Instruction/ maintenance manual of the product E36GC76EPS Electrolux
Go to page of 20
Installation Instructions Slide In Gas Cooktop 5995447 1 08 E36GC76EPS E48GC76EPS.
2 Safety IMPORT ANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a W arning or Caution based on the risk type.
3 WARNING WARNING WARNING WARNING WARNING • Read all instructions before using the appliance. • Improper installation, adjustment, alteration, service, or maintenance can cause personal injury or property damage. Refer to these instructions and the accompanying Use & Care Manual.
4 Safety WARNING WARNING WARNING WARNING WARNING • Based on safety considerations, the top burner flame should be adjusted so it does not extend beyond the edge of the cooking utensil. • If the information in this manual is not followed exactly , a fire or explosion may result causing property damage, personal injury , or death.
5 Finding Information READ AND SA VE THESE INSTRUCTIONS Read all instructions before installing the cooktop. For your safety , please read and observe all safety instructions. This guide will help you anticipate all installation connections. QUESTIONS? For toll-free telephone support in the U.
6 Finding Information TABLE OF CONTENTS Safety ..................................................................... 2 De fi ni ti on s ........................................................... 2 Important Safety Instructions .......................
7 Prep aring for Inst allation VERIFY P ACKAGE CONTENTS • Literature Pack • Griddle • Bolts/W ashers • Simmer Plate • Burner Grate Pack • W ok Sta nd • Burner Set • S tainless S teel C.
8 Prep aring for Inst allation Plan the installation so that the electrical connection, gas shut-off valve, and pressure regulator are accessible from the front of the cabinet and so that all of the minimum required dimensions are provided. Dimensions apply to both models unless otherwise stated (see Figure 1).
9 Prep aring for Inst allation Provide an opening in the countertop as shown (see Figures 2, 3, 4, 5 and 6). Position the cutout so that minimum clearances are met.
10 Prep aring for Inst allation.
11 Making the Gas/Electric Connection REQUIREMENTS Gas Supply Requirements Check your local building codes for the proper method of installation. In the absence of local codes, this appliance should be installed in accordance with the National Fuel Gas Code ANSI Z223.
12 WARNING WARNING WARNING WARNING WARNING Severe shock, or damage to the cooktop may occur if the cooktop is not installed by a qualified installer or electrician.
13 IMPOR IMPOR IMPOR IMPOR IMPOR T T T T T ANT ANT ANT ANT ANT • If the electrical supply circuit does not have a grounding-type receptacle, it is the responsibility of the customer to have the existing receptacle changed by an electrician to a properly grounded receptacle.
14 Inst allation INST ALLING THE COOKTOP Place and center the cooktop within the cutout. Secure the cooktop to the countertop utilizing the two (2) 1/4-20 bolts provided. Do not overtighten the screws. CONNECTING THE GAS Attach the gas pressure regulator (included with the cooktop) to cooktop pipe nipple inlet.
15 Inst allation GAS AND ELECTRIC REQUIREMENTS TABLE The required voltage, frequency and amperage ratings are listed on the product data plate outside on the cooktop bottom. The gas and electric requirements are also shown in the table below . Mo del No.
16 Inst allation INST ALLING THE BURNER COMPONENTS Burner Components Remove the brass burner rings, porcelain burner caps, and porcelain grates from their shipping packages. Place each burner ring onto its corresponding burner base, being certain that the four alignment tabs slide into the matching notches in the base.
17 Inst allation MAKING THE ELECTRICAL CONNECTION Plug the three-prong plug from the appliance into the properly grounded and polarized wall receptacle. WARNING WARNING WARNING WARNING WARNING • Ensure that the power supply is disconnected before proceeding.
18 Operation VERIFYING THE OPERA TION Before beginning the test procedure, ensure that the gas supply is turned off at the shut-off valve, all cooktop control valves are in the “OFF” position, and all burner rings, burner caps, and grates are properly positioned on the cooktop.
19 Operation T urn on the main gas supply to the cooktop by opening the gas shut-off valve. T est each burner separately by pressing and turning one control knob at a time counterclockwise to the “LITE/HI” position. All ignitors will spark simultaneously .
1-877-4Electrolux www .electroluxusa.com www .electroluxca.com.
An important point after buying a device Electrolux E36GC76EPS (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux E36GC76EPS yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux E36GC76EPS - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux E36GC76EPS you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux E36GC76EPS will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux E36GC76EPS, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux E36GC76EPS.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux E36GC76EPS. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux E36GC76EPS along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
