Instruction/ maintenance manual of the product EHG 680 Electrolux
Go to page of 16
Gas hobs Mod. EHG 673 - EHG 680 INSTR UCTION BOOKLET Please read this instruction booklet before using the appliance 35675-8201 GB.
2 This appliance complies with the following E.E.C. Directives: * 73/23 - 90/683 (Low V oltageDirective); * 93/68 (General Directives); * 89/336 (Electromagnetical Compatibility Directive) ; * 90/396 .
3 Content s For the User For the Installer Important Safety Information 2 Description of the Hob 3 Operation 4 Maintenance and Cleaning 4 Something Not Working? 5 Service and S pare Part s 5 Customer .
4 Operation Hob Burners To light a burner: l push the electric ignition pushbutton which is marked by a little spark; l at the same time turn the relevant control knob anticlockwise to maximum position; l then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again.
5 Something Not Working? If the hob is not working correctly , please carry out the following checks before contacting your local Service Force Centre. IMPORT ANT : If you call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
6 Electrolux Guarantee conditions W e, Electrolux, undertake that if, within 12 months of the date of the purchase, this Electrolux appliance or any part thereof is proved to be defective by any reaso.
7 To contact your local Service Force Centre telephone 08705 929 929 CHANNEL ISLANDS GUERNSEY Guernsey Electricity PO Box 4 V ale, Guernsey Channel Islands GY1 3AD JERSEY Jersey Electricity Comp any H.
8 MIDLANDS BIRMINGHAM 66 Birch Road East Wyrley T rading Estate Witton Birmingham B6 7DB BOURNE Pinfold Road Bourne PE10 9HT BRIDGNOR T H 68 St. Marys Street Bridgnorth Shropshire WV16 4DR GLOUCEST.
9 Overall dimensions W idth: 580 mm. Depth: 500 mm. Cut out dimensions W idth: 550 mm. Depth: 470 mm. Ignition HT Spark S park Generator Ispra Control's BF 50066 - 230-240V 0.6 Y A T 120 S par k G ap Fi xe d Rear Lef t Burner (semi-rapid) Heat Input 2.
10 700 mm 400 mm 100 mm 400 mm 50 mm 55 mm 50 mm 650 mm 400 mm 400 mm 100 mm 50 mm 50 mm 55 mm 600 mm FO 0812 FO 0813 Import ant safety requirement s This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition).
11 ON/OFF SWITCH FLEX OUTLET ON/OFF SWITCH FLEX OUTLET FO 0763 FO 0764 1 2 Dimensions are given in mm. Building In Building over a cupboard or drawer If the hob is to be installed abov e a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.
12 Permanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations.
13 A. IGNITOR SWITCH B. IGNITOR UNIT B L N 0 1 2 3 4 5 6 220/240 A Wiring Diagram Fault Finding Preliminary Electrical Systems Check A. EARTH CONTINUITY CHECK - Appliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjust zero if necessary .
14 Ignition System / Gas Ignition YES Check plug top fuse and replace if necessary Check polarity and earth continuity of supply point Check earth continuity of appliance Ignitor does not spark Check .
15 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. T o do this, follow the procedure below . - T urn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times.
CUST OMER CARE Electrolux 55-77 High S treet Slough Berkshire, SL1 1DZ T el: 08705-950950 © Electrolux Household Appliances Limited 2000 Grafiche MDM - Forlì 03/01 The Electrolux Group. The worlds No.1 choice. The Electrolux Group is the world s largest producer of powered appliances for kitchen, cleaning and outdoor use.
An important point after buying a device Electrolux EHG 680 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux EHG 680 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux EHG 680 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux EHG 680 you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux EHG 680 will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux EHG 680, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux EHG 680.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux EHG 680. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux EHG 680 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
