Instruction/ maintenance manual of the product VFDM30LBN-1 Empire Comfort Systems
Go to page of 32
Page 1 23099-1-0707 INST ALLA TION INSTRUCTIONS AND OWNER'S MANUAL UNVENTED GAS LOG HEA TER OR VENTED DECORA TIVE APPLIANCE MODELS VFDR18LB10N-1 VFDR18LB10P-1 VFDR18LBN-1 VFDR18LBP-1 VFDR24LBN-1 .
Page 2 23099-1-0707 T ABLE OF CONTENTS Important Safety Information ................................................................................................. 3 Safety Information for Users of LP-Gas ............................................
Page 3 23099-1-0707 W ARNING When used without adequate combustion and ventilation air , heater may give off CARBON MONOXIDE, an odorless, poisonous gas. Do not install heater until all necessary provisions are made for combustion and ventilation air .
Page 4 23099-1-0707 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. Y ou must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor .
Page 5 23099-1-0707 Notice: During initial firing of this unit, its paint will bake out, and smoke will occur . T o prevent triggering of smoke alarms, ventilate the room in which the unit is installed.
Page 6 23099-1-0707 PRODUCT SPECIFICA TIONS W ater vapor is a by-product of gas combustion. An unvented room heater produces approximately one (1) ounce (30ml) of water for every 1,000 BTU's (.
Page 7 23099-1-0707 This is an unvented gas-fired heater . It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. Keep room area clear and free from com bust ibl e mater ials , gasol ine and other flammable vapors and liquids.
Page 8 23099-1-0707 Example of Large Room with 1/2 W all divider . Figure 1 The following formula can be used to determine the maximum heater rating per the definition of unconfined space: Btu/Hr = .
Page 9 23099-1-0707 Mantel Clearances with Hood (Figur e 5) Y ou must have non-combustible materials above the fireplace opening. Non-combustible material must extend at least 8" above fir epl ac e op en in g. W ith she et meta l, you must hav e non- co mbu st ib le material behind it.
Page 10 23099-1-0707 FOR MASONR Y BUIL T FIREPLACES FREE OPE NIN G AR EA OF CH IMNE Y DA MPER FOR VENTING COMBUSTION PRODUCTS FROM DECORA- TIVE APPLIANCES FOR INST ALLA TION IN SOLID FUEL BURNING FIREPLACES * Height is from hearth to top of chimney and the minimum height is 6 feet.
Page 1 1 23099-1-0707 Notice (Damper Clamp Installation) When installing your log set as a vented installation the damper clamp must be used. When installing your log set as a vent-free installation the damper clam p can be used to elimin ate the pote ntia l for odors when burning the logs for the first time.
Page 12 23099-1-0707 Check all local codes for requirements, especially for the size and type of gas supply line required. Note: Never use plastic pipe.
Page 13 23099-1-0707 Befo re you begin : if you are insta lling logs onto the VFD(R ,T ,M)18 or VFD(R,T ,M)24 models, this burner assembly is supplied with a set of five ceramic fiber logs. Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation from ceramic fibers.
Page 14 23099-1-0707 Befo re you beg in: If you are instal lin g logs ont o the VFD(R, T ,M)30 model, this burner assembly place is supplied with a set of seven ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers.
Page 15 23099-1-0707 Flames from the pilot (rear right back side of the pan burner) as well as the main flame should be visually checked as the log set is installed.
Page 16 23099-1-0707 Th erm o st ats ar e n o t app r ov ed o n ven t ed de c or ati v e app l ia nce s . Label all wires prior to disconnection when servicing controls. W iring errors can cause improper and dangerous operation. V erify proper operation after servicing.
Page 17 23099-1-0707 W ARNING: If you do not follow these instructions exactly , a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly .
Page 18 23099-1-0707 W ARNING: If you do not follow these instructions exactly , a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly .
Page 19 23099-1-0707 VFDT(18,24,30)LB LIGHTING INSTRUCTIONS W ARNING: If you do not follow these instructions exactly , a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand.
Page 20 23099-1-0707 VFDM(18,24,30)LB LIGHTING INSTRUCTIONS W ARNING: If you do not follow these instructions exactly , a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand.
Page 21 23099-1-0707 Figures 21 and 22 show a correct pilot flame pattern. The correct flame will be blue and will extend beyond the thermocouple. The flame will surround the thermocouple just below the tip. A slight yellow flame may occur where the pilot flame and main burner flame meet.
Page 22 23099-1-0707 Figure 25 VFDR Figure 26 VFDT & VFDM Annual inspection and cleaning by your dealer or qualified service technician is recommended to prevent malfunction and/or sooting. TURN OFF HEA TER AND ALLOW T O COOL BEFORE CLEANING. Remove logs, handling carefully by holding gently at each end.
Page 23 23099-1-0707 If the gas quality is bad, your pilot may not stay lit, the burners may produce soot and the heater may backfire when lit. If the gas quality or pressur e is low , contact your local gas supplier immediately . 1. When ignitor button is pr essed, ther e is no spark at ODS/ pilot.
Page 24 23099-1-0707 Parts can be ordered only through your service person or dealer . For best results, the service person or dealer should order parts through the dis- tributor . Parts can be shipped directly to the service person/dealer . All parts listed in the Parts List have a Part Number .
Page 25 23099-1-0707 VFDR SERIES P AR TS VIEW 1 2 3 4 5 6 7 8 9 10 1 1 12 14 13 17 18 19 20 23 24 1 2 3 4 5 6 7 8 9 10 1 1 12 14 13 17 18 19 20 23 24 1 2 3 4 5 6 7 8 9 10 1 1 12 14 15 16 13 17 18 19 2.
Page 26 23099-1-0707 Attention: When ordering parts, it is very important that part number and description of part coincide. USE ONL Y MANUF ACTURER'S REPLACEMENT P AR TS. USE OF ANY OTHER P AR TS COULD CAUSE INJUR Y OR DEA TH. VFDR18LB10 P AR TS LIST INDEX NO.
Page 27 23099-1-0707 1 2 3 4 5 6 7 8 9 10 1 1 12 15 16 17 20 21 18” BURNER 28 24 27 25 26 5 PIECE LOG SET 13 14 18 19 22 23 VFDR18LB 10 P AR TS VIEW.
Page 28 23099-1-0707 VFDT SERIES P AR TS LIST Attention: When ordering parts, it is very important that part number and description of part coincide. USE ONL Y MANUF ACTURER'S REPLACEMENT P AR TS. USE OF ANY OTHER P AR TS COULD CAUSE INJUR Y OR DEA TH.
Page 29 23099-1-0707 VFDT SERIES P AR TS VIEW 27 28 29 30 32 33 31 7 PIECE LOG SET 32 27 30 28 29 5 PIECE LOG SET 1 2 3 4 5 6 7 8 9 10 1 1 12 13 14 17 18 21 22 18” BURNER 24” BURNER 30” BURNER 2.
Page 30 23099-1-0707 VFDM SERIES P AR TS LIST Attention: When ordering parts, it is very important that part number and description of part coincide. USE ONL Y MANUF ACTURER'S REPLACEMENT P AR TS. USE OF ANY OTHER P AR TS COULD CAUSE INJUR Y OR DEA TH.
Page 31 23099-1-0707 VFDM SERIES P AR TS VIEW 1 2 3 4 5 6 7 8 9 10 23 1 2 3 4 5 6 7 8 9 10 1 1 12 17 23 1 2 3 4 5 6 7 8 9 10 21 22 23 18” BURNER 24” BURNER 30” BURNER 32 27 30 28 29 27 28 29 30 .
Page 32 23099-1-0707 Empire Comfort Systems, Inc. 918 Freeburg A ve. Belleville, IL 62220 PH: 618-233-7420 or 800-851-3153 F AX: 618-233-7097 or 800-443-8648 info@empirecomfort.
An important point after buying a device Empire Comfort Systems VFDM30LBN-1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Empire Comfort Systems VFDM30LBN-1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Empire Comfort Systems VFDM30LBN-1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Empire Comfort Systems VFDM30LBN-1 you will learn all the available features of the product, as well as information on its operation. The information that you get Empire Comfort Systems VFDM30LBN-1 will certainly help you make a decision on the purchase.
If you already are a holder of Empire Comfort Systems VFDM30LBN-1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Empire Comfort Systems VFDM30LBN-1.
However, one of the most important roles played by the user manual is to help in solving problems with Empire Comfort Systems VFDM30LBN-1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Empire Comfort Systems VFDM30LBN-1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
