Instruction/ maintenance manual of the product CG905 Fisher & Paykel
Go to page of 32
NZ A U Installation instructions and User guide Gas cooktops CG604 & C G905 models.
.
1 Contents Safety and warnings 2 Installation instructions 6 Introduction 16 Using y our cooktop 18 Care and cleaning 22 T r oubleshooting 26 W arranty and service 27 Impor tant! SA VE THESE INSTR UCTIONS The models shown in this user guide may not be available in all markets and ar e subject to change at any time.
2 Impor tant sa fety instruc tions Installation Read these instructions carefully before installing or using this product. Please make this information av ailable to the person responsible for installing the product as it could reduce y our installation costs.
3 Always disc onnect the cooktop from the electricit y supply before carrying out any maintenance operations or repairs. In the room where the cooktop is installed, there must be enou gh air to allow the gas to burn correctly , according to the current loc al regulations.
4 Safety and warnings W ARNING! Hot Sur face Hazar d This appliance bec omes hot during use. Do not touch the cooktop c omponents, burners, trivets , pan supports or the base when hot. Before cleaning , turn the burners o and make sure the whole cookt op is cool.
5 Impor tant sa fety instruc tions Operation Keep children aw ay from the cooktop when it is in use. Household appliances are not intended to be played with by children. Children, or persons with a disability which limits their ability to use the appliance, should have a responsible person to instruct them in its use.
6 5 8 0 4 8 0 500 60 34 0 – 2 560 200 0 – 2 480 70 60 60 min 0 – 2 840 200 min 0 – 2 860 100 200 500 Area for electrical connection Area for gas connection Fig .
7 Installation instructions 20 mm 650 mm 60 mm min 200 mm min 500 mm 450 mm 650 mm 60 mm min 200 mm min 500 mm 450 mm 20 mm Fig . 2a CG604 models - Clearanc es Fig . 2b CG905 models - Clearanc es Fig . 3a CG604 models - Mounting the base clearance spac ers Fig .
8 Installation instructions F astening the installation brackets (F ig. 4a and 4b) Each cooktop is pro vided with an installation kit including brackets and screws for fastening the cooktop to benches fr om 20 to 40 mm thick.
9 Installation instructions Connecting the cooktop to the gas supply The gas connection must be carried out by an authorised person according to the r elevant standards. Before connecting the appliance to the gas main, mount the brass conical adaptor onto the gas inlet pipe, upon which the washer has been placed (F igs.
10 Installation instructions Leak-t esting and flame -testing the cooktop 1 After connecting the gas supply , check the piping and connections for leaks using a soap and water solution. The presence of bubbles indicates a leak. Tighten or replace c onnections as appropriate .
11 Installation instructions Con verting to a different gas type Impor tant! The conv ersion procedure must be carried out only by an authorised person. This appliance is suitable for use with Natural gas or LPG (check the “ gas type” sticker attached to the appliance).
12 Installation instructions Adjusting the minimum burner setting When changing from one type of gas to another , the minimum valve output must also be correct, considering that in this position the flame must be about 4 mm long and must re- main lit even when the knob is turned quickly from the maximum to the minimum position.
13 Installation instructions Impor tant! Installation must be c arried out according to the manufacturer's instructions. Incorrect installation may cause harm and damage to people , animals or proper ty , for which the manufacturer accepts no responsibility .
14 Wiring diagr am P A Ignition switch A Ignition coil M T erminal block CA Spark electrode NL M PA CA CA CA CA CA PA PA PA PA A CG905 models onl y CG905 models onl y Fig .
15.
16 Introduction About your new cookt op Thank you f or buying an ELBA gas cooktop. Onc e it is installed and ready to use, y ou will want to know everything about it to make sure you get excellent r esults right from the start. This guide introduces y ou to all its special features .
17 8 6 7 5 9 2 2 1 4 3 Introduction 1 Auxiliary burner 2 Semi-rapid burner 3 Rapid burner 4 T r iple-ring wok burner 5 Auxiliary burner k nob Fig .13 CG905 models (with flame failure safety feature) 6.
1 8 Using y our cooktop Gas burners The knob (Fig . 14) controls the flow of gas through the saf ety valve. O = closed valve = maximum flow = minimum flow Y ou can choose to cook at an y heat between and , but never between and O . Using the burners 1 Choose the control knob for the burner you want to use .
19 Using y our cooktop Fig .15 Cleaning the ignitor and probe Ignitor Flame failure pr obe (flame failure models only) Flame failur e safety feature (some models only) Some cooktop models have a flame failur e safety device. These models have a flame failure probe as well as the ignit or (see Fig 15).
20 Matching cookwar e to burner Use flat-bottomed pans, and make sur e they match the size of the burner , as shown in the following table . A small pot on a large burner is not efficient.
21 Using y our cooktop Fig . 17a Incorrect use of wok Fig . 17b Correct use of wok on triple-ring wok burner W ok stand - models fitted with triple -ring wok burner only (Fig .
22 General advice Maintenance P eriod Description Daily Clean gas cooktop as per follo wing instructions. Monthly Remove all burner parts, and clean using a non-abrasive detergent. Rinse in cold water , dry thoroughly, and r eplace. Clean the ignitor carefully , using a toothbrush and methylated spirits .
23 Car e and cleaning Burners and trivets Y ou can remov e and clean these par ts with hot soapy water or other appr opriate products - see ‘Cleaning chart ’ . After cleaning, check that the burners and their flame spreaders ar e dry before replacing correctly .
24 Replacing the triple -ring wok burner Fit the burner spr eader to the housing as shown by the arr ow in Fig . 20. Make sure the burner is not able to rotate (F ig. 21). Fig . 21 Correct positioning of cap and ring - triple- ring wok burner Cap Ring Fig .
25 Car e and cleaning Cleaning chart Cooktop part Cleaning Impor tant T rivets, burner caps Hot soapy water and nylon scour er . Soak removeable parts in a solution of biological clothes-washing detergent. Mild abrasive cream cleaners. F ume -free or heavy-duty oven cleaners (follow manufacturer’ s instructions).
26 T roubleshooting T roubleshooting char t Problem Possible solutions A burner does not light Check the cooktop is plugged in and the electricity is switched on. Check the gas supply valve is turned on and the supply to the house is working. Y ou should hear the gas when you turn a burner on.
27 W arranty and ser vice Before y ou call for service or assistance ... Check the things you can do yourself . Refer to the installation instructions and your user guide and check that: 1 your product is correctly installed. 2 you are familiar with its normal operation.
.
.
Copyright © F isher & Paykel 2013. All rights r eserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at an y time.
An important point after buying a device Fisher & Paykel CG905 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Fisher & Paykel CG905 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Fisher & Paykel CG905 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Fisher & Paykel CG905 you will learn all the available features of the product, as well as information on its operation. The information that you get Fisher & Paykel CG905 will certainly help you make a decision on the purchase.
If you already are a holder of Fisher & Paykel CG905, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Fisher & Paykel CG905.
However, one of the most important roles played by the user manual is to help in solving problems with Fisher & Paykel CG905. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Fisher & Paykel CG905 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
