Instruction/ maintenance manual of the product 316135932 Frigidaire
Go to page of 16
Contents Product Registration ......................................................... 2 V ersión en español ........................................................... 2 Version française ..........................................................
2 Thank you for choosing your new range. The information contained within this Owner's Guide will instruct you on how to properly operate and care for your range. Please read through the information contained in your literature pack to learn more about your new range.
3 IMPORT ANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Save these instructions for future reference. This guide contains important safety symbols and instructions. Please pay attention to these symbols and follow all instructions given.
4 IMPORT ANT INSTRUCTIONS FOR USING YOUR COOKTOP Use Proper Flame SizeAdjust flame size so it does not extend beyond the edge of the utensil. The use of undersized utensils will expose a portion of the burner flame to direct contact and may result in ignition of clothing.
5 Grounding Instructions (electric ignition models only) Avoid fire hazard or electrical shock. Do not use an adapter plug, an extension cord, or remove grounding prong from electrical power cord. Failure to follow this warning can cause serious injury, fire or death.
6 Sealed Surface Burner Models - Setting Surface Controls The surface control knob shown below may not look identical to the surface control knobs on your range; it is only representational. Your range may be equipped with any combination of the following burners: Simmer Burner, this burner is best used for simmering delicate sauces, etc.
7 Before Setting Oven Controls Oven V ent Location The oven vent is located below the backguard. When the oven is on, warm air is released through the vents. This venting is necessary for proper air circulation in the oven and good baking results. Arranging Oven Racks ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN).
8 Your model may be equipped with the clock shown below. Follow the instructions to set the clock and minute timer on your range. Not all manual clean ranges are equipped with a clock. T o Set the Clock When the range is first plugged in, or when the power supply to the range has been interrupted, "12:00" will flash in the display window.
9 The oven control shown below may not look identical to the oven control on your range. They are only representational. Bake 1. Arrange oven racks while the oven is still cool. See "Arranging Oven Racks" under Before Setting Oven Controls .
10 Oven Cleaning Follow these cleaning precautions: Allow the oven to cool before cleaning. Wear rubber gloves when cleaning the appliance manually. REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS WILL REDUCE THE NUMBER OF MAJOR CLEANINGS LATER.
11 Surfaces Aluminum (Trim Pieces) & Vinyl Glass, Painted and Plastic Body Parts, Control Knobs and Decorative Trim Pieces Control Panels Porcelain Enamel Burner Grates, Cooktop Surface, Below Coo.
12 Use caution when replacing the burner cap so the electrode is not damaged. This may cause a delayed ignition or prevent the burner from igniting. Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by an authorized Frigidaire Distributor or Qualified Agency.
13 T o Remove and Replace Oven Bottom To Remove Oven Bottom: 1. Remove the oven racks. 2. Remove the two hold-down screws (Figure 1) at the rear of the oven bottom panel. If the screws are too tight to remove by hand, use a screwdriver. 3. To lift out the bottom panel, place fingers in the slots in the bottom.
14 POSSIBLE CAUSE/SOLUTION Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at base of range until the rack is level. When range is level, cooktop may appear out of alignment if countertop is not level.
15 Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire or needle. Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame is full. Dry the burners thoroughly following instructions in the General Cleaning section.
GIBSON RANGE PLA TINUM ADV ANT AGE W ARRANTY Your Gibson range is protected by this warranty In the U.S.A., your appliance is warranted by Electrolux Home Products North America, a division of White Consolidated Industri es, Inc. We authorize no person to change or add to any of our obligations under this warranty.
An important point after buying a device Frigidaire 316135932 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Frigidaire 316135932 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Frigidaire 316135932 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Frigidaire 316135932 you will learn all the available features of the product, as well as information on its operation. The information that you get Frigidaire 316135932 will certainly help you make a decision on the purchase.
If you already are a holder of Frigidaire 316135932, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Frigidaire 316135932.
However, one of the most important roles played by the user manual is to help in solving problems with Frigidaire 316135932. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Frigidaire 316135932 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center