Instruction/ maintenance manual of the product VCX1525-WH Dimplex
Go to page of 20
Owner ’ s Manual Model VCX1525 VCX1525-WH T o view the full line of Dimplex products, please visit www .dimplex.com 7209350100R03 IMPORT ANT SAFETY INFORMA TION: Always read this manual rst before attempting to install or use this replace.
2 www .dimplex.com T able of Contents Always use a qualied technician or service agency to repair this replace. ! NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment.
3 W elcome & Congratulations Thank you and congratulations for choosing to purchase an electric replace from Dimplex, the world leader in electric replaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation.
4 www .dimplex.com When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: ① Read all instructions before using the Convex In-Stud replace.
5 SA VE THESE INSTRUCTIONS IMPORT ANT INSTRUCTIONS ⑬ Do not modify the replace. Use it only as described in this manual. Any other use not re com men ded by th e m an uf ac tur er may cause re, electric shock or injury to persons. ⑭ This unit may have a polarized plug (one blade is wider than the other).
6 www .dimplex.com IMPORT ANT INSTRUCTIONS W ARNING: Remote control contains small batteries. Keep away from children. If swallowed, seek medical attention immediately . W ARNING: Do not install battery backwards, charge, put in re or mix with used or other battery types - may explode or leak causing injury .
7 Fireplace Installation ! NOTE: A 15 Amp, 120 V olt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a regular basis when the heater is operating.
8 www .dimplex.com W ARNING: The Convex In Stud replace is wall mountable and can be built in a wall space 16 inches (406 mm) over-center between 2” x 4” wall studs. Follow the installation instructions for either wall mount or built-in mounting; failure to do so may cause damage or injury .
9 Fireplace Installation obstruct the bottom of this heater . Bottom of unit must be a minimum of 14 inches (356 mm) above the oor or any surface such as a tabletop to ensure adequate space for heat exhaust from the bottom of the replace (Figure 3).
10 www .dimplex.com ⑦ With the glass assembly taken off, mount the rebox onto the two (2) mounting screws. ⑧ Mark position of hole “H”. ⑨ Remove replace from wall. ⑩ Install drywall anchor into drywall at marked position. ⑪ With the glass assembly of f, mount the replace onto the two (2) mounted screws.
11 Fireplace Installation installation should be entrusted to duly qualied personnel where required by law . ① Leave the frame uninstalled from the replace chassis until step 13. ② Prepare a wall opening following the dimensions shown in Figure 5.
12 www .dimplex.com ④ Remove the outer jacket and strip the individual conductor from the end. ⑤ Loosen the screw securing the junction box cover and remove the cover . ⑥ T ake the cables out from the junction box, loosen the two (2) wire nuts and remove the cord set (Figure 6).
13 Fireplace Installation fasteners. Attach supplied wall cover brackets to the top and the bottom of replace to cover the gap on the dry wall (Figure 8). ⑬ Attach replace frame as shown in Figure 4 . Bathroom Installation This rebox must be protected by a GFI receptacle or circuit for bathroom use.
14 www .dimplex.com Operation Figure 9 T op Light Dimmer Thermostat Heater On/Off Switch Main On/Off Switch A. Main On/Off Switch The switch has two ON positions marked with and “ ON ”. The “ ON ” position is for manual operation. In this position the built-in remote control is by- passed.
15 Operation Resetting The T emperature Cutoff Switch Should the heater overheat, an automatic cut out will turn the replace off and it will not come back on without being reset. It can be reset by switching the Main On/Off Switch to OFF and waiting ve (5) minutes before switching the unit back on.
16 www .dimplex.com Figure 1 1 Lift to remove Glass assembly Bulb Replacement Instructions: ① Disconnect power supply to the replace either by unplugging the replace or switch off at the breaker panel. ② Remove glass assembly . Remove the screws securing the glass assembly on the chassis (Figure 4).
17 Maintenance Figure 12 Light Block ⑥ Replace with new bulbs. ⑦ Reassemble light block and glass assembly in reverse order . Glass Cleaning The front glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc.
18 www .dimplex.com W arranty Products to which this limited warranty applies This limited warranty applies to newly purchased Dimplex replaces and surrounds (mantels) and trims.
19 W arranty Dimplex will in its sole discretion • either repair or replace such defective product or part without charge. If Dimplex is unable to repair or replace such product or part, or if repai.
20 www .dimplex.com © 201 1 Dimplex North America Limited Dimplex North America Limited 1367 Industrial Road Cambridge ON Canada N1R 7G8 Replacement Parts Front Glass - VCX1525 . . . . . . . . . . . . . . . . . . . . . . 5901 170100RP VCX1525-WH . . .
An important point after buying a device Dimplex VCX1525-WH (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dimplex VCX1525-WH yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dimplex VCX1525-WH - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dimplex VCX1525-WH you will learn all the available features of the product, as well as information on its operation. The information that you get Dimplex VCX1525-WH will certainly help you make a decision on the purchase.
If you already are a holder of Dimplex VCX1525-WH, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dimplex VCX1525-WH.
However, one of the most important roles played by the user manual is to help in solving problems with Dimplex VCX1525-WH. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dimplex VCX1525-WH along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
