Instruction/ maintenance manual of the product Mini A Enviro
Go to page of 16
PELLET ST OVE Mini A SHERWOOD INDUSTRIES IS AN ENVIRONMENT ALL Y RESPONSIBLE COMP ANY . THIS MANUAL IS PRINTED ON RECYCLED P APER. PLEA SE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE O WNER ’S MANU AL 50-1927 PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET BURNING ROOM HEATER.
T able of Contents 2 Introduction............................................................... ....................................3 Rating Label Location...........................................................................3 P ellet Quality ..
3 Introduction * This manual is designed for the home owner in conjunction with the technical manual. * R ATING L ABEL L OCATION : The rating label is located on the back of the ash pan co ver . P ELLET Q UALITY : Pellet quality is important, please read the following: Your enviro pellet stove has been designed to burn wood pellets only.
4 Introduction I MPORTANT S AFETY D ATA : Please read this entire Owner’s Manual before installing or operating your ENVIRO Pellet Stove. Failure to follow these instructions may result in property damage, bodily injury or even death.
5 Introduction of ashes should be on a non-combustible floor on the ground, wel l away from all combustible materials pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispensed, they should be retained in the closed container until all cinders hav e been thoroughly cooled.
15 1 / 4 " (386 mm) 19" (483 mm) 17 1 / 2 " (444 mm) 19 1 / 2 " (496 mm) 17 7 / 8 " (455 mm) 34 1 / 8 " (868 mm) 19 3 / 4 " (503 mm) 24 7 / 8 " (632 mm) ROOMAIR.
7 Oper a ting Instructions C ONTROL B OARD F UNCTIONS : 1. AUGER LIGHT: This green light will flash in conjunction with the auger pulse. 2. MODE LIGHT: Responsible for signaling the state of the control board. When the light is flashing the stove is in an automatic start mode or the thermostat has control of the unit.
8 Figure 3: Thermostat Switch in MANUAL position. Figure 4: Thermostat Switch in HIGH/LOW position. ROOM AIR FAN ON/OFF ON/OFF FEED RATE TRIM COMBUSTION BLOWER TRIM HEAT LEVEL AUTO/OFF HIGH/LOW MANUAL.
9 Figure 6: Slider/Damper Adjustment Knob. Figure 7: Efficient Flame. Oper a ting Instructions S LIDER /D AMPER S ET -U P : THE SLIDER / DAMPER MUST BE SET AT TIME OF INSTALLATION.
10 2-3 Days / Weekly Semi-annually or 2 T ons of Fuel Burn Pot and Liner Exhaust V ent Heat Exchanger T ubes Air Intake Ash Pan Blower Mechanisms Door Glass Heat Exchanger T ubes Inside Firebox Behind.
EXHAUST PASSAGES (semi-annually) T o prevent build up of fly -ash all the exhaust passages must be cleaned and vacuumed. R outine Cleaning and Maintenance If the glass has build up that can not be removed with only the cloth, clean the glass using paper towel and a gas appliance glass cleaner , this ma y be purchased through most dealers.
R outine Cleaning and Maintenance Remo val of the firebox backing. • Open the door by lifting the handle, remove the burn pot and burn pot liner . • Lubricate all screws with penetrating oil. • Remov e the four (4) screws that hold the side panels in place.
13 W arr anty Sherwood Industries Ltd. is the manufacturer of the Enviro line of heating products. At Sherwood Industries, our commitment to the highest lev el of quality and customer service is the most important thing we do.
W arr anty 14 Exclusions and Limitations: 1. This W arranty does not co ver tarnish, discoloration or wear on the plating or paint. 2. This W arranty ex cludes wear and tear or breakage caused by cleaning, moving or service on log set. 3. A qualified installer must install this stove or fireplace.
17 . Damage to plated surfaces caused by fingerprints, scr atches, melted items, or other external scores and residues left on the plated surfaces fr om the use of abrasive cleaners or polishes is not cov ered in this warr anty . 18. The Limited W arranty does not co ver tarnish, discoloration or wear on the plated surf aces.
16 NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ _________________________________________ PHONE.
An important point after buying a device Enviro Mini A (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Enviro Mini A yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Enviro Mini A - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Enviro Mini A you will learn all the available features of the product, as well as information on its operation. The information that you get Enviro Mini A will certainly help you make a decision on the purchase.
If you already are a holder of Enviro Mini A, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Enviro Mini A.
However, one of the most important roles played by the user manual is to help in solving problems with Enviro Mini A. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Enviro Mini A along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
