Instruction/ maintenance manual of the product 17 Garmin
Go to page of 12
GPSMAP ® 2006/2010 & GPS 17 installation instructions.
2 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 All rights reserved. Except as expressly provided herein, no part of this manual may be reproduced, copied, transmitted, disseminated, downloaded, or stored in any storage medium, for any purpose without the express prior written consent of Garmin.
3 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 I NTRODUCTION The GPSMAP 2006C/2010C Multi-Function Display (MFD) and GPS 17 must be properly installed according to the following instructions for the best possible performance.
4 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 I NST ALLA TION I NSTRUCTIONS Surface Mount T ools • Drill and Drill Bit • Screwdriver • Pencil • Mounting Hardware (not included) NOTE: Mounting har dware (fasteners) not included.
5 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 Flush Mount T ools • Flush Mount T emplate • Jig saw • Masking tape • Scissors • Drill • Drill bits—1/8" (3 mm) and 3.
6 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 Radar ABOVE - BEST BELOW - OK EMI SS JA YH A W K GOOD BETTER BEST 3' VHF Radio Antenna Radar EMI (Electromagnetic Interference) fro.
7 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 T o attach the enclosed pole mount to the GPS 17: 1. Thread the cable though the pole mount. 2. Align the tab on the mount to the notch on the GPS 17. 3. Use the enclosed screws to secure the mount to the base.
8 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 Wiring There are two wiring diagrams provided for you convenience. The first is a simple hook-up showing the GPSMAP 2006/2010 (using the 18- pin wiring harness), the GPS 17 and the alarm circuit.
9 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 SH IP 'S B A TT ER Y 10 -3 2 VO L TS + - GA RM IN G SD 2 0 SO UN DE R MO DU LE (S EE G SD 2 0 IN ST AL L IN ST RU CT IO NS ) 4.
10 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 Final Wiring Connection Once all the wiring is complete, plug the 18-pin harness into the center connector on the backside of the GPSMAP 2006/2010. The 5-pin port on the right side is intended for future interfacing features and does not require connection at this time.
1 1 I NST ALLA TION I NSTRUCTIONS GPSMAP 2006C/2010C & GPS 17 Dill this 3/4” or 19 mm hole if the coax is going to be installed through the mounting panel Drill using a 1 1/64” or 4.
© Copyright 2005 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151 st Street, Olathe, Kansas 66062, U.S.A. Garmin (Europe) Ltd. Unit 5, The Quadrangle, Abbey Park Industrial Estate, Romsey , SO51 9DL, U.K. Garmin Corporation No.
An important point after buying a device Garmin 17 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Garmin 17 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Garmin 17 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Garmin 17 you will learn all the available features of the product, as well as information on its operation. The information that you get Garmin 17 will certainly help you make a decision on the purchase.
If you already are a holder of Garmin 17, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Garmin 17.
However, one of the most important roles played by the user manual is to help in solving problems with Garmin 17. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Garmin 17 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
