Instruction/ maintenance manual of the product XR-MG9 Aiwa
Go to page of 16
For assistance and information (United States and Puerto Rico) En (English) E (Español) F (Français) MODE D'EMPLOI MANUAL DE INSTRUCCIONES OPERA TING INSTRUCTIONS Compact Disc Stereo System U X.
2 En PRECAUTIONS W ARNING T o reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. “CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
3 En System and accessories Main unit CX-LMG9 Speakers SX-LMG9 Speakers cords Remote control Lithium battery (CR2025) FM antenna AM antenna T ABLE OF CONTENTS PRECAUTIONS .................................... 2 PREP ARA TIONS ..........................
4 En Remote control While sliding the latch, pull out the battery holder from the bottom of the remote control. Place the supplied battery on the battery holder with correct polarity.
5 En Main unit: rear 1 LINE OUT jacks Analog sound signals for CD or radio can be output through these jacks. Use a cable with RCA phono plugs to connect audio equipment. Connect the red plug to the R jack, and the white plug to the L jack. Signals input through the AUX/VIDEO IN jacks are not output from the LINE OUT jacks.
6 En 1 PO WER 6 ST ANDBY/ON Switches the unit on and off (standby). 2 a /SET CD: pauses playback. Radio: stores the received station to preset. s /CLEAR CD: stops playback. Radio: clears a preset station. c /PRESET CD: starts playback. Radio: tunes in a preset station.
7 En Remote control Buttons with the same or similar names on the main unit basically have the same function. 1 0–10, +10 CD: selects a track of the specified number .
8 En ADJUSTMENTS BEFORE OPERA TION Power T urning the unit on Press POWER 6 ST ANDBY/ON (POWER on the remote control). Alternatively , press TUNER/BAND (AUX or CD on the remote control). Playback will start automatically if a disc is inserted. T urning the unit off Press POWER 6 ST ANDBY/ON again.
9 En Setting the clock 1 Hold down SHIFT and press CLOCK on the remote control. When the unit is turned off, you can also press a or ENTER. 2 Press f or g to set the time. Each press changes the time in 1-minute steps. Holding these buttons down will vary the time in 10-minute units.
10 En This unit plays back finalized CD-R/RW discs as well as audio CDs. Playback 1 Press FUNCTION repeatedly (CD on the remote control) to select the CD function. 2 Press z OPEN/CLOSE to open the disc compartment. Place a disc with the label side up.
11 En Programmed playback Plays back up to 30 selected tracks in programmed order . 1 Hold down SHIFT and press PROGRAM on the remote control in stop mode. " PRGM " flashes on the display . 2 Press the numbered buttons on the remote control to program a track.
12 En RADIO OPERA TIONS Manual tuning 1 Press TUNER/BAND repeatedly to select a band. The unit switches to the radio from any other function and alternates between FM and AM. 2 Press f or g repeatedly to tune in a station. " TUNE " is displayed when a station is tuned in.
13 En Adjustments T o switch to monaural FM reception Hold down SHIFT and press TUNER MONO on the remote control so that " MONO " is displayed. T o cancel, press again to display " STEREO ." Tip : When FM stereo reception is poor , switching to monaural reduces noise.
14 En Care and maintenance Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit. T o clean the cabinet Use a soft and dry cloth. If the unit surfaces are extremely dirty , use a soft cloth lightly moistened with mild detergent solution.
15 En Specifications MAIN UNIT CX-LMG9 TUNER FM tuning range 87.5 MHz to 108 MHz FM usable sensitivity (IHF) 13.2 dBf FM antenna terminals 75 ohms (unbalanced) AM tuning range 530 kHz to 1710 kHz (10 .
For assistance and information (United States and Puerto Rico) Printed in China NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
An important point after buying a device Aiwa XR-MG9 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Aiwa XR-MG9 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Aiwa XR-MG9 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Aiwa XR-MG9 you will learn all the available features of the product, as well as information on its operation. The information that you get Aiwa XR-MG9 will certainly help you make a decision on the purchase.
If you already are a holder of Aiwa XR-MG9, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Aiwa XR-MG9.
However, one of the most important roles played by the user manual is to help in solving problems with Aiwa XR-MG9. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Aiwa XR-MG9 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
