Instruction/ maintenance manual of the product SANTO 1454-6 iU Electrolux
Go to page of 28
ÖKO-SANT O 1454-6 iU Built-In Refriger ator Oper ating and Installation Instructions.
Dear customer , Before placing your new r efrigerator/fr eezer into operation please r ead these operating instructions car efully . They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for futur e refer ence.
3 Contents Important Safety Instruction s . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Dis posal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Appliance P ackaging Information .
4 Important Safety Instructions These warnings ar e provided in the inter ests of your s afety . Ensur e you fully understand them befor e installing or u sing the appliance. Y our safety i s of paramount importance. If you ar e unsure about the meaning of these warnings contact the Cu stomer Care Department for assi stance.
5 themselves in the appliance when playing (there is risk of suffocation!) or get themselves into other dangerous situations. • Often children cannot r ecognise the hazards pr esent in household appliances.
6 Disposal Appliance P ackaging Information All materials are envir onmentally friendly . They can be dumped or burned at an incinerating plant without danger . About the materials: The plastics can be recycled and ar e identified as follows: >PE< for polyethylene, e.
7 Y ou can remove any r emnants of adhesive using white spirit. Remove all adhesive tape and packing pieces from the interior of the appliance. Installation Installation Location The appliance should be set up in a well ventilated, dry r oom. Energy use is affected by the ambient temper ature.
8 Reversing the door The side at which the door opens can be changed fr om the right side (as supplied) to the left side, if the installation site r equires. Warning! When changing the side at which the door opens, r emove plug from the mains. Left door opening: Remove the grid from the appliance by pulling it towards.
9 To r everse the opening dir ection of the door , proceed as shown in the figures:.
10 Changing over the fr eezer compartment door Open the freezer compartment door a little way . Using a small screwdriver , press the spring in the opening of the lower door bearing slightly upwards and take the door bearing out complete with the door .
Remove covering and adjust the bracket locking nuts. Push the appliance into place. The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess.
12 Mounting furniture door ☞.
Screw appliance into place. Place the covering strip. ☞ ☞ 13.
Fitting the plinth Important! For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=1 00 mm, the plinth may be fitted without adjustments.
Electrical Connection Any electrical work requir ed to install this appliance should be carried out by a qualified electrician or competent person. WARNING – THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability s hould these safety mea- sures not be observed.
Description of the appliance View of the appliance ➀ ➁ ➂ ➃ 16 ➄ ➅ ➆ ➀ Butter/cheese compartment ➁ Sliding shelf ➂ Bottle shelf ➃ Vegetable dr awers ➄ Storage shelves ➅ Thermostat ➆ Frozen food stor age/freezing food, icemaking.
17 Starting up and temper ature r egulation Connect the appliance to the mains electricity supply . When the refriger ator compartment door is opened, the internal light- ing is switched on. The temperatur e selector knob is located on the right hand side of the refriger ator compartment.
Interior Accessories Stor age shelves/wire tr ays Various glass or plastic stor age shelves and wire tr ays are included with your appliance - different models have differ ent combinations.
Fr eezing and storing frozen food The freezer compartment is for fr eezing and storing food. Important! • The temperatur e in the freezer compartment must be –18°C or col- der before fr eezing fresh food or storing food alr eady frozen. • Do not freeze too lar ge a quantity at any one time (max.
Pr eparation of Ice Cubes Fill the ice cube tray 3/4 full with cold water , place it in the fr eezer compartment and leave to freeze. To loosen the fr ozen cubes, either bend the ice cube tray or hold it under running water for a few seconds.
21 Remove frozen food, wr ap it in several layer s of newspaper and store it, covered, in a cool place. Switch off the appliance and unplug it, or disconnect fr om the elec- tricity supply . Remove the stopper from the meltwater outlet and place a bowl underneath it to catch the meltwater .
• Never clean the appliance with a steam cleaner . Moisture could accumulate in electrical components and there is a danger of an electrical shock. Hot vapours can lead to the damage of plastic parts. • The appliance must be dry before it is placed back into service.
23 Ene r gy Saving Tips • Do not install the appliance near boile r s, r adiato r s or other sou r ces of heat. High ambient tempe r atu r es cause longe r , mo r e f r equent ope r ation of the comp r esso r . • Ensu r e sufficient air ci r culation and exhaust at the appliance base and at the back wall of the appliance.
24 Symptom Appliance does not work. P ossible Cau se Appliance is not switched on. Mains plug is not plugged in or is loose. Fuse has blown or is defective Socket is defective. Mains malfunctions are to be corrected by an electrician. The food is too warm.
25 Changing the light bulb Warning! Ther e is a risk of electric shocks! Before changing the light bulb , switch off the appliance and unplug it, or disconnect from the power supply . Light bulb data: 220-240 V, max. 15 W To switch off the appliance, turn the thermostat knob to position "0".
26 Service & Spare P arts In the event of your appliance requiring service, or if you wish to pur- chase spare parts, contact your local AEG Service For ce Centre by telephoning: 087 05 929929 Y our call will be automatically routed to the Service For ce Centre cov- ering your post code area.
27 Noises during Oper ation The following noises are char acteristic of refriger ation appliances: • Clicks Whenever the compressor switches on or off, a click can be hear d. • Humming As soon as the compressor is in oper ation, you can hear it humming.
AEG Hausgeräte GmbH P ostfach 1 036 D-90327 Nürnberg http://www .aeg.hausgeraete.de © Copyright by AEG 0 1-1 199 2222 682-23.
An important point after buying a device Electrolux SANTO 1454-6 iU (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux SANTO 1454-6 iU yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux SANTO 1454-6 iU - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux SANTO 1454-6 iU you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux SANTO 1454-6 iU will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux SANTO 1454-6 iU, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux SANTO 1454-6 iU.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux SANTO 1454-6 iU. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux SANTO 1454-6 iU along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
