Instruction/ maintenance manual of the product XR-X77 Aiwa
Go to page of 16
U XR-X77 8C-CL2-903-01 020305BSW-H-M For assistance and information (United States and Puerto Rico) Owner’ s record For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below .
2 En W ARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Explanation of Graphical Symbols: The lightning flash with arrowhead symbol, within an equ.
3 En Outdoor Antenna Power lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits.
4 En 3 Connect the supplied antennas. Connect the FM antenna to the FM 75 Ω terminals and the AM antenna to the AM LOOP jack. Connect the FM antenna to the FM 75 Ω terminals without the 2 mark, as illustrated. FM antenna 4 Connect the AC power cord to an AC outlet.
5 En PA RTS AND CONTROLS Main unit 12 3 7 6 5 4 4 z OPEN/CLOSE Opens or closes the disc compartment. 5 s CLEAR CD: stops playback. Radio: clears a preset station. f / r , t / g (TUNING - , + ) CD: skips to a previous or a succeeding track when pressed, searches a track in fast forward or reverse playback when held down.
6 En Remote control 1 4 7 5 6 9 8 ! 0 2 3 Buttons with the same or similar names on the main unit basically have the same function. 1 POWER 2 0–10, +10 CD: selects a track of the specified number . Radio: tunes in the station with the specified preset number .
7 En ADJUSTMENTS BEFORE OPERA TION Power Tu rning the unit on Press POWER 6 ST ANDBY/ON (POWER on the remote control). Alternatively , press TUNER/BAND, AUX or CD. Playback will start automatically if a disc is loaded. Tu rning the unit off Press POWER 6 ST ANDBY/ON again.
8 En This unit plays back finalized CD-R/RW discs as well as audio CDs. Playing a CD 1 Press z OPEN/CLOSE to open the disc compartment. Place a disc with the label side up. Then close the disc compartment by pressing z OPEN/CLOSE. z OPEN/CLOSE 2 Press E to start play .
9 En Programmed play Plays back up to 30 selected tracks in programmed order . 1 Press PROGRAM on the remote control in stop mode. " PRGM " flashes on the display . 2 Press the numbered buttons on the remote control to program a track. -T o select the 25th track, press +10, +10 and 5.
10 En RADIO OPERA TIONS f , g s SHIFT f , g SET s TUNER MODE 0–10, +10 PRESET + , - TUNER/BAND SET TUNER/BAND PRESET POWER T uning in preset stations 1 Select the band. 2 Press PRESET (PRESET + , - 1on the remote control) repeatedly . With each press, the station with the succeeding (or preceding) preset number is tuned in.
11 En Adjustments To switch to monaural FM reception Hold down SHIFT and press TUNER MODE on the remote control so that " MONO " is displayed. To cancel, repeat the above so that " STEREO " is displayed. Tip : When FM stereo reception is poor , switching to monaural reduces noise.
12 En TIMER OPERA TIONS Setting the clock 1 Hold down SHIFT and press CLOCK on the remote control. When the unit is turned off, you can also press SET . 2 Within 6 seconds, press f or g to set the time. Each press changes the time in 1-minute steps. Holding these buttons down will vary the time in 10-minute units.
13 En To check the timer setting Hold down SHIFT and press TIMER on the remote control so that " PLAY " appears on the display . The timer -on time, the source and the timer-activated duration are displayed for 12 seconds. To change the timer setting Reset the timer again.
14 En Care and maintenance Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit. To clean the cabinet Use a soft and dry cloth. If the unit surfaces are extremely dirty , use a soft cloth lightly moistened with mild detergent solution.
15 En Specifications MAIN UNIT CX-LX77 TUNER FM tuning range 87.5 MHz to 108 MHz FM usable sensitivity (IHF) 13.2 dBf FM antenna terminal 75 ohms (unbalanced) AM tuning range 530 kHz to 1710 kHz (10 k.
Printed in Malaysia NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
An important point after buying a device Aiwa XR-X77 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Aiwa XR-X77 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Aiwa XR-X77 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Aiwa XR-X77 you will learn all the available features of the product, as well as information on its operation. The information that you get Aiwa XR-X77 will certainly help you make a decision on the purchase.
If you already are a holder of Aiwa XR-X77, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Aiwa XR-X77.
However, one of the most important roles played by the user manual is to help in solving problems with Aiwa XR-X77. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Aiwa XR-X77 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
