Instruction/ maintenance manual of the product 50200 EDGE Tech
Go to page of 9
Caterpillar 3126 B & E models Edge EZ Module Installation Instructions & Manual OLD P/N: ECAT1000 NEW P/N: 50200.
2 Table of Contents DISCLAIMER OF LIABILITY ___________________________________________________ 3 LIMITATION OF WARRANTY __________________________________________________ 3 Installation Instructions .
3 THIS IS A HIGH PERFORMANCE PRODUCT. USE AT YOUR OWN RISK . Do not use this product until you have carefully read the following agreement. This sets forth the terms and conditions for the use of this product.
4 THIS PRODUCT AND THE B OOST ELBOW (if installed) MUST BE REMOVED W HEN TAKING VEHICLE TO VEHICLE D EALERSHIP OR OTHER SER VICE FACILITY!! LEAVING PRODUCT INSTALLED MAY AFFECT DEALER DIA GNOSTIC ANALYSIS AN D SCAN TOOL FUNCTIONS!! This warranty is void for any new products purchased through auction websites.
5 Installation Instructions Please read these instructions through completely and thoroughly understand each step prior to installation . IMPORTANT: Read all Disclaimer, Warranty, and Installation Instructions before installing product Supplied Items: 1.
6 Harness Connector – Your ECAT1000 module may be equipped with a harness that can be disconnected at th e module itself (See figure 1A). It is important to make sure that your ECAT 1000 module is a.
7 Boost Sensor Connection 1. The boost sensor is located on the driver’s side of the engine as shown in the photo. Disconnect the stock connector and plug in the supplied connectors that are located closest to the Power Edge EZ CAT module. IAP Sensor Connection 2.
8 7. Using the 7/16” wrench, unscrew the stoc k brass elbow out of the turbocharger housing. Using the 7/16” wrench, install the supplied brass elbow, tighten-be careful not to over-tighten.
9 Technical Support: 888-360-3343 To expedite your support call, please have part number (i.e., EAF2100A), version number, and Date of Manufacture ready prior to calling support .
An important point after buying a device EDGE Tech 50200 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought EDGE Tech 50200 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data EDGE Tech 50200 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, EDGE Tech 50200 you will learn all the available features of the product, as well as information on its operation. The information that you get EDGE Tech 50200 will certainly help you make a decision on the purchase.
If you already are a holder of EDGE Tech 50200, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime EDGE Tech 50200.
However, one of the most important roles played by the user manual is to help in solving problems with EDGE Tech 50200. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device EDGE Tech 50200 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
