Instruction/ maintenance manual of the product ERC-2 Emotiva
Go to page of 23
.
.
3" " TABLE OF CONTENTS Thank You for your ERC -2 Purchase 5 Limited Warran ty 6 Service Assistance For t he ERC-2 6 Emotiva Disclosure 7 FCC Compliance 7 Safety Precautions 8 A Note for the .
4" " TROUBLESHOOTING 20 The disc does not rotate 20 The disc is playing but there is no sound 20 The disc stops, noise is heard or the sound drops out 20 A CD- R / CD-RW disc cannot be playe.
5" " THANK YOU FOR Y OUR ERC -2 PURCHASE Dear Music Enthusiast, Thank you for purchasing the Emotiva ERC-2 CD Player. We sincerely believe that it offers you outstanding performance and value. Emotiva products are engineered and produced with the highest quality materials and incorporate the latest technology.
6" " LIMITED WARRANTY The Emotiva ERC-2 CD Player has been created to perform flawlessly for many years. As a result of this quality and craftsmanship, Emotiva offers the following warranty to owners of the ERC-2.
7" " E motiva Di sclosur e Copyright 2011 Emotiva All Rights Reserved. Emotiva reserves the right to make improvements to its products at any time. Therefore, the specifications of the product and the specific details of this manual are subject to change at any time.
8" " S AFETY PRECAU TIONS Read this User's Guide thoroughly before attempting to install and configure the ERC-2 CD Player. All the safety and operation instructions should be read before any operation of the component(s) begin.
9" " A Note for the Cable Television (CATV) Installer This reminder is to call the CATV system installer's attention to Article 82040 of the NEC that provides guidelines for proper grou.
10 " " TECHNICAL SPECIFICATIONS • Nominal output voltage: 2V rms • Channel separation: ≥ 95dB - ref. 1kHz • Frequency response: 20Hz~20kHz (+/- 0.
11 " " ADDITIONAL FEATURES Four (4) independent power supplies drive each section of the unit independently . This prevents interactions and noise. The separate power supplies drive: 1. CD mechanism 2. D igital electronics 3. A nalog electronics 4.
12 " " DISC HANDLI NG Use only discs with regular shapes. If an irregular disc (a disc with a special shape) is used the ERC-2 may be damaged. Discs usable with the ERC-2 CD Audio (CD-DA), CD- R, CD - RW , HDCD Holding discs Avoid touching the surface of a disc where recording is performed.
13 " " FRONT PANEL LAYOUT 1. PLAY/PAUSE This is used to play and pause the disc. 2. PREVIOUS This is used to jump to the start of the current track or to jump to the start of the previous track. 3. NEXT This is used to advance to the start of the next track.
14 " " REAR PANEL LAYOU T 1. BALANCED OUTPUTS (1 set ) These are used to connect the ERC-2 to an input device (pre/pro, receiver) with balanced (XLR) type cables. 2. ANALOG OUTPUTS (2 sets) These are used to connect the ERC-2 to an input device , ( DAC, pre/pro, receiver) with RCA type cables.
15 " " REMOTE CONTROL 1. EJECT Ejects the disc from the unit. 2. DIM This is used to dim the display light. It also turns off the halo light and the lights for all the front panel buttons except the On/Standby button. 3. STANDBY Switches the unit between On and Standby mode.
16 " " 11 . A -B This allows you to loop a certain section of a track, a full track, multiple tracks etc. Press once to start the loop, press again where you want the loop to end. The player will now play the section between the two l oop points.
17 " " CHANGING THE REMOTE CONTROL BATTERI ES Emotiva recommends using high quality AAA batteries in the ERC-2 remote control. To change the remote control batteries you will need a flat tip.
18 " " OPERATING I NSTRUCTIONS LOADING & EJECTING DISCS 1. Press the Standby/On button, make sure unit is on. 2. The display will read EMOTIVA for a few seconds at power up. LOADING will then appear on the screen. The player will then say READY .
19 " " LOCATING A PARTICULAR POINT IN A TRACK 1. Make sure that the disc is playing the desired track. 2. Press the Left REV Button on the remote control, the CD will then rewind within the track. Press again and the disc will rewind faster.
20 " " TROUBLESHOOTING • The disc does not rotate 1. Is the power cable plugged in? 2. Is the power switch on? 3. Is the disc placed upside down? 4. Is the disc dirty? 5. Is the disc scratched? 6. Is the disc warped? • The disc is playing but there is no sound 1.
21 " " IMPOR TAN T USER INFORMATION C AUTION – The use of controls or adjustments or performance of procedures other than those specified herein ma y result in hazardous radiation exposure. CAUTION – No user serviceable parts inside unit.
22 " " Revised 0 5 /6/20 11 All contents © 2011 Emoti va Audio Corporat ion..
23 " ".
An important point after buying a device Emotiva ERC-2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Emotiva ERC-2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Emotiva ERC-2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Emotiva ERC-2 you will learn all the available features of the product, as well as information on its operation. The information that you get Emotiva ERC-2 will certainly help you make a decision on the purchase.
If you already are a holder of Emotiva ERC-2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Emotiva ERC-2.
However, one of the most important roles played by the user manual is to help in solving problems with Emotiva ERC-2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Emotiva ERC-2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
