Instruction/ maintenance manual of the product FAW-40-1SPP Empire Comfort Systems
Go to page of 36
12427-2-0903 Page 1 INST ALLA TION INSTRUCTIONS AND OWNER'S MANUAL F AN TYPE VENTED WALL FURNACE MODEL F A W -40-1SPP F A W -40-1IP EFFECTIVE DA TE SEPTEMBER 2003 WARNING: If the information in this manual is not followed exactly , a fir e or explosion may result causing pr operty damage, personal injury or loss of life.
12427-2-0903 Page 2 The base referred to above does not mean the fire-proof base as used on wood stoves. The protection is for rugs that are extremely thick and light colored tile.
12427-2-0903 Page 3 Some people cannot smell well. Some people cannot smell the odor of the chemical stench put into the gas. You must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor.
12427-2-0903 Page 4 furnace opening confined space Figure 1 Outdoor Air Outlet and inlet air can be brought into the confined space via openings into a ventilated attic and ventilated crawl space.
12427-2-0903 Page 5 C. 4 " (102mm) Oval In-The-Wall (all parts purchase locally) 1. Type B-1 oval pipe or B-W vent pipe 2. Type B-1 oval elbows or B-W oval elbows 3. Single story type B-1 or (B-W) gas vents require a baseplate and one pair of ceiling plate spacers.
12427-2-0903 Page 6.
12427-2-0903 Page 7 8. Align clearance holes on 6" x 10" (152mm x 254mm) duct with screw holes on inner casing back and mark duct to be 2 1/4" (57mm) shorter than 8" x 12" (203mm x 305mm) boot. Remove duct and cut to proper length.
12427-2-0903 Page 8 Attention! If one of the above procedures results in pressures in excess of 1/2 psig (14" w.c.) (3.5 kPa) on the appliance gas valve, it will result in a hazardous condition. Checking Manifold Pressure Both Propane and Natural gas valves have a built-in pressure regulator in the gas valve.
12427-2-0903 Page 9 Oiling the Motor The fan motor should be cleaned and oiled once each heating season. Oil holes are located on the top at each end of the motor. Use a few drops of #10 motor oil. To clean the motor, blow air through its ventilation openings with a vacuum cleaner or low pressure air source.
12427-2-0903 Page 10 SERVICE AND MAINTENANCE SUGGESTIONS CALL SERVICEMAN GENERAL: All furnaces have been fire-tested to check for proper operation. This includes, main burner flame, pilot flame, fan operation, fan control, limit control and automatic valve operation.
12427-2-0903 Page 11 FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand.
12427-2-0903 Page 12 FOR YOUR SAFETY READ BEFORE OPERA TING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance is equipped with an ignition device which automatically lights the pilot.
12427-2-0903 Page 13 ST AR T System Check END SEQUENCE OF OPERA TION T rial for Ignition Main Burner Operation Apply 24 V AC to Appliance Thermostat Calls for Heat Flame Signal Detected Internal Check.
12427-2-0903 Page 14 SmartV alve ™ System T roubleshooting Sequence Note: Before T roubleshooting, Become Familiar with the Sequence of Operation IP SYSTEM TROUBLESHOOTING SEQUENCE NO NO NO YES YES .
12427-2-0903 Page 15 INDEX PART NO. NUMBER DESCRIPTION INDEX PART NO. NUMBER DESCRIPTION PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide.
12427-2-0903 Page 16.
12427-2-0903 Page 17 Service Notes.
12427-2-0903 Page 18 Empire Comfort Systems, Inc. Nine Eighteen F reeburg A ve . Belle ville, Illinois 62220-2623 PH: 1-618-233-7420 PH: 1-800-851-3153 F AX: 1-618-233-7097 F AX: 1-800-443-8648 E-MAIL: inf o@empirecomfor t.com WEB SITE: www .empirecomf or t.
12427(F)-2-0903 Page 1 INSTRUCTIONS POUR L ’INST ALLA TION ET MANUEL DU PROPRIÉT AIRE RADIA TEUR MURAL À CIRCULA TION FORCÉE ET A VEC ÉV ACUA TION MODÈLE F A W -40-1SPP F A W -40-1IP DA TE D’.
12427(F)-2-0903 Page 2 Introduction Toujours consulter le département de construction de votre région en ce qui regarde les règlements, les codes ou les ordonnances qui s’appliquent à l’installation d’un radiateur mural avec évacuation. Instructions pour l'Installateur 1.
12427(F)-2-0903 Page 3 INFORMATION DE SÉCURITÉ POUR LES UTILISATEURS DE PROPANE Le propane est un gaz inflammable qui peut causer des feux et des explosions.
12427(F)-2-0903 Page 4 ATTENTION: L’air de combustion ne doit pas provenir d’un espace chauffé lequel inclus des ventilateurs soufflants, foyers ou d’autres appareils qui peuvent produire une pression négative dans l’espace.
12427(F)-2-0903 Page 5 B. BRAC KET BASEPLATE 4 " B- 1 OVAL C. BASEPL A TE SPACER 4" B-1 OVAL 4" 45 DEG. O V AL ELBOW S C. SPACER BASEPL A TE 4" B-1 OVAL A. VENT ENC LOSURE AD APTER BASEPL A TE SI DE FRONT 4" ROUN D WALL Figure 4 B.
12427(F)-2-0903 Page 6 Pour installer le SOK-1, s’il vous plaît utilisé les étapes 1 jusqu’à 5 dans les instructions du SOR-1 pour les radiateurs FAW-40.
12427(F)-2-0903 Page 7 arrière pour former un carré. Percer un trou pilote à l’intérieur du carré que vous avez tracé sur la paroi extérieure arrière. Enlever la feuille de métal à l’intérieur du carré que vous avez tracé, avec des ciseaux à métal ou un outil comparable.
12427(F)-2-0903 Page 8 Figure 8 Méthode pour installer un collecteur de sédiment avec un adapteur en T L’emploi des connexions de gaz suivantes est recommandé. — ANS Z21.24 Connexions d’appareil de tuyaux et de raccords en métal ondulé. — ANS Z21.
12427(F)-2-0903 Page 9 sources de chaleur (cuisinière, chauffe-eau, etc.) incluant les murs ou encadrements de porte ayant une source de chaleur dans la pièce avoisinante.
12427(F)-2-0903 Page 10 Figure 13 BU RNER BOX GAS VAL VE J UNC TION BOX- TRANS FORMER LIMIT SWITCH FAN SWITCH VENT LIMIT SW ITCH FLUE CONNECTOR FAN PI EZO I GNITOR DRAFT DIVERTER Figure 14 SUGGESTIONS POUR LE SERVICE ET L’ENTRETIEN. Appeler un technicien d’entretien.
12427(F)-2-0903 Page 11 Veilleuse modèle IP Ce radiateur utilise un système “Smart Valve” Honeywell pour l’allumage intermittent de la veilleuse.
12427(F)-2-0903 Page 12 1. Arrêter! Lire les informations de sécurité ci-dessus. 2. Mettre le thermostat à son plus bas réglage. 3. Éteindre tout pouvoir électrique à l’appareil. 4. Enlever le panneau d’accès au contrôle (panneau du bas avant).
12427(F)-2-0903 Page 13 1. Arrêter! Lire les informations de sécurité ci-dessus. 2. Mettre le thermostat à son plus bas réglage. 3. Éteindre tout pouvoir électrique à l’appareil. 4. Cet appareil est muni d’un dispositif d’allumage lequel allume automatiquement la veilleuse.
12427(F)-2-0903 Page 14 D é part V é rification du Syst è me FIN S é quence de Fonctionnement Essai d'Allumage Fonctionnement du Br û leur Principal Appliquer 24 V AC à l'appareil Ther.
12427(F)-2-0903 Page 15 Guide de d é tection des d é fectuosit é s pour le syst è me "Smart V alve" Note: A vant que les d é fectuosit é s apparaissent, familiarisez-vous avec les s é quences de defonctionnement.
12427(F)-2-0903 Page 16 Index Part No. Number Description Index Part No. Number Description PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide.
12427(F)-2-0903 Page 17.
12427(F)-2-0903 Page 18 Empire Comfort Systems, Inc. Nine Eighteen F reeburg A ve . Belle ville, Illinois 62220-2623 PH: 1-618-233-7420 PH: 1-800-851-3153 F AX: 1-618-233-7097 F AX: 1-800-443-8648 E-MAIL: inf o@empirecomfor t.com WEB SITE: www .empirecomf or t.
An important point after buying a device Empire Comfort Systems FAW-40-1SPP (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Empire Comfort Systems FAW-40-1SPP yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Empire Comfort Systems FAW-40-1SPP - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Empire Comfort Systems FAW-40-1SPP you will learn all the available features of the product, as well as information on its operation. The information that you get Empire Comfort Systems FAW-40-1SPP will certainly help you make a decision on the purchase.
If you already are a holder of Empire Comfort Systems FAW-40-1SPP, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Empire Comfort Systems FAW-40-1SPP.
However, one of the most important roles played by the user manual is to help in solving problems with Empire Comfort Systems FAW-40-1SPP. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Empire Comfort Systems FAW-40-1SPP along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
