Instruction/ maintenance manual of the product ONELINK CM2837 First Alert
Go to page of 9
Page 1 of 9 CM2837 **Interconnected alarms provide added warning as compared to single alarms. Bridge Unit 120V AC Hardwired Smoke Alarm SA520B Battery Smoke/CO Combination Alarm with Voice SCO500B Ba.
Page 2 of 9 CM2837 **Interconnected alarms provide added warning as compared to single alarms. WIRELESS Competitive Dip Switches Question : What is Voice Warning with Location? Answer: This is an exclusive First Alert® feature that verbally identifies not only the danger detected, i.
Page 3 of 9 CM2837 **Interconnected alarms provide added warning as compared to single alarms. installation. With First Alert® OneLink® there is an extremely small chance of a duplicate code progra mmed in an adja cent apartment’s units as with the competition.
Page 4 of 9 CM2837 **Interconnected alarms provide added warning as compared to single alarms. Question : How do I program and link the alarms? Answer: TO PROGRAM FIRST ALARM: 1. Insert batteries (2, AA batteries). Alarm Will Say: “Welcome, First Alert Smoke Alarm.
Page 5 of 9 CM2837 **Interconnected alarms provide added warning as compared to single alarms. Question : What is the Spread Spectrum Horn Tone? Answer: The Spread Spectrum Horn Tone is a lower and varying horn frequency that sweeps through the 2200 – 3400 Hz range.
Page 6 of 9 CM2837 **Interconnected alarms provide added warning as compared to single alarms. Now all alarms will be interconnected, in cluding other existing hardwired alarms that were interconnected in the old section.
Page 7 of 9 CM2837 **Interconnected alarms provide added warning as compared to single alarms. Question : What are the latching features on the First Alert® OneLink® alarms? Answer: There are two latching features on th ese alarms: Alarm Latch and Low Battery Latch.
Page 8 of 9 CM2837 **Interconnected alarms provide added warning as compared to single alarms. Question : How many First Alert® OneLink® alarms can be interconnected together? Answer: As with hardwired units, NFPA states that up to 18 total units ca n be interconnected (RF or hardwired) with a m aximum of 12 of those being smoke alarms.
Page 9 of 9 CM2837 **Interconnected alarms provide added warning as compared to single alarms. • Pull out battery drawer makes it easier to replace the batteries. No need to remove from wall or ceiling. The compet ition’s battery access on the back of the unit.
An important point after buying a device First Alert ONELINK CM2837 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought First Alert ONELINK CM2837 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data First Alert ONELINK CM2837 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, First Alert ONELINK CM2837 you will learn all the available features of the product, as well as information on its operation. The information that you get First Alert ONELINK CM2837 will certainly help you make a decision on the purchase.
If you already are a holder of First Alert ONELINK CM2837, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime First Alert ONELINK CM2837.
However, one of the most important roles played by the user manual is to help in solving problems with First Alert ONELINK CM2837. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device First Alert ONELINK CM2837 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
