Instruction/ maintenance manual of the product EUN 12300 Electrolux
Go to page of 20
INST R UCTION BOOKLET 2222 753-5 5 EUN 12 300 free z er UK.
2 Prior to Inst allation • Check the appliance for transport damage. Under no circumstance should a damaged appliance be installed. In the event of damage please cont act your retailer . Inst allation • This appliance is heavy . Care should be taken when moving it.
3 Servicing • This product should be serviced by an authorised engineer and only genuine spare p arts should be used. • Under no circumstances should you attempt to repair the appliance yourself. Rep airs carried out by inexperienced persons may cause injury or serious malfunctioning.
4 Content s Instructions for the User Import ant Safety Instructions . . . . . . . . . . . . . . . .2 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Before use / S tarting your appliance . . . . . . . . . . .5 T emperature control / W arning light (red) .
Before use Remove all securing t apes. W ash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linge r . Dry thoroughl y . 5 Operation Freezer controls S t arting your appliance Insert the plug into the wall socket .
6 compartment. Y ou should never freeze more than 16 Kg. of fresh food at an y one time . Once the food is completely frozen (which could take up to 24 hours) the fast freeze function can be ended at any time by depressing the button ➃ ➃ again. The yellow light ➂ ➂ goes out.
7 • Keep the freezer door closed as much as possible. • Do not push food together too much, try to allow air to circulate around each item. • Cool cooked food as quickly as possible but do NOT place in the freezer until cool.
8 The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 1/4". During this operation it is not necessary to switch off the power supply or to remove the foodstuffs.
9 Maintenance and Cleaning W arning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply . Import ant This appliance cont ains hydrocarbons in it s cooling unit maintenance and recharging must therefore only be carried out by authorised technicians.
10 Something not W orking? Before contacting your local Service Force Centre check the following point s. IMPORT ANT : If you call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
11 Service and S p are Part s In the event of your appliance requiring service, or if you wish to purchase spare p arts, please contact your local Service Force Centre by telephoning:- 08705 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area.
St andard guarantee conditions We, Electrolux, undert ake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of fau.
The appliance’s door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet.
14 Electrical Connection W ARNING THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut of f and the appropriate plug fitted.
15 Building in Dimensions of the recess Height of housing mm 880 Depth of housing mm 550 Width of housing mm 560 It is necessary that the cabinet has a ventilation recess with the following dimensions: Depth 50 mm Width 540 mm For appropriate venting, follow indications in the figure.
16 PR167 Ha Hb 8m m 6. Place guide (Ha) on the inside p art of the furniture door , up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 8. Open the appliance door and the furniture door at 90°.
17 10. Place the small square on the guide again and fix it with the screws supplied. Should the alignment of the furniture door be necessary , use the clearance of slots. At the end of this procedure, it is necessary to check if the door of the furniture closes properly .
.
.
© Electrolux plc 2006 ELECTROLUX HOME PRODUCTS OPERA TIONS EUROPE.
An important point after buying a device Electrolux EUN 12300 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux EUN 12300 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux EUN 12300 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux EUN 12300 you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux EUN 12300 will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux EUN 12300, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux EUN 12300.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux EUN 12300. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux EUN 12300 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
