Instruction/ maintenance manual of the product ERU 6374 Electrolux
Go to page of 20
INSTR UCTION MANU AL 2222 682-64 ERU 6374 refriger ator UK.
2 General Safety ¥ This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorised technicians. ¥ T ake utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages.
3 Servicing ¥ This product should be serviced by an authorised engineer and only genuine spare parts should be used. ¥ Under no circumstances should you attempt to repair the appliance yourself.Repairs carried out by inexperienced persons may cause injury or serious malfunctioning.
➀ Dairy compartment ➁ Bottle storage shelf ➂ Salad bins ➃ Storage shelves ➄ Thermostat control ➅ Freezer compartment ➀ ➁ ➂ ➃ ➄ ➅ 4 Description of the Appliance Operation Before use Remove all securing tapes. W ash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.
5 Meat can only be stored safely in this way for one or two days at the most. Fruit & vegetables: these should be thoroughly cleaned and placed in the bottom salad bin. Butter & cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible.
6 Making ice cubes The appliance is provided with a plastic ice cube tray . Fill the tray 3/4 full to allow the ice to expand and place it in the -star compartment.
7 Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located below the appliance, where it evaporates.
8 W arning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply . Important This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians.
9 Something not W orking? Before contacting your local Service Force Centre check the following points. IMPORT ANT : If you call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
10 Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning:- 08705 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area.
11 Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of fa.
DIMENSIONS Height 81,5 cm Width 59,6 cm Depth 54 cm POWER SUPPL Y VOL T AGE AND FREQUENCY 220-240 V / 50 Hz TOT AL POWER ABSORBED 80 W A VERAGE DAIL Y UNITS ELECTRICITY (*) 0,75 kWh TOT AL GROSS CAP A.
13 Door reversal T o reverse the opening direction of the door , proceed as shown in the figures: 1 1 2 3 4 5 6 8 7 2 3 10 11 9 12 13 Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.
14 Inner door reversal 180 ° mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the Green and the Y ellow (earth) wire to the terminal in the plug which is marked with the letter ÇEÈ or the earth symbol , or coloured green and yellow .
15 Building-in Before carrying out any work, remove the plug from the power socket. Grid preparation Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure).
16 5. Screw appliance into place and retain the cabinet with screws through the securing brackets into the worktop or adjacent woodwork as necessary . 5 4. If necessary , pads are supplied for the rear feet to make sliding the appliance in and out of the recess easier .
17 6. T o mount the furniture door proceed as shown in the figures: 7 8 ab clic clic c C C 6 a b 10 1 2 3 4 C 9 b a = = 1 2 UPPER P ART OF KITCHEN FURNITURE P ANEL 9/a 275 275 max 100 LOWER P ART OF K.
18 Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. ¥ For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments.
.
© Electrolux plc 2003 ELECTROLUX HOME PRODUCTS OPERA TIONS EUROPE 923 453 666.
An important point after buying a device Electrolux ERU 6374 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux ERU 6374 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux ERU 6374 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux ERU 6374 you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux ERU 6374 will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux ERU 6374, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux ERU 6374.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux ERU 6374. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux ERU 6374 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
