Instruction/ maintenance manual of the product RadioLINK Relay Module Ei428 Ei Electronics
Go to page of 7
RADIOLINK RELA Y FOR USE WITH EI168, 405, 405TY & 3105RF Instruction Manual MODEL Ei428 Contains vital information on the products operation and installation. Read and retain carefully . If you are just installing this product the manual MUST be given to the householder .
from the knockout, making sure that there is no gap when mated with ducting/conduit. There is one suitable knockout (the other two surface entries are not recommended as the wiring will reduce the antenna signal).
If momentary relay operation is required, carefully and gently slide the yellow switch to the “ P ” position with a small screw- driver (see figure 1b). This must be done before the mains power is connected or the rechargeable cells are activated.
3. T roubleshooting RF Link If, when checking the radio link interconnection, some of the Ei428 RadioLINK Relays do not respond to the button test, then: (i) Ensure you have held the smoke/heat alarm test button down until the light has come on twice, for 3.
in a particular installation. If this device does cause such interference, which can be verified by turning the device on and off (remove the mains supply and turn of f back up power supply), the user.
7. Getting your RadioLink Base Serviced If your RadioLink Relay fails to work after your have carefully read all the instructions, checked that the unit has been installed correctly , and is receiving AC power (green light on) contact Customer Assistance at the nearest address given at the end of this leaflet.
alarm cancel signal within that period. It switches the relay for 5 seconds with the switch in pulse mode. Low Battery Indication: Red light flashes every 10 seconds. (The green light switches off when the red is on). Size of System: : the recommended maximum number of Radiolink units should not exceed 12 i.
An important point after buying a device Ei Electronics RadioLINK Relay Module Ei428 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Ei Electronics RadioLINK Relay Module Ei428 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Ei Electronics RadioLINK Relay Module Ei428 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Ei Electronics RadioLINK Relay Module Ei428 you will learn all the available features of the product, as well as information on its operation. The information that you get Ei Electronics RadioLINK Relay Module Ei428 will certainly help you make a decision on the purchase.
If you already are a holder of Ei Electronics RadioLINK Relay Module Ei428, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Ei Electronics RadioLINK Relay Module Ei428.
However, one of the most important roles played by the user manual is to help in solving problems with Ei Electronics RadioLINK Relay Module Ei428. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Ei Electronics RadioLINK Relay Module Ei428 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
