highest quality unit is provided. Upon receipt, check for any possible shipping damage and report it at once to the delivering carrier.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 2. CAUTION Used to indicate the presence of a hazard that can or will cause minor personal injury, property damage, or a potential unsafe practice if the warning included with this symbol is ignored.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 3. SITE INSTALLATION INSTALLATION DANGER IMPROPER INSTALLATION, ALTERATION, ADJUSTMENT, SERVICE, OR MAINTENANCE COULD RESULT IN SEVERE INJURY, DEATH, OR CAUSE PROPERTY DAMAGE.
CT ExpRESS SERIES • INSTALLATION MANUAL • MN-29805 • 4. note: Note dimensions required for doorways and aisles for access of the oven and pallet to the installation site. Transport the oven in an upright and level position only. Do not tilt the oven.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 5. LIFTING INSTRUCTIONS INSTALLATION Remove banding before lifting. Lift the unit from either side of the unit, n e v e r f r o m t h e f r o n t o r b a c k . Adjust the forks so that they do not damage any of the components under the unit.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 6. SITE INSTALLATION INSTALLATION EXHAUST VENT 18" (46cm) 4" (102mm) 4" (102mm) 20" (50cm) MINIMUM 20" (50cm) POSITI.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 7. ACCESSORIES CombiClean ® Tablets — CE-28892 s P e c i a l l y F O R M u l a t e d FOR c O M b i t H e R M O v e N s ➥ twO (2) c O N t.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 8. W A TER REQUIREMENTS W A TER QUALITY MINIMUM ST ANDARDS ONE (1) COLD W A TER INLETS - DRINKING QUALITY ONE (1) W A TER INLET: 3/4" G* LINE PRESSURE: 30 to 90 psi 2.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 9. W A TER REQUIREMENTS W A TER QUALITY MINIMUM ST ANDARDS ONE (1) COLD W A TER INLETS - DRINKING QUALITY ONE (1) W A TER INLET : 3/4" G* LI NE PRE SS UR E: 30 to 90 psi 2.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 10. W A TER REQUIREMENTS WA TER QUALITY MINIMUM ST ANDARDS ONE (1) COLD W A TER INLETS - DRINKING QUALITY ONE (1) W A TER INLET: 3/4" G* LINE PRESSURE: 30 to 90 psi 2.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 11. ELECTRICAL CONNECTION INSTALLATION DANGER ENSURE POWER SOURCE MATCHES VOLTAGE IDENTIFIED ON APPLIANCE RATING TAG.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 12. ELECTRICAL CONNECTION INSTALLATION DANGER ELECTRICAL CONNECTIONS MUST BE MADE BY A QUALIFIED SERVICE TECHNICIAN IN ACCORDANCE WITH APPLICABLE ELECTRICAL CODES.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 13. MOBILE EQUIPMENT RESTRAINT INSTALLATION Any appliance that is not furnished with a power supply cord but includes a set of casters, stand with casters, or a stacked configuration must be installed with a tether.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 14. INSTALLATION WATER QUALITY REQUIREMENT W ARNING TO PREVENT W A TER PIPES FROM BURSTING, INCOMING W A TER SUPPL Y SHOULD BE TURNED OFF WHEN THE APPLIANCE IS NOT IN USE. W ARNING W A TER SUPPL Y MUST BE OPEN WHEN CLEANING PROGRAM IS ACTIV A TED.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 15. INSTALLATION WATER CONNECTIONS W A TER SUPPL Y & INST ALLA TION W A TER REQUIREMENTS ONE (1) COLD W A TER INLET - DRINKING QUALITY ONE (1) TREA TED WA TER INLET : 3/4" G LINE PRESSURE: 30 to 90 psi 2.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 16. INSTALLATION OPTIONAL HAND HELD SPRAY HOSE V alve bracket INSTALLATION 1. Two pre-drilled holes with screws in place are located at the lower rear side of the unit (same side as door opening).
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 17. INSTALLATION WATER VALVE WATER DRAINAGE NOTE: THE SHUT-OFF VALVE MUST BE IN THE OPEN POSITION WHEN THE OVEN IS BEING USED. The oven must discharge through an indirect waste pipe by means of an air gap.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 18. INSTALLATION INDICATOR LIGHT If the indicator light does not illuminate, the filters may be missing or not properly aligned. Check them for proper positioning. Ventless hood and oven will not operate unless the hood is closed properly.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 19. INSTALLATION VENTLESS HOOD MODEL TOP EXHAUST VENT 1. Charcoal Filter: The charcoal filter should be inspected for contaminant's on a regular basis.
.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 21. INSTALLATION CT EXPRESS™ CHECKLIST Use this list as a nal check of oven installation conformance. Damage directly attributed to improper set up, installation, or cleaning can invalidate warranty claims.
.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 23. continued on next page This section is provided for the assistance of qualified technicians only and is not intended for use by untrained or unauthorized service personnel.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 24. continued on next page Error Code Error Call Out in Display Description of Error Possible Cause E13 Boiler T emperature High Boiler temperatur e overheats — Scale build up inside steam generator.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 25. ERROR CODES Error Code Error Call Out in Display Description of Err or Possible Cause E34 Steam Generator Drain Pump Fault W ater level in steam generator does not drop during cleaning program — Scale build up inside the steam generator drain pump.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 26. ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E57 No Rinse W ater During rinse no water fl ow is detected through solenoid valve — Water supply is shut off.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 27. ERROR CODES When the oven malfunctions, an error code will appear in the display . PRESS THE ST AR T ICON TO ACKNOWLEDGE THE ERROR. The icons that begin to flash repr esent operational modes that are still usable.
CT EXPRESS SERIES • INSTALLATION MANUAL • MN-29805 • 28. ORIGINAL EQUIPMENT LIMITED WARRANTY Alto-Shaam, Inc. warrants to the original purchaser that any original part that is found to be defective in material or workmanship will, at Alto-Shaam’s option, subject to provisions hereinafter stated, be replaced with a new or rebuilt part.
TRANSPORTATION DAMAGE AND CLAIMS All Alto-Shaam equipment is sold F.O.B. shipping point, and when accepted by the carrier, such shipments become the property of the consignee. Should damage occur in shipment, it is a matter between the carrier and the consignee.
An important point after buying a device Alto-Shaam Combination Oven/Steamer (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Alto-Shaam Combination Oven/Steamer yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Alto-Shaam Combination Oven/Steamer - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Alto-Shaam Combination Oven/Steamer you will learn all the available features of the product, as well as information on its operation. The information that you get Alto-Shaam Combination Oven/Steamer will certainly help you make a decision on the purchase.
If you already are a holder of Alto-Shaam Combination Oven/Steamer, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Alto-Shaam Combination Oven/Steamer.
However, one of the most important roles played by the user manual is to help in solving problems with Alto-Shaam Combination Oven/Steamer. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Alto-Shaam Combination Oven/Steamer along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
