Instruction/ maintenance manual of the product 3000 Series Dometic
Go to page of 16
1 MAGNUM OPUS ® ALL-CHINA GRA VITY DISCHARGE TOILET OWNER’S MANUAL Dometic Corporation • Sanitation Systems 13128 S tate Rt 226, PO Box 38 Big Prairie, OH 4461 1 SeaLand Product Customer Service: 1-800-321-9886 (8:00 a.
2 TABLE OF CONTENTS T oilet Model Identification . . . . . . . . . . . . . . . . 2 Ordering Parts . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Information Before Operation . . . . . . 3 T oilet Controls . . . . . . . . . . . . . . . . .
3 IMPORT ANT INFORMA TION BEFORE OPERA TION 1. Fill freshwater tank and add deodorant to holding tank through toilet bowl. 2. Make sure all guests understand the operation of the toilet system and the flushing instruction label is easy for guests to read.
4 1. Adding More Water T o T oilet Bowl Pull up the handle until the desired water level is attained. T o prevent overflowing the toilet, a timer inside the control module limits the amount of water that can be added. 2. Flushing The T oilet Push the handle down for a moment, then release it.
5 AUTOMA TIC FLUSH OPERA TION TIMING CHART The Magnum Opus toilet should be cleaned regularly for maximum sanitation and operational efficiency . Y ou can clean it just as you would a household toilet. Do not use caustic chemicals, such as drain-opening types, as they will damage the seals.
6 WINTERIZING At the end of each traveling season, the Magnum Opus toilet system must be winterized for storage. The following procedure should be used: 1. Pump out waste holding tank. 2. Thoroughly flush toilet system with fresh water . 3. Drain freshwater tank.
7 FLUSH MECHANISM COMPONENTS Base Assembly Cable BASE ASSEMBL Y COMPONENTS (under china toilet) W ater V alve Flush Ball Closed Limit Switch Motor Drive Arm Rotor Arm Flush V alve Motor Flexible Water Supply Hose Open Limit Switch Mode Switch Water Level Switch Power Cable CONTROL MODULE Input for Flush Handle Cable Input for Base Assembly Cable 1.
8 TROUBLESHOOTING 1. T oilet emits odor (flush ball open). 2. Water will not stay in bowl. 3. W ater leaks onto floor . 4. T oilet will not flush and water will not enter bowl. 5. Flush ball will not open, but water enters toilet bowl. 6. Flush ball will not close.
9 TROUBLESHOOTING (cont’d) 9. Water leaking from Water V alve. 10. Water will not enter toilet bowl when the Flush Handle is raised to add water . 1 1. Water Level Switch has no effect on water level in low or high positions. 12. Water will not shut off – toilet overflows.
10 ELECTRICAL TROUBLESHOOTING A volt/ohmmeter (VOM) and the Magnum Opus Wiring schematic (page 12) may be required for this section. Caution: Portions of this section will require that power be applied to the toilet. Keep hands away from the flush ball, motor drive arm and rotor shaft to prevent personal injury during testing and troubleshooting.
11 Symptom: T oilet will not flush and water will not enter toilet bowl. • LED 13 (+5V) off : Check toilet fuse or circuit breaker . Check for loose or defective wiring between Control Module and DC power source. Check for reverse polarity . If all of above check OK, replace Control Module.
12 WIRING DIAGRAM ELECTRICAL TROUBLESHOOTING (cont’d) T OILET OPERA TION CORRECTIVE PROCEDURES (cont’d) Symptom: Water will not enter the bowl when the Flush Handle is raised to add water . • Place the Water Level Switch in "Low" position and flush toilet.
13 CUSTOMER SERVICE There is a strong, worldwide network to assist in servicing and maintaining your sanit ation system. For the Authorized Service Center near you, please call from 8:00 a.m. to 5:00 p.m. (ET) Monday through Friday . Y ou may also write us at Dometic Corp.
14 NOTES.
15 NOTES.
16 Dometic Corporation warrants, to the original purchaser only , that this Magnum Opus ® gravity discharge toilet, if used for personal, family or household-like purposes, is free from defects in material and workmanship for a period of three (3) years from the date of purchase.
An important point after buying a device Dometic 3000 Series (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dometic 3000 Series yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dometic 3000 Series - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dometic 3000 Series you will learn all the available features of the product, as well as information on its operation. The information that you get Dometic 3000 Series will certainly help you make a decision on the purchase.
If you already are a holder of Dometic 3000 Series, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dometic 3000 Series.
However, one of the most important roles played by the user manual is to help in solving problems with Dometic 3000 Series. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dometic 3000 Series along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
