Instruction/ maintenance manual of the product UV-18 Field Controls
Go to page of 8
UV-AIRE™ AIR PURIFYING SYSTEM Mode l: UV-12,18 READ THESE INSTRUCTIONS CAREFULLY AND COMPLETE LY BEFORE PROCEEDING WITH THE INSTALLATION LEAVE THE INSTALLATION INSTRUCTIONS WITH THE OWNER/OPERATOR OF THE DEVICE AFTER OPENING THE CARTON, UNPACK AND INSPECT THE UNIT AND LAMP FOR DAMAGE.
Page 2 I. INDICATION FOR USE This product is not sold as a medical device and is not for the purpose of diagnosis of any disease or co ndition nor for use in the mitigation, treatment, or pr evention of any disease or condition. II. GENERAL INFORMATION There are different size units avail able, depending on t he squ are footage of your home.
Page 3 2. Determine the type of duct you have. (For flex duct applications, refer to Figure 21 on page 8) I F YOU HAVE METAL DUCT : a. Apply supplied wet and stick mounting template to air duct in either a vertical or horizontal positio n as shown in Figure 2.
Page 4 3. Remove base unit and cover from box. 4. Apply supplied “Du ct Seal Kit” according to instructio ns included in kit (See Figure 12) 5. Determine whether to use flat or angl ed bracket. (Refer to UV-Aire “ Bulb Mounting Bracket Selection” in section IV for aid in this decis ion) a.
Page 5 8. Insert lamp through hole until lamp cannot be inserted any further. (See Figure 16) 9. Swing the swivel bracket over end of lamp. Hand-ti ghten the wing nut on stud. (See Figure 17) Be careful not to over tighten the wing nut. The porcelain at the lamp base may crack when over tightened.
Page 6 Chart A IV. BULB MOUNTING BRACKET SELECTION The UV-AIRE TM units come with an a ngled mounting bracket and flat mount ing bracket to position the bul b either straight or at an angle. Cho ose one or the other br acket method be st suited for your needs.
Page 7 V. MAINTENANCE 1. Inspect and clean lamp at least every 6 months. 2. Replace your UV-Aire™ Ai r Purifying System lamp once a year to maintain the lamps maximum output intensity. The lamp should operate continuously fo r maximum lamp life and light effectiveness.
Page 8 IX. FLEX DUCT INSTALLATION For installations on duct system s with a metallic main duct an d flex duct branches , follow the instructions i n figure 21 below. The health aspects associated with the use of these p roducts and their ability to aid in disinfecting of environmental air have not been invest igated by UL.
An important point after buying a device Field Controls UV-18 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Field Controls UV-18 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Field Controls UV-18 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Field Controls UV-18 you will learn all the available features of the product, as well as information on its operation. The information that you get Field Controls UV-18 will certainly help you make a decision on the purchase.
If you already are a holder of Field Controls UV-18, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Field Controls UV-18.
However, one of the most important roles played by the user manual is to help in solving problems with Field Controls UV-18. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Field Controls UV-18 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
