Instruction/ maintenance manual of the product VFDR30LB Empire Comfort Systems
Go to page of 24
Page 1 21565-3-0906 INST ALLA TION INSTRUCTIONS AND OWNER'S MANUAL UNVENTED GAS LOG HEA TER OR VENTED DECORA TIVE APPLIANCE MODELS VFDR18LB(N,P)-1 VFDR24LB(N,P)-1 VFDR30LB(N,P)-1 EFFECTIVE DA TE SEPTEMBER 2006 V ented/V ent-Fr ee Burner and Logs This is an unvented gas-fired heater .
Page 2 21565-3-0906 SECTION P AGE IMPOR T ANT SAFETY INFORMA TION ........................................................................................ 3 SAFETY INFORMA TION FOR USERS OF LP-GAS ......................................................
Page 3 21565-3-0906 W ARNING When used without adequate combustion and ventilation air , heater may give off CARBON MONOXIDE, an odorless, poisonous gas. Do not install heater until all necessary provisions are made for combustion and ventilation air .
Page 4 21565-3-0906 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. Y ou must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor .
Page 5 21565-3-0906 Notice: During initial firing of this unit, its paint will bake out, and smoke will occur . T o prevent triggering of smoke alarms, ventilate the room in which the unit is installed.
Page 6 21565-3-0906 This is an unvented gas-fired heater . It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. Keep room area clear and free from combus tib le materi als, gaso line and other flammable vapors and liquids.
Page 7 21565-3-0906 ventilation air by one of the methods described in the National Fuel Gas Code, ANSI Z223.1, Section 5.3. or applicable local codes.
Page 8 21565-3-0906 Mantel Clearances with Hood (Figur e 5) Y ou must have non-combustible materials above the fireplace opening. Non-combustible material must extend at least 8" above fir epl ac e ope ni ng. W ith she et met al , you must ha ve non -c om bu st ibl e material behind it.
Page 9 21565-3-0906 FOR MASONR Y BUIL T FIREPLACES FREE OPEN ING A REA OF CHI MNEY DAMPER FOR VENTING COMBUSTION PRODUCTS FROM DECORA- TIVE APPLIANCES FOR INST ALLA TION IN SOLID FUEL BURNING FIREPLACES * Height is from hearth to top of chimney and the minimum height is 6 feet.
Page 10 21565-3-0906 Notice (Damper Clamp Installation) When installing your log set as a vented installation the damper clamp must be used. When installing your log set as a vent-free installation the damper clam p can be used to elimi nate the potenti al for odors when burnin g the logs for the first time.
Page 1 1 21565-3-0906 Check all local codes for requirements, especially for the size and type of gas supply line required. Note: Never use plastic pipe.
Page 12 21565-3-0906 Before you begin: if you are installing logs onto the VFDR18 or VFDR24 models, this burner assemb ly is supplied with a set of five ceramic fiber logs. Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation from ceramic fibers.
Page 13 21565-3-0906 Before you begin: If you are installing logs onto the VFDR30 model, this burner assembly place is supplied with a set of seven ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers.
Page 14 21565-3-0906 Flames from the pilot (rear right back side of the pan burner) as well as the main flame should be visually checked as the log set is installed.
Page 15 21565-3-0906 Th e rm o st a t s a re no t ap p ro v ed on v en t ed de c or a t iv e a p pl i a nc e s. Label all wires prior to disconnection when servicing controls. W iring errors can cause improper and dangerous operation. V erify proper operation after servicing.
Page 16 21565-3-0906 W ARNING: If you do not follow these instructions exactly , a fire or explosion may r esult causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly .
Page 17 21565-3-0906 Figure 18 shows a correct pilot flame pattern. The correct flame will be blue and will extend beyond the thermocouple. The flame will surround the thermocouple just below the tip. A slight yellow flame may occur where the pilot flame and main burner flame meet.
Page 18 21565-3-0906 Annual inspection and cleaning by your dealer or qualified service technician is recommended to prevent malfunction and/or sooting. TURN OFF HEA TER AND ALLOW TO COOL BEFORE CLEANING. Remove logs, handling carefully by holding gently at each end.
Page 19 21565-3-0906 If the gas quality is bad, your pilot may not stay lit, the burners may pr oduce soot and the heater may backfire when lit. If the gas quality or pressur e is low , contact your local gas supplier immediately . 1. When ignitor button is pressed, there is no spark at ODS/ pilot.
Page 20 21565-3-0906 Attention: When ordering parts, it is very important that part number and description of part coincide. USE ONL Y MANUF ACTURER'S REPLACEMENT P AR TS. USE OF ANY OTHER P AR TS COULD CAUSE INJUR Y OR DEA TH. P AR TS LIST INDEX NO.
Page 21 21565-3-0906 P AR TS VIEW Parts can be ordered only through your service person or dealer . For best results, the service person or dealer should order parts through the distributor . Parts can be shipped directly to the service person/dealer .
Page 22 21565-3-0906 SER VICE NOTES.
Page 23 21565-3-0906 SER VICE NOTES.
Page 24 21565-3-0906 Empire Comfort Systems, Inc. 918 Freeburg A ve. Belleville, IL 62220 PH: 618-233-7420 or 800-851-3153 F AX: 618-233-7097 or 800-443-8648 info@empirecomfort.
An important point after buying a device Empire Comfort Systems VFDR30LB (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Empire Comfort Systems VFDR30LB yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Empire Comfort Systems VFDR30LB - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Empire Comfort Systems VFDR30LB you will learn all the available features of the product, as well as information on its operation. The information that you get Empire Comfort Systems VFDR30LB will certainly help you make a decision on the purchase.
If you already are a holder of Empire Comfort Systems VFDR30LB, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Empire Comfort Systems VFDR30LB.
However, one of the most important roles played by the user manual is to help in solving problems with Empire Comfort Systems VFDR30LB. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Empire Comfort Systems VFDR30LB along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
