Instruction/ maintenance manual of the product DB03505 Drolet
Go to page of 35
READ AND KEEP TH IS MAN UAL FO R REFERENCE 45138A OWNER’S MANUAL SAHARA WOOD STOVE US ENVIRONME NTAL PROTE CTION AGENCY PHASE II CERT IFIED W OOD ST OVE Verified and tested following ULC S627 and UL 1482 Standards by : Manufactured by : STOVE BUILDER INT ERNA TION A L INC.
1 INTRODUCTION Stove Builder I nternational, one of the most important wood stove and fireplac e manufa cturers i n North America, congratulates y ou on your purchase and wishes to help y ou get max imum satisfaction from your wood stove.
2 TABLE OF CONTENTS TECHNICAL SPECIFICATIONS ..................................................................................... 4 TIPS ON WOOD HEATING .............................................................................................. 5 SECTION 1.
3 3.3 NOTES ABOUT FIRST FIRING .......................................................................... 29 3.4 LIGHTING A FIRE ................................................................................................ 29 3.5 MAINTAINING THE FIRE .
4 TECHNICAL SPECIFICATIONS Recomm ended Surfa ce: 1,300 to 2,000 sq. ft. (120 to 185 m 2 ) Maximum heat output (EPA test fuel) : Maximum heat output (seasoned cordwood ): 7.41kW (25,300 BTU) 16.12 kW (55,000 BTU) Maximum efficiency (default EPA effi ciency) : 63% Average em issions (E PA): 7.
5 TIPS ON WO OD HE ATING Wood is a re newabl e energy. It is also a ver y clean h eat sou rce wh en used with appl iances that are certified b y the U.S. Environmental Protection Agen cy (EPA), a stand ard accepted in Canada as w ell. EPA-certified wood sto ves are different than conventional wood stoves .
6 SECTION 1.0 - INSTALLATION When inst alled and operated as described in these instructions, t he Sahara wood stove is suitable for use as a freestanding wood stove in residential installation s. The S ahara wood stove is not int ended for installa tio n in a bedroom or a mobile home.
7 1.3 CLEARANC ES Clearances t o any combustibles when measured directly from the floor protector to t he ceiling must be a minimum of 84" (2134 mm). C learances to any combustibles when m easured di rectly from the front of the stove must be a minimum of 48" (1219 mm).
8 1.3.1 Reduced clearances using shielding You may decrease the mini mum clearances to combustible materials by installing heat radiation shields between the walls or the ceiling and the stove. Those heat radiation shields must be installed permanently , and must be made of a heat-resistant or heat-tolerant material.
9 1.4 FLOOR PROTECTOR I f th e stove is to be installed on top of a combustible floor, it must be guar ded by a non-combust ible material extending at l east 18 ” (300mm ) from th e front and 8” (200mm) from the sides and the back of the fir eb ox.
10 SECTION 2.0 CHIMNEY ( FLUE SYSTEM) 2.1 DEFINITIONS For clarity , the following definitions should be used with respect to these instruction s: • A chimney system consists of a conn ector off th e top of th e stove, and a chimne y , which attaches to the connector and terminates outside the house.
11 I f you are using a masonry chimney , it is important that it be built i n com pliance wit h the s pecification s of th e Building Code. I t must be lined with fire clay bricks, or clay tiles, sealed together with fire cement, or h ave a listed solid fuel burning stainless st eel liner.
12 FIGURE 2.2 Minimum Height of the Chimney 2.2.1 Step by step in stallation of y our factory -bu ilt chimney The w ay to i nsta ll yo ur c himne y may vary from on e c himne y manufact ure r to anot her .
13 Ty pical in stal lat ion t hro ug h t he wall FIGURE 2.2.1 (A ) Typ ical installation th rough th e wall 1- Star t by posi tio nin g your stov e wh ere you woul d li ke it to go, tak ing into accou nt the minimum cle ara nces to combus tib le mate ri al.
14 2- Once the op enin g c omple ted, you need t o frame in th e area to al low for th e i nsta ll ati on of a wa ll thi mbl e. A w al l thim ble is not re qui re d for in stal la tio ns t hro ugh con cr ete wa lls . 3- You must first secur e the wal l thi mble into the exter io r wal l surfac e.
15 5- You can now inst all the wal l su ppor t. Simpl y sl ide the wal l sup por t up to the tee, ensur ing tha t the adapter on th e suppor t engag es w ith the female co upl er on the bottom of th e tee. W hen the w all suppo rt is lev el and pr oper ly posi tio ned, you can use lag bolts to secur e it i nt o t h e w al l stu ds.
16 8- Fi nall y , t wi st on y our r ain cap and y ou c an h ead b ack in sid e. 9- You are now ready to conne ct you r chimne y to y our stov e. Simpl y insta ll the inter -c onne cti ng sto ve pi pe betw ee n the stov e pip e adapt er a nd t he st ov e.
17 Ty pical in stal lat ion t hro ug h t he ceil ing FIGURE 2.2.1 (B) Typical Installat ion Through the Ceiling 1- Pla ce your s tov e wher e yo u woul d lik e it loc ated and use a pl umb li ne to mark the ceili ng dir ect ly abov e yo ur stov e flue.
18 2- Befor e y ou ins tal l t he c eil in g s uppo rt, y ou need to fr ame the area . 3- To instal l the ceil ing s uppo rt, j ust sl id e t he assembl y i nto the framed openi ng f rom bel ow .
19 6- Now , y ou can add additi onal chi mne y se c ti ons . Co n ti nue ad di ng ch i mn ey le ng ths u nt i l a h ei gh t of about 2 feet bel ow the nex t ceil in g lev el . An atti c ins ula tio n shiel d must be insta ll ed wh er e a chi mney pass es from a low er liv ing space into an upper liv ing space or attic spac e.
20 11- You are now read y to connec t your chimney to your stov e. Simp ly inst all the inte r- conn ecti ng sto ve pi pe betw ee n the stov e pip e adapt er a nd t he st ov e. Y o u c an fo l l ow the i ns t r uc t i on s in t he foll ow ing s ect ion (s ecti on 2.
21 FIGURE 2.2.2 (B) Factory Built Th imble.
22 FIGURE 2.2.2 (C ) Brick Thimble.
23 2.3 CHIMNEY CONNEC TOR Your chimney connector (commonly called stove pipe) and chimney must have the same diameter as the stove’s exhaust outl et. The stove pipe must be made of aluminiz ed or cold roll steel with a mini mum 24- gauge thickness (0.
24 FIGURE 2.3 (B ) Minimum Slope 2.4 DRAFT Your Sahara stov e’s performance will be optimi sed if it is ins talled with a chimney (flue) s y stem that provides an adequate draft.
25 • Opening a window slightly on a calm (windless) day alleviates any of th e above sy mptoms. • The house is equipped wit h a well-sea led vapour barrier and tight fitti ng wi ndows and/or has any powered devices that exhaust house air. • There is excessive condensation on windows in t he winter.
26 SECTION 3.0 OPERATION Keep these instructions for future refe rence. WA RNING: • ANY MODIFICATION OF THE AP PLIANCE THAT HA S NOT BEE N APPROVE D IN W RITING BY THE TESTING AUTHORITY IS CONSIDERED AS BREACHING CSA B365 ( CANADA ), AND A NSI NFPA 211 (USA).
27 • Even tho ugh your Drol et has been specifically designed and tested t o prevent smo ke spillage, alway s open t he doo r sl owly as thi s will minimis e the likeli hood of smoke spillage or a back draft of flame or smoke into the room.
28 fire. Never burn salt wood, beach wood, chemically treated wood, or wood removed from salt water, since the deposits left will deteriorate the firebox. Damage caused by chemicals or salt is not covered under warranty . Seasoned cord wood is recommended.
29 decorative fireplaces. Dec orative fireplaces gene rally have larger , cooler, and less air-tight fireboxes. Your Drolet stove, on the other hand, has a smaller, completely sea led firebox which attains mu ch higher temperatures. I t is therefore not designed to support excessive heat caused by the addition of chemicals in manufactured logs.
30 hour, y ou can close the air cont rol completely . In order to have the best ind ica ti on of whe n y ou shou ld close the air control completely to operate y our stove the most efficiently , use a chimney (flue) thermometer.
31 SECTION 4.0 MAINTENANCE 4.1 CLEANING AN D PAINTING Y OUR STOVE Clean t he sto ve frequently so that soot, ash, and creosote do not accumulate. Do n ot attempt to clean the stove when the unit is hot. Special care m ust be taken with gold plated surfaces in order to maintain the finish at its original brilliance.
32 4.4 ASH REMOVAL USIN G THE ASH DRAWER C AUTION : ASHES CAN START FIRES , EVE N AFTER SEVERAL DAYS OF INACTIVITY . N EVER DISPOS E OF ASHES IN A COMBUSTIBLE CONTAINER .
33 4.5 CHIMNEY (FLUE) C LEANING Regular chimney (flue) maint enance, as well as good burning practices, are requ ire d to pre ven t ch imn ey fire s. When wood (especially green wood) is burned without adequate heat or air supply , it produces tar and other organic vapours ( smoke ), which combine wit h expelled moi sture to form creosote.
34 DROLET LIM ITED L IFETIM E WARRANTY The warranty of the manu facturer extends only to the original co nsumer p urchaser and is not tr ansferabl e. This war ran ty cove rs bran d new p roducts only , wh ich have not been altered, m odified n or repaired sin ce s hipment fro m factor y.
An important point after buying a device Drolet DB03505 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Drolet DB03505 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Drolet DB03505 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Drolet DB03505 you will learn all the available features of the product, as well as information on its operation. The information that you get Drolet DB03505 will certainly help you make a decision on the purchase.
If you already are a holder of Drolet DB03505, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Drolet DB03505.
However, one of the most important roles played by the user manual is to help in solving problems with Drolet DB03505. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Drolet DB03505 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
