Instruction/ maintenance manual of the product 24 Vac System Control Kit CK-43 Field Controls
Go to page of 8
2630 Airport Road · Kinston , NC 28504 Phone: 252-522-3031· Fax: 252-522-0214 www.fieldcontrols.com 24 VAC SYSTEM CONTROL KIT Mode l: CK-43 The CK-43 is designed for use with the SWG Series Power Venter for controlling Natural Gas and L.P. Gas Draft Induced appliances.
Page 2 INSTALLATION INSTRUCTIONS M OUNTING J UNCTION B OX The junction box can be mounted at the v enter or remotely mounted away from the venter. (See Figure 1 & Figure 2) 1. Remove one of the knockouts from the side of the junction box where the pressure switch is mounted.
Page 3 DRAFT CONTROL INSTALLATION See Figure 4 for typical vent system layout. CAUTION: This draft control is shipped as a single acting draft control. If the draft control is not being used on a gas draft induced furnace, remove the gate stop on the draft control ring before installing.
Page 4 D RAFT C ONTROL I NSTALLA TION IN T YPE B V ENT P IPE CAUTION: DO NOT use the supplied collar when mounting draft control to Type B Vent Pipe. Install by using a Type B Vent Pipe Tee. 1. Install a vent pipe reducer or increaser into the inner pipe and fasten using sheet metal screws.
Page 5 PROVING SWITCH ADJUSTMENTS After proper air flow is established, the pressure switch adjustment is made by turning pressure switch adjustment screw clockwise (See Figure 10) until burner operation stops. Turn the adjustment screw counter clockwise until burner ignites.
Page 6 SYSTEM CONTROL CHECK OUT PROCEDURES 1. Adjust the thermostat to call for heat and observe the power venting system for proper operation sequence (Repeat if necessary). a. Thermostat calls for heat. b. Relay is energized and venter motor starts.
Page 7 INSTALLATION INFORMATION MODEL NO.: ____________________________________________________________ INSTALLER’S NAME: _____________________________________________________ INSTALLER’S COMPANY: _________________________________________________ INSTALLER’S PHONE NO.
Page 8 P/N 46190700 Rev D 11/07.
An important point after buying a device Field Controls 24 Vac System Control Kit CK-43 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Field Controls 24 Vac System Control Kit CK-43 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Field Controls 24 Vac System Control Kit CK-43 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Field Controls 24 Vac System Control Kit CK-43 you will learn all the available features of the product, as well as information on its operation. The information that you get Field Controls 24 Vac System Control Kit CK-43 will certainly help you make a decision on the purchase.
If you already are a holder of Field Controls 24 Vac System Control Kit CK-43, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Field Controls 24 Vac System Control Kit CK-43.
However, one of the most important roles played by the user manual is to help in solving problems with Field Controls 24 Vac System Control Kit CK-43. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Field Controls 24 Vac System Control Kit CK-43 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
