Instruction/ maintenance manual of the product ZGS 782 IT Electrolux
Go to page of 32
ZGS 782 IT ZGS 782 ICT Gas hob Instruction booklet IE GB.
2 Thank you for selecting our appliance Thank you for selecting our appliance Thank you for selecting our appliance Thank you for selecting our appliance Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances.
3 Contents Important Safety Information Important Safety Information Important Safety Information Important Safety Information Important Safety Information ......................................................... .....................................
4 Important Safety Information Y Y Y Y Y ou MUST r ou MUST r ou MUST r ou MUST r ou MUST r ead these war ead these war ead these war ead these war ead these war nings car nings car nings car nings car.
5 z Ensure the control knobs are in the ‘OFF’ position when not in use. z When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance. z Unstable or misshapen pans should not be used on the hob as unstable pans can cause an accident by tipping or spillage.
6 Description of the Hob 1 . Hob T op 2 . Auxiliary Burner 3 . Semi-rapid Burner 4 . Rapid Burner 5 . T riple Crown 6 . Control knobs 1 3 6 4 5 2 3.
7 INSTALLATION Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered Any gas instal.
8 Lighting the burners Lighting the burners Lighting the burners Lighting the burners Lighting the burners For easier lighting, proceed before putting For easier lighting, proceed before putting For e.
9 Do not keep the control knob pressed for more than 15 seconds. If the burner does not light even after 15 seconds, release the control knob, turn it the "off" position and wait for at least one minute before trying to light the burner again.
10 As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering. Use only pans or pots with flat Use only pans or pots with flat Use only pans or pots with flat Use only pans or pots with flat Use only pans or pots with flat bottom.
11 Before any maintenance or cleaning can be carried out, Before any maintenance or cleaning can be carried out, Before any maintenance or cleaning can be carried out, Before any maintenance or cleani.
12 Pay attention when replacing the pan Pay attention when replacing the pan Pay attention when replacing the pan Pay attention when replacing the pan Pay attention when replacing the pan supports in .
13 Something Not W orking? If the hob is not working corr ectly , please carry out the following checks before contacting your local Service Force Centre. SYMPTOM SYMPTOM SYMPTOM SYMPTOM SYMPTOM There is no spark when lighting the gas. The gas ring bur ns unevenly .
14 OVERALL DIMENSIONS OVERALL DIMENSIONS OVERALL DIMENSIONS OVERALL DIMENSIONS OVERALL DIMENSIONS Width: 744 mm Depth: 510 mm CUT OUT DIMENSIONS CUT OUT DIMENSIONS CUT OUT DIMENSIONS CUT OUT DIMENSION.
15 BURNER RAPID SEMI-RAPID AUXILIARY TRIPLECROWN POSITION M A X M I N M A X M I N M A X M I N M A X M IN NOMINAL THERMAL POWER kW 3 . 0 0.75 2.0 0.45 1.0 0.33 4.0 1.2 NOMINAL FLOW RATE m 3 / h 0.286 0.057 0.190 0.038 0.095 0.028 0.381 0.114 NOZZLE REFERENCE 11 9 Adjust.
16 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.
17 Installation IMPOR IMPOR IMPOR IMPOR IMPOR T T T T T ANT ANT ANT ANT ANT This hob must be installed by a competent person to the This hob must be installed by a competent person to the This hob mus.
18 A) End of shaft with nut B) Washer C) Elbow FO 0264 It is important to install the elbow corr It is important to install the elbow corr It is important to install the elbow corr It is important to .
19 2 B B B B B uilding over a kitchen unit uilding over a kitchen unit uilding over a kitchen unit uilding over a kitchen unit uilding over a kitchen unit with door with door with door with door with .
20 Fitting the Hob into the W orktop Carry out the building in of the hob as follows: • place the seals supplied with the hob on the front edge of the cut out. Then, place them at 86 mm from the side edges and at 10 mm from the rear edge, as shown in the diagram, taking care that the seals meet without overlapping.
21 Electrical Connections Any electrical work required to install this hob should be Any electrical work required to install this hob should be Any electrical work required to install this hob should .
22 Wiring diagram Permanent Connection Permanent Connection Permanent Connection Permanent Connection Permanent Connection In the case of a permanent connection, it is necessary that you install a dou.
23 Fault Finding Preliminary Electrical Systems Check Preliminary Electrical Systems Check Preliminary Electrical Systems Check Preliminary Electrical Systems Check Preliminary Electrical Systems Check START START START START START Isolate appliance and carry out: A: A: A: A: A: Earth Continuity check.
24 A. EARTH CONTINUITY CHECK A. EARTH CONTINUITY CHECK A. EARTH CONTINUITY CHECK A. EARTH CONTINUITY CHECK A. EARTH CONTINUITY CHECK Appliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjust zero if necessary . — T est leads from any appliance earth point to earth pin on plug.
25 Check gas supply at burner Ignition System / Gas Ignition Ignition System / Gas Ignition Ignition System / Gas Ignition Ignition System / Gas Ignition Ignition System / Gas Ignition YES YES YES YES.
26 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. T o do this, follow the pr ocedure below . 1) T ur n the gas tap to the MAX position and ignite. 2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times.
27 Conversion from Natural Gas to LPG IMPOR IMPOR IMPOR IMPOR IMPOR T T T T T ANT ANT ANT ANT ANT The replacement/conversion from natural gas to LPG should only The replacement/conversion from natural.
28 Guarantee/Customer Service Standard guarantee conditions Standard guarantee conditions Standard guarantee conditions Standard guarantee conditions Standard guarantee conditions We, Zanussi-Electrol.
29 Service and Spare Parts Service and Spare Parts Service and Spare Parts Service and Spare Parts Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase .
30 This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law.
31.
356994801 01/08 R.0 www .zanussi-electrolux.co.uk.
An important point after buying a device Electrolux ZGS 782 IT (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux ZGS 782 IT yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux ZGS 782 IT - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux ZGS 782 IT you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux ZGS 782 IT will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux ZGS 782 IT, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux ZGS 782 IT.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux ZGS 782 IT. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux ZGS 782 IT along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
