Instruction/ maintenance manual of the product CHDI 8610 Electrolux
Go to page of 20
DI 8610 CHDI 8610 Cooker Hood Operating and Installation Instructions.
55 Printed on recycled paper AEG - putting words into action Contents Safety warnings 56 For the User 56 For the Installer 56 Description of the Appliance 58 Extractor version 58 Recirculation V ersio.
56 Safety warnings For the User • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames.
57 heaters and gas fires, in the same room. • Hoods can only be used safely with appliances connected to a chimney if the room and/or flat (air/environment combination) is ventilated from outside using a suitable ventilation hole approximately 500-600 cm 2 large to avoid the possibility of a depression being created during operation of the hood.
58 Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter (special accessory). • Y ou will need an original AEG charcoal filter for this function (A vailable from your local AEG Service Force Centre).
59 Hood Operation • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen.
60 Control device for grease and charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the charcoal filter (in the case of recirculation version with charcoal filter). On delivery , the hood is not supplied with an charcoal filter , so the saturation indicator will be disabled.
61 Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild detergent. • Never use corrosive, abrasive or flammable cleaning products.
62 Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • T o do this you will need an original AEG charcoal filter (available from your local Service Force Centre).
63 W arning • Failure to observe the instructions on cleaning the unit and changing the filters could cause a fire hazard. Y ou are therefore strongly recommended to follow these instructions.
64 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply . Check that a fan speed has been selected The cooker hood is not working Check that: ef fectively .
65 T echnical assistance service (not for UK) Y ou are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. When calling, please be ready to specify: 1.
66 T echnical Specifications Dimensions: Height x Width x Depth (in cm) 80-106,5 x 100 x 65 Maximum absorbed power: 250 W Motor absorption: 1 x 170 W Lighting: 4 x20 W Length of the cable: 150 cm Moun.
67 Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply , check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access.
68 Installation - Fig. 6-7-8 Expansion plugs are provided to secure the hood to most types of ceilings. However , a qualified technician must verify suitability of the materials in accordance with the type of ceiling. The ceiling must be strong enough to take the weight of the hood.
69 2a 3 4 4 4 4 4 4 6 6 7 7 7 7 8 8 2a 5 7 9 10 10 10 10 11 11 14,5 273 273 244 214 190 6 12 2b 2b Fig. 6.
70 • For extractor versions (13A), connect the other end of the exhaust pipe to the flue. For filter versions (13F), fit deflector F to the support and secure it to the bracket supplied using 4 screws, then connect the exhaust pipe to the connection ring located on the deflector .
71 15 15 15 15 15 16 16 15 15 13F F 13A 15 14 Fig. 7.
72 19 18 18 18 18 18 18 18 18 18 18 M X 17 17 19 20 X 20 Fig. 8.
LI1R5C AEG Hausger ä te GmbH Postfach 1036 D-90327 N ü rnberg http:// www .aeg.hausgeraete.de http ://www .aeg.co.uk © Copyright by AEG.
An important point after buying a device Electrolux CHDI 8610 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux CHDI 8610 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux CHDI 8610 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux CHDI 8610 you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux CHDI 8610 will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux CHDI 8610, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux CHDI 8610.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux CHDI 8610. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux CHDI 8610 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
