Instruction/ maintenance manual of the product 1220 Alto-Shaam
Go to page of 39
MN-28897 • 02/12 printed i n u . s . a . Combitherm ® Combination Oven / Steamer ES ELECTRIC 6•10 10•10 7•14 10•18 12•20 20•20 VHes-5 VHes -10 • InstallatIon W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA PHONE: 262.
i Delivery 1 Unpacking 1 Safety Procedures and Precautions 2 Installation Site Requirements 3 Ventilation Requirements 3 Positioning on Site 4 Lifting Instructions 5 Leveling 6 Stand Installation 6 Ac.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 1. DELIVERY This Alto-Shaam appliance has been thoroughly tested and inspected to ensure only the highest quality unit is provided. Upon receipt, check for any possible shipping damage and report it at once to the delivering carrier.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 2. CAUTION Used to indicate the presence of a hazard that can or will cause minor personal injury, property damage, or a potential unsafe practice if the warning included with this symbol is ignored.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 3. SITE INSTALLATION INSTALLATION DANGER IMPROPER INSTALLATION, ALTERATION, ADJUSTMENT, SERVICE, OR MAINTENANCE COULD RESULT IN SEVERE INJURY, DEATH, OR CAUSE PROPERTY DAMAGE.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 4. NOTE: Note dimensions required for doorways and aisles for access of the oven and pallet to the installation site. Transport the oven in an upright and level position only. Do not tilt the oven.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 5. SITE INSTALLATION INSTALLATION Lifting Ins tructions Do not lift in this area! Damage t o the components will r esult. Cent er of Gra vity Front View T op View (Fron t) Leg 24” Spacer Board Remov e banding befor e lifting.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 6. SITE INSTALLATION INSTALLATION POSITIONING REQUIREMENTS q In order to ensure proper ventilation, a minimum distance of at least 6-inches (152mm) must be kept from the control panels side (left) of the oven and any adjoining surfaces.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 7. ACCESSORIES CombiClean® Tablets — CE-28892 s P E c i a l l y F O r M u l a t E d FOr cOMbitHErM OvENs ➥ t w O (2) c O N t .
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 8. 6•10 es 31-3/8" (796mm) 34-1/16" (864mm) 17-15/16" (456mm) 7-9/16" (191mm) WA TER DRAIN 33-1/8" (840.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 9. 6•10 es i 31-3/8" (796mm) 34-1/16" (864mm) 17-15/16" (456mm) 7-9/16" (191mm) WA TER DRAIN 33-1/8" (8.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 10. 6•10 es iN 32-15/16" (835mm) 35-9/16" (903mm) 21-11/16" (550mm) 5-3/8" (137mm) 6-3/8" (161mm) WA TE.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 11. 10•10 es 33-1/16" (840mm) 4-15/16" (125mm) 41-1/2" (1053mm) 33-15/16" (861mm) 7-9/16" (192mm) 60-9/.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 12. 10•10 es i 33-1/16" (840mm) 4-15/16" (125mm) 41-1/2" (1053mm) 33-15/16" (861mm) 7-9/16" (192mm) 60-.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 13. 19-1/2" (495mm) 12-5/16" (312mm) 9-9/16" ( 242m m) 35-7/8" (910mm) 33-7/8" (860mm) 33" (837mm) 2.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 14. 7•14 es TO P VIEW FRONT VIEW SIDE VIEW A rial MT Condensed Light 8 pt 43-3/4" (1111mm) 8-1/2" (216mm) 26-1/2".
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 15. 7•14 es i TO P VIEW FRONT VIEW SIDE VIEW A rial MT Condensed Light 8 pt 43-3/4" (1111mm) 8-1/2" (216mm) 26-1/2&quo.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 16. 30" (760mm) 4-1 1/16" (120mm) 2-5/16" (58mm) 22-3/8" (568mm) 15-1/2" (393mm) 12-3/4" (323mm) Ele.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 17. 30" (760mm) 4-1 1/16" (120mm) 2-5/16" (58mm) 22-3/8" (568mm) 15-1/2" (393mm) 12-3/4" (323mm) Ele.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 18. 46-3/4" (1186mm) 44-3/4" (1136mm) 40-15/16" (1039mm) 1-13/16" (46mm) 48" (1218mm) 45-5/16" (1151.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 19. 46-3/4" (1186mm) 44-3/4" (1136mm) 40-15/16" (1039mm) 1-13/16" (46mm) 48" (1218mm) 45-5/16" (1151.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 20. 40-15/16" (1039mm) 1-13/16" (46mm) 46-3/4" (1186mm) 44-3/4" (1136mm) 4-3/4" (120mm) 2" (50mm) 51.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 21. 40-15/16" (1039mm) 1-13/16" (46mm) 46-3/4" (1186mm) 44-3/4" (1136mm) 4-3/4" (120mm) 2" (50mm) 51.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 22. ELECTRICAL CONNECTION INSTALLATION DANGER ENSURE POWER SOURCE MATCHES VOLTAGE STAMPED ON APPLIANCE NAMEPLATE.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 23. ELECTRICAL CONNECTION INSTALLATION DANGER ELECTRICAL CONNECTIONS MUST BE MADE BY A QUALIFIED SERVICE TECHNICIAN IN ACCORDANCE WITH APPLICABLE ELECTRICAL CODES.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 24. motor with rotation direction electrical connection electrical panel terminal block ground WARNING FOLLOWING ELECTRICAL CONNECTION, THE FAN MUST ROTATE IN THE SAME DIRECTION AS THE ARROW LOCATED ON THE OVEN FAN MOTOR.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 25. MOBILE EQUIPMENT RESTRAINT INSTALLATION Any appliance that is not furnished with a power supply cord but includes a set of casters must be installed with a tether.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 26. INSTALLATION WATER QUALITY REQUIREMENT WARNING TO PREVENT WATER PIPES OR HOSES FROM BURSTING, INCOMING WATER SUPPLY SHOULD BE TURNED OFF WHEN THE APPLIANCE IS NOT IN USE. WARNING WATER SUPPLY MUST BE OPEN WHEN CLEANING PROGRAM IS ACTIVATED.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 27. INSTALLATION WATER CONNECTIONS WATER SUPPLY & INSTALLATION WATER REQUIREMENTS TWO (2) COLD WATER INLETS - DRINKING QUALITY ONE (1) TREATED WATER INLET: 3/4” NPT* ONE (1) UNTREATED WATER INLET: 3/4” NPT* LINE PRESSURE: 30 to 90 psi 2.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 28. INSTALLATION WATER VALVE WATER DRAINAGE shut - off valve shown i n the off position NOTE: THE SHUT-OFF VALVE MUST BE IN THE OPEN POSITION WHEN THE OVEN IS BEING USED. The oven must discharge through an indirect waste pipe by means of an air gap.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 29. INSTALLATION CHECKLIST Use this list as a nal check of oven installation conformance. Damage directly attributed to improper set up, installation, or cleaning can invalidate warranty claims.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 30. INSTALLATION There is a remote possibility in the day-to-day operation of the Combitherm that the control could lock or freeze. If this occurs, the control is easy to reset. PRESS AND HOLD THE POWER KEY FOR A PERIOD OF 5 SECONDS.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 31. INSTALLATION ERROR CODES AND REASONS (continued) Error Code Display Shows When does the error occur? Possible reason E13 Exces.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 32. INSTALLATION cONTINUed ON NexT pAge ERROR CODES AND REASONS (continued) Error Code Display Shows When does the error occur? Possible reason E29 Probe Short to Frame Activatedifoneormoreofthetemperature sensors were connected to GND for 5 seconds.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 33. INSTALLATION In theevent of an error code, the Combithermmay be operated on a limited basis.Error conditions under which continued operation can be conducted are indicated by “Yes” in the chart shown below.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 34. INSTALLATION VENTLESS HOOD OPTION The Ventless Hood option is factory installed directly on the top of the Alto-Shaam Combitherm oven. The hood is designed to vent clean air back into the kitchen, filtering vapors and grease.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 35. INSTALLATION VENTLESS HOOD OPTION TOP LEVEL ASSY, VHES-5 HOOD FOR COMBI 5010692 TOP EXHAUST VENT 2 6 1 4 3 5 7 1 Ventless Hood Power Knob 2 Emergency Latch Release: This release is to be used ONLY if the timed latch mechanism is not working or in the event of a power outage.
COMBITHERM® ES SERIES • ELECTRIC INSTALLATION MANUAL #MN-28897 • 36. ORIGINAL EQUIPMENT LIMITED WARRANTY Alto-Shaam, Inc. warrants to the original purchaser that any original part that is found t.
TRANSPORTATION DAMAGE AND CLAIMS All Alto-Shaam equipment is sold F.O.B. shipping point, and when accepted by the carrier, such shipments become the property of the consignee. Should damage occur in shipment, it is a matter between the carrier and the consignee.
An important point after buying a device Alto-Shaam 1220 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Alto-Shaam 1220 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Alto-Shaam 1220 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Alto-Shaam 1220 you will learn all the available features of the product, as well as information on its operation. The information that you get Alto-Shaam 1220 will certainly help you make a decision on the purchase.
If you already are a holder of Alto-Shaam 1220, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Alto-Shaam 1220.
However, one of the most important roles played by the user manual is to help in solving problems with Alto-Shaam 1220. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Alto-Shaam 1220 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center