Instruction/ maintenance manual of the product 2460 D Electrolux
Go to page of 20
2460 D Cooker hood Operating and Installation Instructions.
2 Printed on recycled paper AEG - putting words into action.
3 Contents Safety warnings 4 For the User 4 For the Installer 4 Description of the Appliance 6 Extractor version 6 Filter V ersion 6 Control Panel 7 Maintenance and care 8 Cleaning the hood 8 Metal gr.
4 Safety warnings For the User • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames.
5 • It is advisable to apply for authorization from the relevant controlling authority when connecting the outlet to an unused chimney flue or combustion gas duct. The air outlet installation must comply with the regulations laid down by the relevant authorities.
6 Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter • Y ou will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre).
7 Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen.
8 Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild deter- gent. • Never use corrosive, abrasive or flammable cleaning products.
9 Dishwasher Place grease filters in dishwasher . Select the most powerful washing programme and highest temperature, at least 65°C. Repeat the process.
10 Charcoal filter • The charcoal filter should only be used if you want to use the hood in its filtering function. • T o do this you will need an original AEG charcoal filter .
11 Fig. 5 W arning • Failure to observe the instructions on cleaning the unit and changing the filters could cause a fire hazard. Y ou are therefore strongly recommended to follow these instructions.
12 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3.
13 Service and spare parts In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning 08705 929 929 Y our call will be automatically routed to the Service Centre covering your post code area.
14 Guarantee conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser , which must be verified by purchase invoice or similar documentation.
15 Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home. They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances.
16 T echnical Specifications Models 2460 D Dimensions - extractor version (in cm): Height 68-1 13 Width 59 ,8 Depth 4 5 Dimensions - filter version (in cm): Height 67,5-122,5 Width 59 ,8 Depth 4 5 Max.
17 Electrical connection Safety warnings for the electrician The electric outlet should be placed inside the chimney .The hood has a power cable, 150 cm, with earth connection and the rated voltage is 220 - 240 V . Connect the hood to the mains supply via a double pole switch which has 3 mm minimum separation between the contacts.
18 W all unit mounting - Fig. 6 • Only for extractor version: position the upper section of the chimney so that the oulet slots H are not visible (see also A-B-C sequence on on Fig. 6 ). • Fix each other both parts of the hood (1) , make all connections between the two parts (2) and fix with 6 screws (3) .
19 20b 20b 7-16 7-16 4 5 6 12 13 8 9 14 14 15 18 20a 20a 9 8 19 8 9 1 17 2 B G H 11 11 10 1 1 1 1 3 3 3 3 21 22 F 17 12 13 10 22 Fig. 6 A-B-C, Extractor version only! NOTE: 18 not supplied.
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http:// www .aeg.hausgeraete.de © Copyright by AEG LI1UGB Ed. 04/02 LI1UGB Ed. 04/02.
An important point after buying a device Electrolux 2460 D (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux 2460 D yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux 2460 D - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux 2460 D you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux 2460 D will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux 2460 D, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux 2460 D.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux 2460 D. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux 2460 D along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
